单选题Refer to the exhibit. What is the configuration an example of?()Aenabling modular QoS over Frame RelayBenabling Real-Time Transport Protocol (RTP) header compressionCenabling distributed compressed Transmission Control ProtocolDenabling latency and jitter reduction for Transmission Control trafficEenabling TCP header compression

单选题
Refer to the exhibit. What is the configuration an example of?()
A

enabling modular QoS over Frame Relay

B

enabling Real-Time Transport Protocol (RTP) header compression

C

enabling distributed compressed Transmission Control Protocol

D

enabling latency and jitter reduction for Transmission Control traffic

E

enabling TCP header compression


参考解析

解析: 暂无解析

相关考题:

Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?()A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B

Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. W hat did the TAC engineer configure incorrectly?() A. The crypto isakmp configuration is not correct.B. The crypto map configuration is not correct.C. The interface tunnel configuration is not correct.D. The network configuration is not correct; netw ork 172.16.1.0 is missing.

Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1?() A. 10.10.10.16/28 onlyB. 10.10.10.16/28 and 10.10.10.64/26C. 10.10.10.16/28, 10.10.10.64/26, and 172.16.10.0/24D. 10.10.10.64/26 only

Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1? () A. 10.10.10.16/28 onlyB. 10.10.10.16/28 and 10.10.10.64/26C. 10.10.10.16/28, 10.10.10 .64/26, and 172.16.10.0/24D. 10.10.10.64/26 only

Refer to the exhibit. A partial routing configuration is shown. Complete the configuration so that only the default - network is redistributed from EIGRP 190 into EIGRP 212. Which ACL statement completes the configuration correctly? ()A. access - list 100 permit ip 0.0.0.0 0.0.0.0 0.0.0.0 0.0.0 .0B. access - list 100 permit ip host 0.0.0.0 anyC. access - list 100 permit ip any host 0.0.0.0D. A default -network cannot be redistributed between routing processes.

Refer to the exhibit. A network administrator wants to reduce the number of OSPF routes advertised from Area 1 into Area 2. As the router configuration specialist, what two things would you do to accomplish this goal?()A. Enter the configuration on router B1.B. Enter the configuration on router B4.C. On the same router, enter the Summary - address 10.10.1.0 255.255.255.128 subcommand.D. On the same router, enter the Area 1 range 10.10.1.0 255.255.255.128 subcommand.E. On the same ro uter, enter the Area 2 range 10.10.1.0 255.255.255.128 subcommand.

Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?() A. the serial 1/1 addressB. the serial 2/0 addressC. a randomly generated internal addressD. the configured router - id address

Refer to the exhibit. What three statements are true about the IS - IS configuration?() A.The router is in area 49.0001.0002B.The router acts as a Level 1 - 2 routerC.CLNS routing is enable d for the routerD.The router has a system ID of 0003.0004E.The interfaces have a functional IS - IS configurationF.The network service access point selector (NSEL) byte has a value of 0

Refer to the exhibit. What statement is true base d upon the configuration in the exhibit? () A. CGMP version 2 is being used.B. The switch will use sparse mode first, dense mode second.C. A rendezvous point must be configured in order for the interface to operate in sparse mode.D. IGMP version 2 is being used.E. The rendezvous point is IP address 172.16.4.16.F. If a rendezvous point is configured, the interface cannot operate in dense mode.

Refer to the exhibit. IP multicast configuration changes have been made on several routers.However, the IP multicast table displayed in the exhibit still does not reflect the changes. What should be done to display the new routing table information? ()A. Issue the clear ip route * privileged EXEC command.B. Issue the clear ip igmp group privileged EXEC command.C. Issue the no ip mroute - cache privileged EXEC command.D. Issue the clear ip mroute privileged EXEC command.

