After installing a second processor and corresponding heatsink into a server， an administrator notices that the new processor is not showing up during POST. Which of the following could be the cause of this issue？（）A、 The power supply is not sufficient to power the server.B、 The voltage regulator module （VRM） was not installed.C、 The IRQ setting was not set.D、 The DMA setting was not set.
After installing a second processor and corresponding heatsink into a server， an administrator notices that the new processor is not showing up during POST. Which of the following could be the cause of this issue？（）
- A、 The power supply is not sufficient to power the server.
- B、 The voltage regulator module （VRM） was not installed.
- C、 The IRQ setting was not set.
- D、 The DMA setting was not set.
相关考题：
A user reports it takes a long time to load all applications and the hard drive LED is showing constant activity. Which of the following is MOST likely the issue?() A. The processor is faulty.B. The file system is fragmented.C. The modem drivers are corrupt.D. The power supply is faulty.
An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?（）A. Processor failureB. Third party memoryC. Disk drive failureD. ESD during the upgradeE. Backplane failure
An administrator will replace five current servers. Which of the following is the MOST important to review before installing new servers?() A. Verify uninterruptible power supply (UPS) loadB. Verify if server consumes 220VC. Verify CPU loadD. Verify if server consumes 110V
An administrator identifies that a server is shutting down. The administrator powers up the server and OS loads but after a few minutes it powers down again. Which of the following is the cause?（）A、Redundant power supply failureB、CPU overheatingC、Memory failureD、Hard disk failure
Several reports are logged stating that an application server is performing slowly. During the investigation， the administrator notices that the hard drives on the server appear to have a high level ofactivity. Which items should the administrator monitor using performance monitoring tools？ （）A、 Page FileB、 Disk UtilizationC、 System TemperatureD、 Processor UtilizationE、 Network Utilization
An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）A、The hard drives were not plugged into the server correctly.B、The controller driver is outdated and needs to be updated from the OEMs website.C、The firmware for the server is too old and does not support the new RAID controller card.D、The cable from the controller to the hard drive backplane is not connected.
A technician is building a Windows 2008 server and has installed a motherboard， processor， and power supply. Which of the following optical drives should the technician install？（）A、Flash DriveB、DVD-RWC、CD-ROMD、SSD
Which of the following is the MOST likely to cause a server power supply fan to fail but allows the power supply to still be functional？（）A、DustB、Power SurgeC、Excessive humidityD、High temperatures
The technician has replaced a power supply with an identical power supply, and now the high end graphics card is not working. Which of the following should the technician check?（）A、The memoryB、The CMOS batteryC、The PCIe power jackD、The processor for chip creep
A user reports it takes a long time to load all applications and the hard drive LED is showing constant activity. Which of the following is MOST likely the issue?（）A、The processor is faulty.B、The file system is fragmented.C、The modem drivers are corrupt.D、The power supply is faulty.
Which of the following is MOST critical when installing a new processor in an existing system?（）A、Thermal pasteB、FansC、Drive speedsD、Cable management
An administrator will replace five current servers. Which of the following is the MOST important to review before installing new servers？（）A、 Verify uninterruptible power supply （UPS） loadB、 Verify if server consumes 220VC、 Verify CPU loadD、 Verify if server consumes 110V
A technician has just completed a CPU upgrade on a motherboard. Which of the following will MOST likely cause the PC not to boot?（）A、The technician used generic thermal paste.B、The processor had pins broken during installation.C、The memory is incompatible with the new CPU.D、An incorrect fan size was installed on the heatsink.
A technician has just installed an upgraded graphics card. The computers power turns off before itfinishes booting. Which of the following is the cause of the problem? （）A、The monitor cannot display the increased resolution that is a feature of the new graphics card.B、The power supply does not provide enough wattage to power the new graphics card.C、The new graphics card is incompatible with the existing processor.D、The computer does not have enough RAM to support the new graphics card.
