单选题Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?（）A The network administrator faled to save the configuration.B The configuration register is set to 0x2100.C The boot system flash command is missing from the configuration.D The configuraiton register is set to 0x2102.E The router is configured with the boot system startup command.
单选题
Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?（）
A
The network administrator faled to save the configuration.
B
The configuration register is set to 0x2100.
C
The boot system flash command is missing from the configuration.
D
The configuraiton register is set to 0x2102.
E
The router is configured with the boot system startup command.
参考解析
解析：
暂无解析
相关考题：
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B
Refer to the exhibit. R1 and R2 have been configured to share routing information via EIGRP. What will be the result of the configuration section shown for R2? () A. Any routes learned by R2 from the interface tied to the 172.16.0.0 network will not be advertised to neighbors on the 192.168.2.0 network.B. Only routes learned by R2 from the interface tied to the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.C. Only the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network.D. All networks, except the 172.16.0.0 network will be advertised to neighbors on the 192.168.2.0 network .
Refer to the exhibit. BigBids Incorporated is a worldwide auction provider. The network uses EIGRP as its routing protocol throughout the corporation. The network administrator does not understand the convergence of EIGRP. Using the output of the show ip eigrp topology all - links command, answer the administrator‘s questions.Which three networks is the router at 172.17.10.2 directly connected to?（）A. 172.17.0.0/30B. 172.17.1.0/24C. 172.17.2.0/24D. 172.17.3 .0/25E. 172.17.3.128/25F. 172.17.10.0/24
Refer to the exhibit. A network administrator has configured DHCP services on the router asshown. DHCP clients connected to the FastEthernet0/0 interface are working properly. DHCP clients connected to the FastEthernet0/1 interface are not receiving addresses.Which two statements contain recommendations that will solve the problem?（）A.The network shown in the output under the ip dhcp pool Central command should be changed to network 10.10.0.0 with a mask of 255.255.255.0B.A second DHCP pool for network 10 .10.0.0/24 should be configuredC.An ip dhcp excluded - address global configuration command for network 10.10.0.0/24 should be issuedD.The ip helper -address 10.0.0.1 command should be issued so that the address can be added to the Fast Ethernet0/0 c onfigurationE.The ip helper -address 10.0.0.1 command should be issued so that the address can be added to the Fast Ethernet0/1 configuration
Refer to the exhibit. A network administrator wants to reduce the number of OSPF routes advertised from Area 1 into Area 2. As the router configuration specialist, what two things would you do to accomplish this goal?（）A. Enter the configuration on router B1.B. Enter the configuration on router B4.C. On the same router, enter the Summary - address 10.10.1.0 255.255.255.128 subcommand.D. On the same router, enter the Area 1 range 10.10.1.0 255.255.255.128 subcommand.E. On the same ro uter, enter the Area 2 range 10.10.1.0 255.255.255.128 subcommand.
Refer to the above exhibit. Why is the 140.140.0.0 network not used as the gateway of last resort even though it is configured first?() A.The last default - network statement will always be preferred.B.A route to the 140.140.0.0 network does not exist in the routing table.C.Default - network selection will always prefer the statement with the lowest IP address.D.A router will load balance across multiple default - networks; repeatedly issuing the show ip route command would show the gateway of last resort changing between the two networks.
Refer to the exhibit. ROUTE.com has just implemented this EIGRP network. A network administrator came to you for advice while trying to implement load balancing across part of their EIGRP network. If the variance value is configured as 2 on all routers and all o ther metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths? （）A. 1B. 2C. 3D. 4E. 5
Refer to the exhibit. Routing updates for the 192.168.1.0 network are being received from all three neighbors. Which statement is correct regarding the result of the con figuration shown? () A. The router will prefer the next hop of 172.16.1.1 for packets destined for the 192.168.1.0 network.B. The router will prefer the next hop of 172.26.1.1 for packets destined for the 192.168.1.0 network.C. The router will adve rtise the 192.168.1.0 network only to 172.30.1.1.D. The router will advertise the 192.168.1.0 network only to 172.26.1.1.E. The router will prefer the next hop of 172.26.1.1 for packets except those destined for the 192.168.1.0 network.
Refer to the exhibit. By default, when RTB passes BGP advertisements from RTA about network 192.168.2.0 to RTC, what address will be listed as the next － hop address? () A. 10.1.1.2B. 192.168.1.49C. 10.1.1.1D. 192.168.1.50
Refer to the exhibit. Which two statement s are correct?() A. All the routes were redistributed into BGP from an IGPB. All the routes were originated by BGP with the network commandC. All six routes will be installed in the routing tableD. Four routes will be installed in the routing ta bleE. Two routes will be installed in the routing table
Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?() A.255.255.255.0B.255.255.254.0C.255.255.252.0D.255.255.248.0
Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?() A.data link layerB.application layerC.access layerD.session layerE.network layer
Refer to the exhibit. Give this output for SwitchC, what should the network administrator‘s next action be?() A.Check the trunk encapsulation mode for SwitchC‘s fa0/1 port.B.Check the duplex mode for SwitchC‘s fa0/1 port.C.Check the duplex mode for SwitchA‘s fa0/2 port.D.Check the trunk encapsulation mode for SwitchA‘s fa0/2 port.