Refer to the exhibit. By default, when RTB passes BGP advertisements from RTA about network 192.168.2.0 to RTC, what address will be listed as the next - hop address? () A. 10.1.1.2B. 192.168.1.49C. 10.1.1.1D. 192.168.1.50

Refer to the exhibit. What is the most appropriate summarization for these routes?() A.10.0.0.0/21B.10.0.0.0/22C.10.0.0.0/23D.10.0.0.0/24

Refer to the exhibit. In this VLSM addressing scheme, what summary address would be sent from routerA?() A.172.16.0.0/16B.172.16.0.0/20C.172.16.0.0/24D.172.32.0.0/16E.172.32.0.0/17F.172.64.0.0/16

Refer to the exhibit. What does the (*) represent in the output?() A.Packet is destined for a local interface to the router.B.Packet was translated, but no response was received from the distant device.C.Packet was not translated, because no additional ports are available.D.Packet was translated and fast switched to the destination.

Refer to the exhibit. What can be determined about the router from the console output?() A.No configuration file was found in NVRAM.B.No configuration file was found in flash.C.No configuration file was found in the PCMCIA card.D.Configuration file is normal and will load in 15 seconds.

Refer to the exhibit.   What are three of the basic components of a VoIP network?()A、software voice applicationsB、multipoint control unit (MCU)  C、gatekeeper  D、call agentE、interactive voice response (IVR) systems  F、softphones

Refer to the exhibit. What does the option secret 5 in the username global configuration mode commandindicate about the enable secret password?()A、It is hashed using SHAB、It is encrypted using DH group 5C、It is hashed using MD5D、It is encrypted via the service password-encryption commandE、It is hashed using a proprietary Cisco hashing algorithmF、It is encrypted using a proprietary Cisco encryption algorithm

Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()A、The router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2B、The configuration is invalid because the DHCP options are global configuration commandsC、The configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfacesD、The router will choose which pool to use based upon the interface the DHCP request wasreceived on

Refer to the exhibit. What is the configuration an example of?()A、enabling modular QoS over Frame RelayB、enabling Real-Time Transport Protocol (RTP) header compressionC、enabling distributed compressed Transmission Control ProtocolD、enabling latency and jitter reduction for Transmission Control trafficE、enabling TCP header compression

单选题Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?()A 10.1.1.2B 10.154.154.1C 172.16.5.1D 192.168.5.3

单选题Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?()A Switch1B Switch2C Switch3D Switch4

单选题Refer to the exhibit. What does the option secret 5 in the username global configuration mode commandindicate about the enable secret password?()AIt is hashed using SHABIt is encrypted using DH group 5CIt is hashed using MD5DIt is encrypted via the service password-encryption commandEIt is hashed using a proprietary Cisco hashing algorithmFIt is encrypted using a proprietary Cisco encryption algorithm

单选题Refer to the exhibit. The DHCP configuration that is shown is configured on a Cisco router. Whichstatement is true?()AThe router will distribute IP addresses from pool 1 until its addresses are exhausted. Then therouter will begin distributing addresses from pool 2BThe configuration is invalid because the DHCP options are global configuration commandsCThe configuration is incomplete until the DHCP pools are bound to the appropriate interface orinterfacesDThe router will choose which pool to use based upon the interface the DHCP request wasreceived on

多选题Refer to the exhibit.   What are three of the basic components of a VoIP network?()Asoftware voice applicationsBmultipoint control unit (MCU)CgatekeeperDcall agentEinteractive voice response (IVR) systemsFsoftphones

单选题Refer to the exhibit. Given the DHCP pool configuration shown on Router A, the Cisco IP phone will not boot up in the Teleworker location. What is missing from the Teleworker DHCP pool configuration?()A The DHCP pool needs to have an import all statement. B The DHCP pool is missing an option 150 ip 10.59.138.1 statement.C The DHCP pool is missing an option 139 ip 10.59.138.1 statementD The DHCP pool is missing a dns-server 10.59.138.1 statement.

单选题Refer to the exhibit. When a profile is configured in the Aironet Desktop Utility, which security option  permits the configuration of host-based Extensible Authentication Protocol (EAP)?()A  WPA/WPA2/CCKMB  WPA/WPA2 PassphraseC  802.1xD  Pre-Shared Key (Static WEP)

单选题Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enter the system configuration dialog as shown. What is the caust of the problem?()A The network administrator faled to save the configuration.B The configuration register is set to 0x2100.C The boot system flash command is missing from the configuration.D The configuraiton register is set to 0x2102.E The router is configured with the boot system startup command.