An SNMP alert has been generated by a server in the main data center.The alert stated that the internal temperature of the server has exceeded the threshold.No other servers in the rack have experienced problems，and no other alerts have come from that server about any other events.Which of the following is the cause of this issue？（）A、Rack cooling equipment failureB、Dust collection in the serverC、Server processor failureD、Server power supply failure
An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade, it times out. Which of the following could be the cause of the problem?（）A、Processor failureB、Third party memoryC、Disk drive failureD、ESD during the upgradeE、Backplane failure
An Administrator notices a decrease in the performance of his site. This is directly related to an increase in usage. After further investigation he notices that users appear to be pooling up in the web server. Which of the following would cause this to occur？（）A、The web Server ThreadsPerChild directive could be set too low.B、The Web Container Thread Pool Minimum Size could be set too high.C、The Web Container Thread Pool Maximum Size could be set too high.D、The growable thread pool setting could be disabled for the Web Container.
单选题A technician is building a Windows 2008 server and has installed a motherboard， processor， and power supply. Which of the following optical drives should the technician install？（）AFlash DriveBDVD-RWCCD-ROMDSSD
多选题An Administrator notices a decrease in the performance of his site. This is directly related to an increase in usage. After further investigation he notices that users appear to be pooling up in the web server. Which of the following would cause this to occur？（）AThe web Server ThreadsPerChild directive could be set too low.BThe Web Container Thread Pool Minimum Size could be set too high.CThe Web Container Thread Pool Maximum Size could be set too high.DThe growable thread pool setting could be disabled for the Web Container.
单选题A technician has just installed an upgraded graphics card. The computers power turns off before itfinishes booting. Which of the following is the cause of the problem? （）AThe monitor cannot display the increased resolution that is a feature of the new graphics card.BThe power supply does not provide enough wattage to power the new graphics card.CThe new graphics card is incompatible with the existing processor.DThe computer does not have enough RAM to support the new graphics card.
单选题A user reports it takes a long time to load all applications and the hard drive LED is showing constant activity. Which of the following is MOST likely the issue?（）AThe processor is faulty.BThe file system is fragmented.CThe modem drivers are corrupt.DThe power supply is faulty.
单选题A technician has just completed a CPU upgrade on a motherboard. Which of the following will MOST likely cause the PC not to boot?（）AThe technician used generic thermal paste.BThe processor had pins broken during installation.CThe memory is incompatible with the new CPU.DAn incorrect fan size was installed on the heatsink.
多选题An administrator has shut down a server to install additional memory. When the administrator restarts the server after the upgrade， it times out. Which of the following could be the cause of the problem？（）AProcessor failureBThird party memoryCDisk drive failureDESD during the upgradeEBackplane failure
单选题After installing a second processor and corresponding heatsink into a server， an administrator notices that the new processor is not showing up during POST. Which of the following could be the cause of this issue？（）A The power supply is not sufficient to power the server.B The voltage regulator module （VRM） was not installed.C The IRQ setting was not set.D The DMA setting was not set.
单选题An administrator just installed a new RAID controller card into a server. The firmware is current for the controller card. When the server is powered up the administrator notices that the RAID controller card is not recognized during POST. Which of the following is the cause of the problem？（）AThe hard drives were not plugged into the server correctly.BThe controller driver is outdated and needs to be updated from the OEMs website.CThe firmware for the server is too old and does not support the new RAID controller card.DThe cable from the controller to the hard drive backplane is not connected.
单选题An administrator identifies that a server is shutting down. The administrator powers up the server and OS loads but after a few minutes it powers down again. Which of the following is the cause？（）A Redundant power supply failureB CPU overheatingC Memory failureD Hard disk failure
单选题An SNMP alert has been generated by a server in the main data center.The alert stated that the internal temperature of the server has exceeded the threshold.No other servers in the rack have experienced problems，and no other alerts have come from that server about any other events.Which of the following is the cause of this issue？（）ARack cooling equipment failureBDust collection in the serverCServer processor failureDServer power supply failure