The network administrator of the Oregon router adds the following command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command (Choose two.)（）。A.The command establishes a static route.B.The command invokes a dynamic routing protocol for 192.168.12.0.C.Traffic for network 192.168.12.0 is forwarded to 172.16.12.1.D.Traffic for all networks is forwarded to 172.16.12.1.E.This route is automatically propagated throughout the entire network.F.Trafficfor network 172.16.12.0 is forwarded to the 192.168.12.0 network.
The network administrator of the Oregon router adds the following command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command (Choose two.)（）。
A.The command establishes a static route.
B.The command invokes a dynamic routing protocol for 192.168.12.0.
C.Traffic for network 192.168.12.0 is forwarded to 172.16.12.1.
D.Traffic for all networks is forwarded to 172.16.12.1.
E.This route is automatically propagated throughout the entire network.
F.Trafficfor network 172.16.12.0 is forwarded to the 192.168.12.0 network.
相关考题：
You are a senior network administrator at Ezonexam, and while performing the password recovery procedure on your 2500 series Cisco router, you type in the following command:o/r 0x2142What is the purpose of this command?A．It is used to restart the router.B．It is used to bypass the configuration in NVRAM.C．It is used to enter ROM Monitor mode.D．It is used to view the lost password.E．It is used to save the changes to the configuration.
Which of the following should an administrator do after running a command from the console onthe perimeter router?() A. Update the configuration logsB. Update the network wiring schematicsC. Update the network configuration proceduresD. Compare the configuration with the baseline
After implementing EIGRP on your network, you issue the show ip eigrp traffic command on router C. The following output is shown:What information can you determine about this network?() A. The network is stableB. There is a flapping link or interface, and router C knows an alternate path to the networkC. There is a flapping link or interf ace, and router C does not know an alternate path to the networkD. EIGRP is not working correctly on router CE. There is not enough information to make a determination
After implementing EIGRP on your network, you issue the show ip eigrp traffic command on router C. The following output is shown:What can you conclude about this network? () A. The network has been stable for at least the last 45 minutesB. There is a flapping link or interf ace, and router C knows an alternate path to the networkC. There is a flapping link or interface, and router A does not know an alternate path to the networkD. EIGRP is not working correctly on router CE. There is not enough information to make a determination
The following configuration command was entered into a router:ip route 172.16.3.0 255.255.255.0 192.168.2.4 Which of the following statements are true regarding this configuration change?() A. The default administrative distance is used.B. The command is used to establish a static route.C. The command is used to configure the router interfaces.D. The command is used to establish a stub network.E. The subnet mask for the source address is 255.255.255.0
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）A. Issue the show ip route command on Router AB. Issue the show ip route command on Router BC. Issue the show cdp neighbors command on Router BD. Issue the show cdp neighbors detail command on Router CE. Issue the show arp command on Router AF. Issue the show arp command on Router B
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?（）A. Router# show ip eigrp adjacencyB. Router# show ip eigrp topologyC. Router# show ip eigrp interfacesD. Router# show ip eigrp neighbors
The network administrator of the Oregon router adds the follwing command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command?() A. The command establishes a static routeB. The command invokes a dynamic routing protocol for 192.168.12.0C. Traffic for network 192.168.12.0 is forwarded to 172.16.12.1D. Traffic for all networks is forwarded to 172.16.12.1E. This route is automatically propagated throughout the entire networkF. Traffic for network 172.16.12.0 is forwarded to the 192.168.12.0 network
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? () A.informationalB.emergencyC.warningD.criticalE.debugF.error
As a network administrator, you have been instructed to prevent all traffic originating on the LAN from entering the R2 router. Which the following command would implement the access list on the interface of the R2 router?（）A.access-list 101 inB.access-list 101 outC.ip access-group 101 inD.ip access-group 101 out
As a network administrator，you have been instructed to prevent all traffic or iginating on the LAN from entering the R2 router.Which the following command would implement the access list on the interface of theR2 router？（）A.access-list 101 inB.access-list 101 outC.ipaccess-group 101 inD.ipaccess-group 101 out
A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router.How should the network administrator configure the serial interface of the main office router to make the connection?（）A.B.C.D.
