单选题A standard access control list has been configured on a router and applied to interface Serial 0 in anoutbound direction. No ACL is applied to Interface Serial 1 on the same router. What will happen whentraffic being filtered by the access list does not match the configured ACL statements for Serial 0？（）AThe traffic is droppedBThe resulting action is determined by the destination IP addressCThe source IP address is checked，and，if a match is not found， traffic is routed out interface Serial 1DThe resulting action is determined by the destination IP address and port number
单选题
A standard access control list has been configured on a router and applied to interface Serial 0 in anoutbound direction. No ACL is applied to Interface Serial 1 on the same router. What will happen whentraffic being filtered by the access list does not match the configured ACL statements for Serial 0？（）
A
The traffic is dropped
B
The resulting action is determined by the destination IP address
C
The source IP address is checked，and，if a match is not found， traffic is routed out interface Serial 1
D
The resulting action is determined by the destination IP address and port number
参考解析
解析：
暂无解析
相关考题：
Evaluate the following block of code:What is the outcome of the above code?() A. It produces an error because a fully qualified host name needs to be specified.B. It produces an error because the range of ports associated with the hosts has not been specified.C. It creates an access control list (ACL) with the user ACCT_MGR who gets the CONNECT and RESOLVE privileges.D. It creates an access control list (ACL) with the user ACCT_MGR who gets the CONNECT privilege but not the RESOLVE privilege.
You are a technician at TestKing. Your assistant applied an IP access control list to Router TK1. You want to check the placement and direction of the access control list.Which command should you use?（）A. show access-listB. show ip access-listC. show ip interfaceD. show interfaceE. show interface list
A standard IP access list is applied to an Ethernet interface of a router. What does this standard access list filter on?() A. The source and destination addressesB. The destination port numberC. The destination addressD. The source addressE. All of the above
Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q- complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached?（）A.VLANs have not been created yetB.An IP address must be configured for the portC.The port is currently configured for access modeD.The correct encapsulation type has not been configuredE.The no shutdown command has not been entered for the port
Which item represents the standard IPACL?() A.access-list 50 deny 192.168.1.10.0.0.255B.access-list 110 permit ip any anyC.access-list 2500 deny tcp any host 192.168.1.1 eq22D.access-list 101 deny tcp any host 192.168.1.1
Router R1 has been configured for EIGRP. The configuratio n also includes an ACL with one line -access - list 1 permit 10.100.32.0 0.0.15.255 - and the EIGRP configuration includes the distribute -list 1 in command. Which of the following routes could not be displayed in the output of the show ip eigrp topology comm and as a result?（）A、10.10.32.0/19B、10.10.44.0/22C、10.10.40.96/27D、10.10.48.0/23E、10.10.60.0/30
An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL (Choose three.)（）。A、FTPB、TelnetC、SMTPD、DNSE、HTTPF、POP3
You are a technician at TestKing. Your assistant applied an IP access control list to Router TK1. You want to check the placement and direction of the access control list.Which command should you use?（）A、show access-listB、show ip access-listC、show ip interfaceD、show interfaceE、show interface list
Refer to the exhibit. Which statement is correct based on the show login command output shown？（）A、When the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.B、The login block-for command is configured to block login hosts for 93 seconds.C、All logins from any sources are blocked for another 193 seconds.D、Three or more login requests have failed within the last 100 seconds.
