单选题Which of the following multicast mode does Auto-RP require？（）ALink-modeBDense modeCSparse modeDSparse-dense mode
单选题
Which of the following multicast mode does Auto-RP require？（）
A
Link-mode
B
Dense mode
C
Sparse mode
D
Sparse-dense mode
参考解析
解析：
暂无解析
相关考题：
Which of the following modes of heat transfer does NOT require any physical contact between a warmer and a cooler substance?A.RadiationB.ConductionC.Natural convectionD.contact directly
Which multicast mode does Auto－RP require?() A. Link-modeB. Dense modeC. Sparse modeD. Sparse-dense mode
Which two multicast groups support Auto－RP mapping and discovery?() A.224.0.0.39B.224.0.1.39C.224.0.0.40D.224.0.1.40
Which two multicast protocol statements are true?() A. Sparse mode multicast uses a pull model to send multicast traffic to where it is requestedB. Dense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted trafficC. Dense mode multicast requires explicit join messa ges from their membersD. Sparse mode uses reverse path forwarding (RPF) to prune off redundant flowsE. The primary use of sparse mode multicast is for test labs and router performance testing
Which of the following statements is correct regarding PIM Sparse Mode operations？（）A、It does not support all underlying unicast routing protocols like GBPB、It supports shared trees only assuming all hosts want the multicast trafficC、Receivers are registered with RP by their first-hop routerD、Receivers are joinedto the Shared Tree（rooted the rp ）by their local Designated Router（DR）E、From the RP，traffic flows down a Source Tree to each receiver
Which three statements are true about IP multicast configuration?（）A、PIM sparse - dense mode and PIM dense mode require an RP on the network.B、PIM sparse mode and PIM dense mode require an RP on the network.C、PIM sparse mode interfaces are always added to the multicast routing table in a router.D、PIM sparse mode and PIM sparse - dense mode require an RP on the network.E、PIM dense mode interfaces are always added to the multicast routing table in a router.F、PIM sparse - dense mode acts as PIM dense mode if an RP is not known.
Which three statements best describe multicast operation on Cisco Nexus switches in a data center？（）A、 Cisco NX-OS Software does not support PIM dense mode.B、 The command ip multicast-routing must be enabled in Cisco NX-OS Software before any multicast configuration is possible on the switch.C、 PIM CLI configuration and verification commands are not available until you enable the PIM feature with the feature pim command.D、 Cisco NX-OS Software supports multicast routing per Layer 3 VRF instance.E、 The default PIM operational mode on the Cisco Nexus 7000 switch is SSM.
Which two statements are tru e about the rendezvous point (RP) in a multicast network?（）A、The multicast sources must register with the RP to form the multicast distribution treeB、An RP is required only in networks running Protocol Independent Multicast dense mode ( PIM DM)C、The multicast receivers must register with the RP to form the multicast distribution treeD、An RP is required only in networks running Protocol Independent Multicast sparse mode (PIM SM)E、An RP is required only in networks running Pro tocol Independent Multicast sparse - dense mode (PIM - SDM)F、To form the multicast distribution tree, the multicast sources register with and the receivers join the RP
In PIM-SM operations，to which device does the first router that connects with the multicast source sendthe register message？（）A、RPB、multicast sourceC、IGMP routerD、multicast receiverE、PIM designated router
Which statement about active and passive surveys is incorrect？（）A、Active mode does not require the client to be specifically confguredB、Passive mode can survey more than one access point at a timeC、Active mode yields signal-quality information such as packet retries and lost packetsD、Active mode requires more time to survey but yields more information results than passive mode does
Which of the following connector types does CAT5e require to connect it from a PC to a switch or router?（）A、RJ-45B、RJ-11C、BNCD、LC
A small office in which all workstations are using an ISP provided IP range has noticed a consistent decrease in network traffic speed. The decrease does not occur when the gateway to the ISP is disconnected. Which of the following should the administrator implement?（） A、Multicast addressingB、Load balancingC、Address translationD、DHCP
A customer asked a consultant to create the infrastructure for an application. The application is designed to charge customers for conferencing services based on usage. To determine if a Storage Area Network （SAN） is the best storage solution， which of the following questions is most appropriate？（）A、Will the application require a database？B、Which operating system does the application require？C、Will the data need to be backed up in real time？D、Does the application share data among the servers？
Which multicast groups support Auto-RP mapping and discovery？（）A、224.0.0.39B、224.0.1.39C、224.0.0.40D、224.0.1.40
Which of the following operations does not require Oracle to store information in an UNDO segments as part of the transaction?（）A、INSERT B、SELECT C、UPDATE D、DELETE
单选题Which of the following statements is correct regarding PIM Sparse Mode operations？（）AIt does not support all underlying unicast routing protocols like GBPBIt supports shared trees only assuming all hosts want the multicast trafficCReceivers are registered with RP by their first-hop routerDReceivers are joinedto the Shared Tree（rooted the rp ）by their local Designated Router（DR）EFrom the RP，traffic flows down a Source Tree to each receiver
多选题Which multicast groups support Auto-RP mapping and discovery？（）A224.0.0.39B224.0.1.39C224.0.0.40D224.0.1.40
单选题Which of the following modes of heat transfer does NOT require any physical contact between a warmer and a cooler substance?（）ARadiationBConductionCNatural convectionDAll of the above
单选题Which of the following connector types does CAT5e require to connect it from a PC to a switch or router?（）ARJ-45BRJ-11CBNCDLC
单选题Which multicast mode does Auto-RP require?（）ALink-modeBDense modeCSparse modeDSparse-dense mode
单选题As a watch officer when bunkering, which of the following does require his individual attention?（）Adraft of the vesselBrate of deliveryCcommunication with terminal personnelDobservation of manifold valves
多选题Which two multicast groups support Auto-RP mapping and discovery？（）A224.0.0.39B224.0.1.39C224.0.0.40D224.0.1.40
多选题Which two multicast protocol statements are true？ （Choose two.） （）ADense mode multicast requires explicit join messages from their members.BDense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted traffic.CSparse mode multicast uses a pull model to send multicast traffic to where it is requested.DSparse mode uses reverse path forwarding （RPF） to prune off redundant flows.EThe primary use of sparse mode multicast is for test labs and router performance testing.
单选题The ip pim autorp listener command is used to do which of these？（）Aenable a Cisco router to passively listen to Auto-RP packets without the router actively sending or forwarding any of the packetsBallow Auto-RP packets in groups 224.0.1.39 and 224.0.1.40 to be flooded in dense mode out interfaces configured with the ip pim sparse-mode commandCenable the use of Auto-RP on a routerDconfigure the router as an Auto-RP mapping agent
多选题Which two multicast protocol statements are true?（）ASparse mode multicast uses a pull model to send multicast traffic to where it is requestedBDense mode multicast uses a push model to flood traffic throughout the network and then prunes the unwanted trafficCDense mode multicast requires explicit join messa ges from their membersDSparse mode uses reverse path forwarding (RPF) to prune off redundant flowsEThe primary use of sparse mode multicast is for test labs and router performance testing