Refer to the exhibit. Which three statements correctly describe Network Device A?() A.With a network wide mask of 255.255.255.128, each interface does not require an IP address.B.With a network wide mask of 255.255.255.128, each interface does require an IP address on a unique IP subnet.C.With a network wide mask of 255.255.255.0, must be a Layer 2 device for the PCs to communicate with each other.D.With a network wide mask of 255.255.255.0, must be a Layer 3 device for the PCs to communicate with each other.E.With a network wide mask of 255.255.254.0, each interface does not require an IP address.
Refer to the exhibit,a network administrator cannot establish a telnet session with the indicated router.What is the cause of this failure?（）A、A level 5 password is not setB、The vty password is missingC、The console password is missingD、An ACL is blocking Telnet access
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）A、As numbers must be changed to match on all the routers.B、Loopback interface must be configured so a DR is elected.C、The no auto-summary command is needed on Router A and Router C.D、Router B needs to have two network statements, one for each connected network.
Refer to the exhibit. What are three of the basic components of a VoIP network？（）A、software voice applicationsB、multipoint control unit （MCU） C、gatekeeper D、call agentE、interactive voice response （IVR） systems F、softphones
Before inserting a new switch in the network，the network administrator checks that the VTP domain name is correct，the VTP mode is set to server， and revision is lower than the switches in the network. The administrator then configures interfaces and trunks，erases existing VLANs，and connects the switch to the network. Following that procedure，there is no connectivity in the network. What is a possible cause of this problem？（）A、Because the configuration revision of the new switches is lower than the rest of the network， it can change the VLAN database of the other switches.B、As a VTP server， the new switch deleted all VLANs of the network.C、Erasing VLANs increases the VTP configuration revision.D、Since the configuration revision of the network is higher than the new switch， the VLAN database was automatically synchronized.
Refer to the exhibit.What is the effect of the configuration that is shown?（）A、It tells the router or switch to try establish an SSH connection first and if that fail to use telnet.B、It configures a cisco network device to use the SSH protocol on incoming communications via the virtual terminal ports.C、It allows seven failed login attempts before the VTY lines are temporarily shutdown.D、It configures the virtual terminal lines with the password 030752180500.E、It configures SSH globally for all logins.
单选题Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）A data link layerB application layerC access layerD session layerE network layer
单选题Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）AAs numbers must be changed to match on all the routers.BLoopback interface must be configured so a DR is elected.CThe no auto-summary command is needed on Router A and Router C.DRouter B needs to have two network statements, one for each connected network.
多选题Refer to the exhibit. Which two statements are correct？（）AAll six routes will be installed in the routing tableBTwo routes will be installed in the routing tableCFour routes will be installed in the routing tableDAll the routes were redistributed into BGP from an IGPEAll the routes were originated by BGP with the network command
单选题Refer to the exhibit. Which statement is true about a voice VLAN？（）A Physically the voice network and the data network are separate.B The voice traffic will normally be on a different IP subnet than will the data traffic.C End user intervention is necessary to place the phone into the proper VLAN.D The same security policy should be implemented for both voice and data traffic.E The data VLAN must be configured as the native VLAN.
单选题Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?（）A Switch1B Switch2C Switch3D Switch4
单选题Refer to the exhibit.What is the effect of the configuration that is shown?（）AIt tells the router or switch to try establish an SSH connection first and if that fail to use telnet.BIt configures a cisco network device to use the SSH protocol on incoming communications via the virtual terminal ports.CIt allows seven failed login attempts before the VTY lines are temporarily shutdown.DIt configures the virtual terminal lines with the password 030752180500.EIt configures SSH globally for all logins.
单选题Refer to the exhibit. Which statement is true about a voice VLAN？（）A Physically the voice network and the data network are separateB The voice traffic will normally be on a different IP subnet than will the data trafficC End user intervention is necessary to place the phone into the proper VLAND The same security policy should be implemented for both voice and data trafficE The data VLAN must be configured as the native VLAN
多选题Refer to the exhibit. What are three of the basic components of a VoIP network？（）Asoftware voice applicationsBmultipoint control unit （MCU）CgatekeeperDcall agentEinteractive voice response （IVR） systemsFsoftphones