多选题A technician is attempting to get into the BIOS and they are being prompted for a password. Which of the following can clear the BIOS password？（）APull the CMOS battery.BPull the 20/24 pin connector from the main board.CShort the reset circuit near the RAM.DUse the appropriate jumper on main board.EUse the reset button on the front panel.
多选题
A technician is attempting to get into the BIOS and they are being prompted for a password. Which of the following can clear the BIOS password？（）
A
Pull the CMOS battery.
B
Pull the 20/24 pin connector from the main board.
C
Short the reset circuit near the RAM.
D
Use the appropriate jumper on main board.
E
Use the reset button on the front panel.
参考解析
解析：
暂无解析
相关考题：
A technician turns on a PC and before the computer boots up, the technician is prompted for apassword. The technician does not know the password. Which of the following can the techniciando to allow access to the PC?（） (Select TWO).A. Set the clear password jumper on the motherboardB. Enter the BIOS setup and select the clear password settingC. Remove the power cord from the power supply and then plug it back inD. Power cycle the PCE. Remove the CMOS battery for 15 minutes
A user has forgotten their BIOS password on their computer. Which of the following would atechnician use to allow the user access to their PC?() A. Remove the BIOS chip on the PCB. Re-flash the BIOSC. Run password cracking software on the users PCD. Set the password clear jumper on the motherboard
When a user’s computer is first turned on, they see a lock symbol and a blinking cursor. Which of the following was configured in the BIOS to show this?() A. Intrusion detectionB. Power on passwordC. Drive encryptionD. BIOS password
Which of the following would represent a power supply connector that supplies the main power toan ATX motherboard?() A. 6-pin PCI connectorB. 24-pin connectorC. Molex connectorD. SATA connector
A technician would like to load an operating system CD on startup. Which of the following settings would a technician change in the BIOS?() A. Enable TPMB. Enable BIOS passwordC. Disable TPMD. Boot sequence
A technician is attempting to get into the BIOS and they are being prompted for a password. Which of the following can clear the BIOS password？（）A、Pull the CMOS battery.B、Pull the 20/24 pin connector from the main board.C、Short the reset circuit near the RAM.D、Use the appropriate jumper on main board.E、Use the reset button on the front panel.
A technician turns on a PC and before the computer boots up, the technician is prompted for apassword. The technician does not know the password. Which of the following can the techniciando to allow access to the PC?（） (Select TWO).A、Set the clear password jumper on the motherboardB、Enter the BIOS setup and select the clear password settingC、Remove the power cord from the power supply and then plug it back inD、Power cycle the PCE、Remove the CMOS battery for 15 minutes
A technician is attempting to configure Windows XP Media Center on a desktop from a CD. The message that comes up on the screen says ‘Missing NTLDR press any key to reboot’. Which of the following should the technician do NEXT?（）A、Replace the video card with a compatible one.B、Check the Windows XP Hardware Compatibility List.C、Verify the boot order in the BIOS.D、Install Windows XP RC2 first, then upgrade to Windows XP Media Center.
A technician would like to load an operating system CD on startup. Which of the following settings would a technician change in the BIOS?（）A、Enable TPMB、Enable BIOS passwordC、Disable TPMD、Boot sequence
When a user’s computer is first turned on, they see a lock symbol and a blinking cursor. Which of the following was configured in the BIOS to show this?（）A、Intrusion detectionB、Power on passwordC、Drive encryptionD、BIOS password
Which of the following will reset the BIOS settings?（） (Select TWO).A、Unplug the CMOS battery.B、Unplug the power supply.C、Switch on the reset jumper.D、Replace the RAM.E、Unplug the CPU.
A technician purchases a new 120 GB IDE hard disk to use in an old server as a swap drive. After adding the drive to the server， the technician discovers that the operating system does not detect the drive. After rebooting the server， the technician notices the drive is missing from POST and comes to the conclusion that the BIOS needs to be updated. The technician downloads the latest version of the BIOS update from the manufacturer website. Which action should the technician take next？（）A、 backup the BIOS configuration to use laterB、 install the BIOS update from a command promptC、 create a bootable floppy and copy the BIOS update tools to the floppyD、 read the manufacturer’s guidelines and recommendations on installing the update
A technician is locked out of a desktops BIOS because of a forgotten password. Which of the following is a method of removing the password？（）A、Replace the power supply unit.B、Reseat the systems memory.C、Reset the proper jumper.D、Re-install the operating system.
