Refer to the exhibit. On the basis of the output, what two conclusions can be reached?() A. The default administrative distance has been changed.B. IS - IS is not enabled.C. Three physical interfaces are taking part in integrated IS - IS.D. IS - IS is not redistributing any oth er routing protocols.E. There are two neighboring routers sending IS - IS routing information.F. Address summarization is configured.
Refer to the exhibit. On the basis of the output, what two conclusions can be reached?()
A. The default administrative distance has been changed.
B. IS - IS is not enabled.
C. Three physical interfaces are taking part in integrated IS - IS.
D. IS - IS is not redistributing any oth er routing protocols.
E. There are two neighboring routers sending IS - IS routing information.
F. Address summarization is configured.
相关考题：
In case no settlement can be reached between the two parties, the case under dispute shall be submitted for arbitration.(英译中)
Refer to the exhibit. Based on this command output, what can we conclude about R3?() A. R3 is an ABR.B. R3 is not connec ted to the backbone.C. R3 has four neighbors.D. R3 is the DR for area 2.
Refer to the exhibit. You have completed an OSPF implementation, and you are verifying OSPF operation. You notice that router A and router B are stuck in the two - way state. From the show ip ospf interface command output, what is the cause of this issue?（）A. All OSPF implementations must have at le ast one interface in area 0.B. You are attempting to run in the broadcast mode over an NBMA interface.C. Both routers are configured to function as a BDR; therefore, there is no DR router.D. Someone has changed the OSPF router ID; therefore you must clear the OSPF process.E. The OSPF priority is set to 0 on both routers; therefore neither can become the DR.
Refer to the exhibit. A Boston company bought the asse ts of a New York company and is trying to route traffic between the two data networks using EIGRP over EoMPLS. As a network consultant, you were asked to verify the interoperability of the two networks. From the show ip route command output, what can yo u tell the customer about the traffic flow between the subnet in New York (172.16.8.0/24) and the subnets in Boston (172.16.16.0/24 and 10.10.16.0/24)?（）A. Traffic is flowing between the 172.16.8.0 subnet and subnets 172.16.16.0 and 10.10.16.0 and no configuration changes are needed.B. Auto - summary must be disabled on N1 and B1 before traffic can flow between the 172.16.8.0 subnet and subnets 172.16.16.0 and 10.10.16.0.C. Traffic will flow between the 172.16.8.0 subnet and 172.16.16.0 without any further configuration changes. However, auto - summary must be disabled on N1 and B1 before traffic can flow between the 172.16.8.0 subnet and the 10.10.16.0 subnet.D. Auto - summary must be disabled on N1 and B1 before traffic can flow between the 172.16 .8.0 subnet and the 172.16.16.0 subnet. However, traffic will flow between the 172.16.8.0 subnet and 10.10.16.0 without any further configuration changes.
Refer to the exhibit. Which two conclusions can be drawn from the debug ip igmp output?() A. The router sent an IGMP version 2 query out interface Ethernet1 at multicast address 224.0.0.1.B. Router RTA received an IGMP report version 1 from host 192.168.9.1.C. Reverse Path Forwarding (RPF) is ena bled for 192.168.9.4.D. Reverse Path Forwarding (RPF) is enabled for 224.0.1.40.E. The IP multicast groups are 224.0.0.1, 224.0.1.40, and 239.255.0.1.F. IP PIM RP mapping is static.
Refer to the exhibit. What two statements are true?() A. This is the designated router (DR) on the FastEthernet 0/0 link.B. The output was generated by the show ip interface c ommand.C. The router was configured with the commands:r outer ospf 1 network 172.16.6.0 0.0.0.255 area 1D. The IP address of the backup designated router (BDR) is FE80::205:5FFF:FED3:5808.E. Interface FastEthernet 0/0 was configured with the ipv6 o spf 1 area 1 command.F. OSPF version 2 has been enabled to support IPv6.
Refer to the output. What IOS command produces this output?() A. show i p ospfB. show ip ospf interfaceC. show ipv6 ospf interfaceD. show ipv6 ospf
Refer to the exhibit. EIGRP is configured on all routers in the network. On a basis of the show ip eigrp topology output provided, what conclusion can be deri ved? () A.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out inquiring for a second successor to network 10.6.1.0/24B.Router R1 can send traffic destined for network 10.6.1.0/24 out of interface FastEthernet0/0C.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out before it declares the neighbor unreachableD.Router R1 is waiting for a reply from the neighbor 10.1.2.1 in response to the query sent out about network 10 .6.1.0/24
Refer to the exhibit. What is the most appropriate summarization for these routes?() A.10.0.0.0/21B.10.0.0.0/22C.10.0.0.0/23D.10.0.0.0/24
Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?() A.data link layerB.application layerC.access layerD.session layerE.network layer
Refer to the exhibit. Give this output for SwitchC, what should the network administrator‘s next action be?() A.Check the trunk encapsulation mode for SwitchC‘s fa0/1 port.B.Check the duplex mode for SwitchC‘s fa0/1 port.C.Check the duplex mode for SwitchA‘s fa0/2 port.D.Check the trunk encapsulation mode for SwitchA‘s fa0/2 port.
Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?（）A.The design will function as intendedB.Spanning-tree will need to be used.C.The router will not accept the addressing scheme.D.The connection between switches should be a trunk.E.The router interfaces must be encapsulated with the 802.1Q protocol.
Refer to the exhibit. The two exhibit devices are the only Cisco devices on the network. The serial network between the two devices has a mask of 255.255.255.252. Given the output that is shown, what three statements are true of these devices? （）A.The Manchester serial address is 10.1.1.1B.The Manchester serial address is 10.1.1.2C.这个Manchester路由器串口地址为：10.1.12D.The London router is a Cisco 2610.E.The Manchester router is a Cisco 2610.F.The CDP information was received on port Serial0/0 of the Manchester router.G.The CDP information was sent by port Serial0/0 of the London Router.
Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?() A.Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500.B.Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes.C.Theminimumpacketsizethatcantraversethisinterfaceis1500bytes.D.Themaximumpacketsizethatcantraversethisinterfaceis1500bytes.E.Themaximumframesizethatcantraversethisinterfaceis1500bytes.
Refer to the exhibit. What does the (*) represent in the output?() A.Packet is destined for a local interface to the router.B.Packet was translated, but no response was received from the distant device.C.Packet was not translated, because no additional ports are available.D.Packet was translated and fast switched to the destination.
Refer to the exhibit. The user at Workstation B reports that Server A cannot be reacheD.What ispreventing Workstation B from reaching Server A?() A.The IP address for Server A is a broadcast address.B.The IP address for Workstation B is a subnet address.C.The gateway for Workstation B is not on the same subnet.D.The gateway for Server A is not on the same subnet.
Refer to the exhibit. What can be determined about the router from the console output?() A.No configuration file was found in NVRAM.B.No configuration file was found in flash.C.No configuration file was found in the PCMCIA card.D.Configuration file is normal and will load in 15 seconds.
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）A、As numbers must be changed to match on all the routers.B、Loopback interface must be configured so a DR is elected.C、The no auto-summary command is needed on Router A and Router C.D、Router B needs to have two network statements, one for each connected network.
Refer to the output shown on switch SW1 below： Warning： Spantree port fast start should only be enabled on ports connected to a single host.Connecting hubs， concentrators， switches， bridges， etc. to a fast start port can cause temporaryspanning tree loops. Use with caution. Spantree ports 4/1-24 fast start enabled. What command could you enter to reproduce this output？
Refer to the exhibit. What are three of the basic components of a VoIP network？（）A、software voice applicationsB、multipoint control unit （MCU） C、gatekeeper D、call agentE、interactive voice response （IVR） systems F、softphones
单选题Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?（）A Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500.B Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes.C Theminimumpacketsizethatcantraversethisinterfaceis1500bytes.D Themaximumpacketsizethatcantraversethisinterfaceis1500bytes.E Themaximumframesizethatcantraversethisinterfaceis1500bytes.
单选题Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?（）A 10.1.1.2B 10.154.154.1C 172.16.5.1D 192.168.5.3
单选题Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）A data link layerB application layerC access layerD session layerE network layer
单选题Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?（）A The design will function as intendedB Spanning-tree will need to be used.C The router will not accept the addressing scheme.D The connection between switches should be a trunk.E The router interfaces must be encapsulated with the 802.1Q protocol.
单选题Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）AAs numbers must be changed to match on all the routers.BLoopback interface must be configured so a DR is elected.CThe no auto-summary command is needed on Router A and Router C.DRouter B needs to have two network statements, one for each connected network.
多选题Refer to the exhibit. On the basis of the information in the exhibit， which two statements are true？（）AWhen traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose2 because of the higher MED value of SanJose2BThe serial 0/0/1 interface on the ISP router has been configured with the set metric 50commandCThe output was generated by entering the show ip bgp command on the SanJose1 routerDThe output was generated by entering the show ip bgp command on the ISP routerEThe serial 0/0/1 interface on the ISP router has been configured with the set metric 75commandFWhen traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose1 because of the lower MED value of SanJose1
多选题Refer to the exhibit. What are three of the basic components of a VoIP network？（）Asoftware voice applicationsBmultipoint control unit （MCU）CgatekeeperDcall agentEinteractive voice response （IVR） systemsFsoftphones