Refer to the exhibit A frame on vlan 1on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）A、trunk mode mismatchesB、vlans that do not correspond to a unique IP subnetC、native vlan mismatchesD、allowing only vlan 2 on the destination.
Refer to the exhibit A frame on vlan 1on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）
- A、trunk mode mismatches
- B、vlans that do not correspond to a unique IP subnet
- C、native vlan mismatches
- D、allowing only vlan 2 on the destination.
相关考题：
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B
Refer to the exhibit. What must be done on router RTA to ensure that EIGRP works effectively in a Frame Relay multipoint environment?() A. Issue the command bandwidth 224 on the physical interface.B. Issue the command bandwidth 56 on the physical interface.C. Issue the command bandwidth 224 on each subinterface.D. Issue the command bandwidth 56 on each subinterface.
Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0／16?() A. show ip routeB. show policy - mapC. show access - listsD. show route - map
Refer to the exhibit. You are the network administrator of the Route.com company. You have been tasked to implement a hub and spoke EIGRP topology over Frame Relay to provide connectivity between the networks at headquarters and all 300 spokes. Before you begin the actual implementation, which three pieces of information are more important to know than the others?（）A. the Committed Information Rate of all the Frame Relay PVCsB. the Cisco IOS version running on all the routersC. the router model number of all the spoke routersD. the number of HQ networks connected behind the headquarter routersE. the routing policy, such as whether or not the spokes can be used as backup transient point between the two headquarter routers
Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?() A. the serial 1/1 addressB. the serial 2/0 addressC. a randomly generated internal addressD. the configured router - id address
Refer to the exhibit.How many broadcast domains exist in theexhibited topology?() A.oneB.twoC.threeD.fourE.fiveF.six
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame－relay map command shown?() A.The Seria l0/0interface is passing traffic.B.The DLCI 100 was dynamic allyallocated by the routerC.The Seria l0/0 interf aceacquired the IP address of 172.16.3.1 from a DHCP serverD.The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloudE.The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
Refer to the exhibit. What is the most appropriate summarization for these routes?() A.10.0.0.0/21B.10.0.0.0/22C.10.0.0.0/23D.10.0.0.0/24
Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?() A.255.255.255.0B.255.255.254.0C.255.255.252.0D.255.255.248.0
Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?（）A.The design will function as intendedB.Spanning-tree will need to be used.C.The router will not accept the addressing scheme.D.The connection between switches should be a trunk.E.The router interfaces must be encapsulated with the 802.1Q protocol.
Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?() A.trunk mode mismatchesB.vlans that do not correspond to a unique IP subnetC.native vlan mismatchesD.allowing only vlan 2 on the destination.
Refer to the exhibit, Host A pings interface S0／0 on router 3, what is the TTL value for that ping?() A. 253B. 252C. 255D. 254
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?() A.10.0.0.0B.10.0.0.254C.192.223.129.0D.192.223.129.254
Refer to the exhibit. A router has a 256 kbps Frame Relay circuit connected to interface serial 0/0. As a large FTP packet is being placed into the hardware transmit queue of interface serial 0/0， a voice packet is placed into the priority queue of that interface. How， and in what order， wi the packets be transmitted？（）A、the voice packet will be transmitted first， followed by the FTP packet in its entiretyB、the voice packet will be transmitted first， followed by the fragmented FTP packetC、the FTP packet will be fragmented and the voice packet will be interleavedD、the FTP packet will be transmitted first in its entirety， follow by the voice packet
Refer to the exhibit. What are three of the basic components of a VoIP network？（）A、software voice applicationsB、multipoint control unit （MCU） C、gatekeeper D、call agentE、interactive voice response （IVR） systems F、softphones
Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）A、The Serial0/0 interface is passing traffic.B、The DLCI 100 was dynamically allocated by the routerC、The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP serverD、The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloudE、The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
Refer to the exhibit. What is the configuration an example of？（）A、enabling modular QoS over Frame RelayB、enabling Real-Time Transport Protocol （RTP） header compressionC、enabling distributed compressed Transmission Control ProtocolD、enabling latency and jitter reduction for Transmission Control trafficE、enabling TCP header compression
单选题Refer to the exhibit.which address and mask combination a summary of the routes learned by EIGRP?（）A 192.168.25.0255.255.255.240B 192.168.25.16255.255.255.252C 192.168.25.0255.255.255.252D 192.168.25.28255.255.255.240E 192.168.25.16255.255.255.240
单选题Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?（）A 10.1.1.2B 10.154.154.1C 172.16.5.1D 192.168.5.3
单选题Refer to the exhibit A frame on vlan 1 on switch s1 is sent to switch s2 when the frame is received on vlan 2,what causes this behavior?（）A trunk mode mismatchesB vlans that do not correspond to a unique IP subnetC native vlan mismatchesD allowing only vlan 2 on the destination.
单选题Refer to the exhibit. What is the configuration an example of？（）Aenabling modular QoS over Frame RelayBenabling Real-Time Transport Protocol （RTP） header compressionCenabling distributed compressed Transmission Control ProtocolDenabling latency and jitter reduction for Transmission Control trafficEenabling TCP header compression
多选题Refer to the exhibit. Which two statements are correct？（）AAll six routes will be installed in the routing tableBTwo routes will be installed in the routing tableCFour routes will be installed in the routing tableDAll the routes were redistributed into BGP from an IGPEAll the routes were originated by BGP with the network command
单选题Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?（）A Switch1B Switch2C Switch3D Switch4
单选题Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）AThe Serial0/0 interface is passing traffic.BThe DLCI 100 was dynamically allocated by the routerCThe Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP serverDThe DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloudEThe mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
单选题Refer to the exhibit,a network administrator cannot establish a telnet session with the indicated router.What is the cause of this failure?（）AA level 5 password is not setBThe vty password is missingCThe console password is missingDAn ACL is blocking Telnet access
单选题Refer to the exhibit. A router has a 256 kbps Frame Relay circuit connected to interface serial 0/0. As a large FTP packet is being placed into the hardware transmit queue of interface serial 0/0， a voice packet is placed into the priority queue of that interface. How， and in what order， wi the packets be transmitted？（）Athe voice packet will be transmitted first， followed by the FTP packet in its entiretyBthe voice packet will be transmitted first， followed by the fragmented FTP packetCthe FTP packet will be fragmented and the voice packet will be interleavedDthe FTP packet will be transmitted first in its entirety， follow by the voice packet
多选题Refer to the exhibit. What are three of the basic components of a VoIP network？（）Asoftware voice applicationsBmultipoint control unit （MCU）CgatekeeperDcall agentEinteractive voice response （IVR） systemsFsoftphones