The network administrator of the Oregon router adds the follwing command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command?（）A、The command establishes a static routeB、The command invokes a dynamic routing protocol for 192.168.12.0C、Traffic for network 192.168.12.0 is forwarded to 172.16.12.1D、Traffic for all networks is forwarded to 172.16.12.1E、This route is automatically propagated throughout the entire networkF、Traffic for network 172.16.12.0 is forwarded to the 192.168.12.0 network
A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? （）A、informationalB、emergencyC、warningD、criticalE、debugF、error
A network administrator needs to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface for this connection?（）A、Router(config-if)# encapsulation frame-relay q933aB、Router(config-if)# encapsulation frame-relay ansiC、Router(config-if)# encapsulation frame-relay ietfD、Router(config-if)# encapsulation frame-relay islE、None of the above
A network administrator has configured access list 172 to prevent Telnet and ICMP traffic from reaching a server with the address if 192.168.13.26. Which command can the administrator issue to verify that the access list is working properly?（）A、Router# ping 192.168.13.26B、Router# debug access-list 172C、Router# show open ports 192.168.13.26D、Router# show access-listE、Router# show ip interface
An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）A、Issue the show ip route command on Router AB、Issue the show ip route command on Router BC、Issue the show cdp neighbors command on Router BD、Issue the show cdp neighbors detail command on Router CE、Issue the show arp command on Router AF、Issue the show arp command on Router B
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?（）A、Router# show ip eigrp adjacencyB、Router# show ip eigrp topologyC、Router# show ip eigrp interfacesD、Router# show ip eigrp neighbors
Which of the following OSPF commands, when used together, will put the network 192.168.10.0/24 into OSPF area 0?（）A、Router(config-router)# network 192.168.10.0 0.0.0.255 0B、Router(config-router)# network 192.168.10.0 0.0.0.255 area 0C、Router(config-router)# network 192.168.10.0 255.255.255.0 area 0D、Router(config)# router ospf 0E、Router(config)# router ospf 1
As a network administrator, you have been instructed to prevent all traffic originating on the LAN from entering the R2 router. Which the following command would implement the access list on the interface of the R2 router?（）A、access-list 101 inB、access-list 101 outC、ip access-group 101 inD、ip access-group 101 out
The following configuration command was entered into a router:ip route 172.16.3.0 255.255.255.0 192.168.2.4 Which of the following statements are true regarding this configuration change?（）A、The default administrative distance is used.B、The command is used to establish a static route.C、The command is used to configure the router interfaces.D、The command is used to establish a stub network.E、The subnet mask for the source address is 255.255.255.0
Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0". Whic h of the following is most likely to have caused this output to occur on R1?（）A、R1 has been configured with an ip default- network 2.0.0.0 command.B、R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.C、R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.D、Another router has been configured with an ip default - network 2.0.0.0 command.E、Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
多选题The network administrator of the Oregon router adds the following command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command (Choose two.)（）。AThe command establishes a static route.BThe command invokes a dynamic routing protocol for 192.168.12.0.CTraffic for network 192.168.12.0 is forwarded to 172.16.12.1.DTraffic for all networks is forwarded to 172.16.12.1.EThis route is automatically propagated throughout the entire network.FTrafficfor network 172.16.12.0 is forwarded to the 192.168.12.0 network.
单选题An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?（）AIssue the show ip route command on Router ABIssue the show ip route command on Router BCIssue the show cdp neighbors command on Router BDIssue the show cdp neighbors detail command on Router CEIssue the show arp command on Router AFIssue the show arp command on Router B
多选题The following configuration command was entered into a router:ip route 172.16.3.0 255.255.255.0 192.168.2.4 Which of the following statements are true regarding this configuration change?（）AThe default administrative distance is used.BThe command is used to establish a static route.CThe command is used to configure the router interfaces.DThe command is used to establish a stub network.EThe subnet mask for the source address is 255.255.255.0
单选题Which of the following should an administrator do after running a command from the console onthe perimeter router?（）AUpdate the configuration logsBUpdate the network wiring schematicsCUpdate the network configuration proceduresDCompare the configuration with the baseline
多选题A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? （）AinformationalBemergencyCwarningDcriticalEdebugFerror
单选题Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?（）A The network administrator faled to save the configuration.B The configuration register is set to 0x2100.C The boot system flash command is missing from the configuration.D The configuraiton register is set to 0x2102.E The router is configured with the boot system startup command.