A standard IP access list is applied to an Ethernet interface of a router. What does this standard access list filter on?（）A、The source and destination addressesB、The destination port numberC、The destination addressD、The source addressE、All of the above
A network administrator has configured access list 172 to prevent Telnet and ICMP traffic from reaching a server with the address if 192.168.13.26. Which command can the administrator issue to verify that the access list is working properly?（）A、Router# ping 192.168.13.26B、Router# debug access-list 172C、Router# show open ports 192.168.13.26D、Router# show access-listE、Router# show ip interface
创建一个标准命名访问控制列表cisco用来拒绝网络192.168.160.0到192.168.191.0内的主机，下面表达式正确的是（）。A、ip access-list standard cisco deny 192.168.160.0 255.255.240.0B、ip access-list standard cisco deny 192.168.160.0 0.0.191.255C、ip access-list standard cisco deny 192.168.160.0 0.0.31.255D、ip access-list standard cisco deny 192.168.0.0 0.0.31.255
A standard access control list has been configured on a router and applied to interface Serial 0 in anoutbound direction. No ACL is applied to Interface Serial 1 on the same router. What will happen whentraffic being filtered by the access list does not match the configured ACL statements for Serial 0？（）A、The traffic is droppedB、The resulting action is determined by the destination IP addressC、The source IP address is checked，and，if a match is not found， traffic is routed out interface Serial 1D、The resulting action is determined by the destination IP address and port number
Which item represents the standard IP ACL?（）A、access-list 50 deny 192.168.1.10.0.0.255B、access-list 110 permitip any anyC、access-list 2500 deny tcp any host 192.168.1.1eq22D、access-list 101 deny tcp any host 192.168.1.1
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines. What command would assign this access- list to the Virtual Terminal Lines?（）A、router(config-line)# ip access-group 1 inB、router(config-line)# access-class 1 inC、router(config-line)# ip access-list 1 inD、router(config-line)# access-line 1 in
An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports21, 23 and 25. What types of packets will be permitted by this ACL? (Choose three.)（）A、FTPB、TelnetC、SMTPD、DNSE、HTTPF、POP3
An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL? （）A、FTPB、TelnetC、SMTPD、DNSE、HTTPF、POP3
单选题You are validating the configuration of your SRX Series device and see the output shown below. What does this indicate?（）A The SRX Series device has been configured correctly, the Junos Pulse Access Control Service is reachable on the network, and the SRX Series device is waiting to receive the initial connection from the Junos Pulse Access Control Service.B The SRX Series device has confirmed that the Junos Pulse Access Control Service is configured and is reachable on the network, the SRX Series device is waiting to receive the connection from the Junos Pulse Access Control Service, and all that remains to be accomplished is to configure the SRX Series device.C The SRX Series device is configured correctly and connected to the Junos Pulse Access Control Service. All that remains to be done to complete the configuration is to configure the SRX Series device on the Junos Pulse Access Control Service.D Both the Junos Pulse Access Control Service and the SRX Series device are configured correctly and communicating with each other.
单选题Refer to the exhibit. Which statement is correct based on the show login command output shown？（）AWhen the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.BThe login block-for command is configured to block login hosts for 93 seconds.CAll logins from any sources are blocked for another 193 seconds.DThree or more login requests have failed within the last 100 seconds.
多选题An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports21, 23 and 25. What types of packets will be permitted by this ACL? (Choose three.)（）AFTPBTelnetCSMTPDDNSEHTTPFPOP3
多选题An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL (Choose three.)（）。AFTPBTelnetCSMTPDDNSEHTTPFPOP3
单选题A standard IP access list is applied to an Ethernet interface of a router. What does this standard access list filter on?（）AThe source and destination addressesBThe destination port numberCThe destination addressDThe source addressEAll of the above
多选题An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL? （）AFTPBTelnetCSMTPDDNSEHTTPFPOP3
多选题你需要创建一个标准命名访问控制列表cisco用来拒绝主机172.16.198.94/19所在的子网，表示错误的有（）。Aip access-list standard cisco deny 172.16.192.0 0.0.31.255Bip access-list standard cisco deny 172.16.0.0 0.0.255.255Cip access-list standard cisco deny 172.16.172.0 0.0.31.255Dip access-list standard cisco deny 172.16.188.0 0.0.15.255Eip access-list standard cisco deny 172.16.192.0 0.0.15.255
单选题A standard access control list has been configured on a router and applied to interface Serial 0 in anoutbound direction. No ACL is applied to Interface Serial 1 on the same router. What will happen whentraffic being filtered by the access list does not match the configured ACL statements for Serial 0？（）AThe traffic is droppedBThe resulting action is determined by the destination IP addressCThe source IP address is checked，and，if a match is not found， traffic is routed out interface Serial 1DThe resulting action is determined by the destination IP address and port number
单选题You are a technician at TestKing. Your assistant applied an IP access control list to Router TK1. You want to check the placement and direction of the access control list.Which command should you use?（）Ashow access-listBshow ip access-listCshow ip interfaceDshow interfaceEshow interface list
单选题Your network contains a domain-based namespace named DFS1. DFS1 has Windows 2008 Server mode enabled. You need to ensure that only files and folders in DFS1 that users have permissions to access are displayed. What should you do?（）ADisable referrals.BModify the system access control list.CEnable access-based enumeration (ABE).DModify the discretionary access control list.
多选题A network administrator has configured access list 172 to prevent Telnet and ICMP traffic from reaching a server with the address if 192.168.13.26. Which command can the administrator issue to verify that the access list is working properly?（）ARouter# ping 192.168.13.26BRouter# debug access-list 172CRouter# show open ports 192.168.13.26DRouter# show access-listERouter# show ip interface