Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）A、The Serial0/0 interface is passing traffic.B、The DLCI 100 was dynamically allocated by the routerC、The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP serverD、The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloudE、The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）
- A、The Serial0/0 interface is passing traffic.
- B、The DLCI 100 was dynamically allocated by the router
- C、The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP server
- D、The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloud
- E、The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
相关考题：
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B
Refer to the exhibit. What must be done on router RTA to ensure that EIGRP works effectively in a Frame Relay multipoint environment?() A. Issue the command bandwidth 224 on the physical interface.B. Issue the command bandwidth 56 on the physical interface.C. Issue the command bandwidth 224 on each subinterface.D. Issue the command bandwidth 56 on each subinterface.
Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0／16?() A. show ip routeB. show policy - mapC. show access - listsD. show route - map
Refer to the exhibit. Which th ree commands should be used on router B1 to redistribute the EIGRP AS 10 routes into RIP?() A. router ripB. router eigrp 10C. redistribute eigrp 10D. redistribute ripE. default - metric 10000 100 255 1 1500F. default - metric 5
Refer to the exhibit. Based on this command output, what can we conclude about R3?() A. R3 is an ABR.B. R3 is not connec ted to the backbone.C. R3 has four neighbors.D. R3 is the DR for area 2.
Refer to the exhibit. What is required to complete the IPv6 routing configurations shown?() A. Interface authentication must be configuredB. The routing processes must be configured with an area IDC. IP unicast routing must be enabledD. IPv4 ad dresses must be applied to the interfaces
Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?() A. the serial 1/1 addressB. the serial 2/0 addressC. a randomly generated internal addressD. the configured router - id address
Refer to the exhibit. On the basis of the output, what two conclusions can be reached?() A. The default administrative distance has been changed.B. IS - IS is not enabled.C. Three physical interfaces are taking part in integrated IS - IS.D. IS - IS is not redistributing any oth er routing protocols.E. There are two neighboring routers sending IS - IS routing information.F. Address summarization is configured.
Refer to the exhibit. By default, when RTB passes BGP advertisements from RTA about network 192.168.2.0 to RTC, what address will be listed as the next － hop address? () A. 10.1.1.2B. 192.168.1.49C. 10.1.1.1D. 192.168.1.50
Refer to the exhibit. What is the most appropriate summarization for these routes?() A.10.0.0.0/21B.10.0.0.0/22C.10.0.0.0/23D.10.0.0.0/24
Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?() A.255.255.255.0B.255.255.254.0C.255.255.252.0D.255.255.248.0
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?() A.The loopback addresses are on different subnetsB.The value of the dead timers on the router are differentC.Route summarization is enabled on both routersD.The process indentifier on router A is different than the process identifier on router B
Refer to the exhibit. In this VLSM addressing scheme, what summary address would be sent from routerA?() A.172.16.0.0/16B.172.16.0.0/20C.172.16.0.0/24D.172.32.0.0/16E.172.32.0.0/17F.172.64.0.0/16
Refer to the exhibit. The user at Workstation B reports that Server A cannot be reacheD.What ispreventing Workstation B from reaching Server A?() A.The IP address for Server A is a broadcast address.B.The IP address for Workstation B is a subnet address.C.The gateway for Workstation B is not on the same subnet.D.The gateway for Server A is not on the same subnet.
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?() A.10.0.0.0B.10.0.0.254C.192.223.129.0D.192.223.129.254
Refer to the exhibit. What are three of the basic components of a VoIP network？（）A、software voice applicationsB、multipoint control unit （MCU） C、gatekeeper D、call agentE、interactive voice response （IVR） systems F、softphones
Refer to the exhibit. What does the option secret 5 in the username global configuration mode commandindicate about the enable secret password？（）A、It is hashed using SHAB、It is encrypted using DH group 5C、It is hashed using MD5D、It is encrypted via the service password-encryption commandE、It is hashed using a proprietary Cisco hashing algorithmF、It is encrypted using a proprietary Cisco encryption algorithm
Refer to the exhibit. What is the configuration an example of？（）A、enabling modular QoS over Frame RelayB、enabling Real-Time Transport Protocol （RTP） header compressionC、enabling distributed compressed Transmission Control ProtocolD、enabling latency and jitter reduction for Transmission Control trafficE、enabling TCP header compression
单选题Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?（）A 10.1.1.2B 10.154.154.1C 172.16.5.1D 192.168.5.3
单选题Refer to the exhibit. What is the configuration an example of？（）Aenabling modular QoS over Frame RelayBenabling Real-Time Transport Protocol （RTP） header compressionCenabling distributed compressed Transmission Control ProtocolDenabling latency and jitter reduction for Transmission Control trafficEenabling TCP header compression
单选题Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）AAs numbers must be changed to match on all the routers.BLoopback interface must be configured so a DR is elected.CThe no auto-summary command is needed on Router A and Router C.DRouter B needs to have two network statements, one for each connected network.
单选题Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?（）A Switch1B Switch2C Switch3D Switch4
多选题Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?（）AEnsure that the Ethernet encapsulations match on the interconnected router and switch ports.BEnsure that cables A and B are straight-through cables.CEnsure cable A is plugged into a trunk port.DEnsure the switch has power.EReboot all of the devices.FReseat all cables.
多选题Refer to the exhibit. What are three of the basic components of a VoIP network？（）Asoftware voice applicationsBmultipoint control unit （MCU）CgatekeeperDcall agentEinteractive voice response （IVR） systemsFsoftphones
单选题Refer to the exhibit. Given the DHCP pool configuration shown on Router A, the Cisco IP phone will not boot up in the Teleworker location. What is missing from the Teleworker DHCP pool configuration?（）A The DHCP pool needs to have an import all statement. B The DHCP pool is missing an option 150 ip 10.59.138.1 statement.C The DHCP pool is missing an option 139 ip 10.59.138.1 statementD The DHCP pool is missing a dns-server 10.59.138.1 statement.
问答题What does “He” in the fifth paragraph refer to?