In which of the following locations would a technician set the LBA mode for a hard drive？（）A、Jumper SettingsB、Disk ManagerC、Device ManagerD、System BIOS
Which of the following will corrupt the BIOS?（）A、Applying the BIOS settings in the incorrect orderB、Power being lost during the upgrade processC、Installing the OS before applying the BIOS upgradeD、Imaging the system after performing a BIOS upgrade
Which of the following connectors uses the main board ATX connector type?（）A、CentronixB、20/24 pinC、BNCD、Molex
A user has forgotten their BIOS password on their computer. Which of the following would atechnician use to allow the user access to their PC?（）A、Remove the BIOS chip on the PCB、Re-flash the BIOSC、Run password cracking software on the users PCD、Set the password clear jumper on the motherboard
Which of the following would represent a power supply connector that supplies the main power toan ATX motherboard?（）A、6-pin PCI connectorB、24-pin connectorC、Molex connectorD、SATA connector
A technician arrives in Germany and discovers that when their PC is plugged into the outlet, nopower is received. Which of the following actions should the technician take to get the PC tooperate?（）A、Change the BIOS settings to the local timeB、Adjust the voltage selector switchC、Attach a 220 volt power strip from the current region to the PCD、Attach a 120 volt battery backup power supply to the PC
A technician is preparing to update the BIOS on a laptop. Which of the following should thetechnician do to prevent problems during the update?（）A、Remove all of the memoryB、Plug in the AC adapterC、Remove the hard drive and optical driveD、Clear the partitions on the hard drive
单选题Which of the following will corrupt the BIOS？（）A Applying the BIOS settings in the incorrect orderB Power being lost during the upgrade processC Installing the OS before applying the BIOS upgradeD Imaging the system after performing a BIOS upgrade
单选题A technician purchases a new 120 GB IDE hard disk to use in an old server as a swap drive. After adding the drive to the server， the technician discovers that the operating system does not detect the drive. After rebooting the server， the technician notices the drive is missing from POST and comes to the conclusion that the BIOS needs to be updated. The technician downloads the latest version of the BIOS update from the manufacturer website. Which action should the technician take next？（）A backup the BIOS configuration to use laterB install the BIOS update from a command promptC create a bootable floppy and copy the BIOS update tools to the floppyD read the manufacturer’s guidelines and recommendations on installing the update
多选题Which TWO of the following are required to use the hot-swap memory feature of the x445 while being operating system independent？（）AMemory Mirroring must be enabled in the BIOS.BRedundant bit steering must be enabled in the BIOS.CDIMMs must be the same size and speed as the DIMMs being replaced.DMemory Mirroring must be enabled in the operating system.EDIMMs can be of same size or larger or same speed or faster.
单选题A technician is locked out of a desktops BIOS because of a forgotten password. Which of the following is a method of removing the password？（）AReplace the power supply unit.BReseat the systems memory.CReset the proper jumper.DRe-install the operating system.
多选题A technician is attempting to get into the BIOS and they are being prompted for a password. Which of the following can clear the BIOS password？（）APull the CMOS battery.BPull the 20/24 pin connector from the main board.CShort the reset circuit near the RAM.DUse the appropriate jumper on main board.EUse the reset button on the front panel.
多选题A technician turns on a PC and before the computer boots up, the technician is prompted for apassword. The technician does not know the password. Which of the following can the techniciando to allow access to the PC?（） (Select TWO).ASet the clear password jumper on the motherboardBEnter the BIOS setup and select the clear password settingCRemove the power cord from the power supply and then plug it back inDPower cycle the PCERemove the CMOS battery for 15 minutes
多选题Which of the following will reset the BIOS settings?（） (Select TWO).AUnplug the CMOS battery.BUnplug the power supply.CSwitch on the reset jumper.DReplace the RAM.EUnplug the CPU.
单选题Which of the following would represent a power supply connector that supplies the main power toan ATX motherboard?（）A6-pin PCI connectorB24-pin connectorCMolex connectorDSATA connector