Which two are characteristics of the IS －IS protocol but not OSPF?() A. forms adjacencies with all neighborsB. supports demand circuit routingC. provides routing support for multiple network layer protocolsD. utilizes SPF algorithmE. provides for network scalability by allowing the network to be separated into areasF. three layers of hierarchical routing
Which two are characteristics of the IS －IS protocol but not OSPF?()
A. forms adjacencies with all neighbors
B. supports demand circuit routing
C. provides routing support for multiple network layer protocols
D. utilizes SPF algorithm
E. provides for network scalability by allowing the network to be separated into areas
F. three layers of hierarchical routing
相关考题：
Which two commands are needed to create and apply an export policy that advertises static routes to OSPF neighbors?() A.edit policy-options policy-statement policy-name set term 1 from protocol static set term 1 then acceptB.edit ospf policy set from protocol static set 1 then acceptC.set protocols OSPF export policy-nameD.set protocols OSPF policy policy-name
Which command allows viewing of only OSPF routes?() A.show ip ospf routeB.show ip route protocol ospfC.show route protocol ospfD.show ospf table
Open Shortes t Path First (OSPF) is a routing protocol developed for Internet Protocol (IP) networks by the Interior Gateway Protocol (IGP) working group of the Internet Engineering Task Force (IETF).Which two statements best describe the OSPF link - state routing pro tocol?（）A. OSPF sends updates every 10 secondsB. OSPF sends triggered updates when a network change occursC. When a link state is changed, the router that detected the change creates a link - state advertisement (LSA) and propagates it to all OSPF devices using the 224.0.0.6 multicast addressD. OSPF sends summaries of individual link- state entries every 30 minutes to ensure LSDB synchronization
Which two characteristics apply to a CAS T1 interface?（）A、signaling travels in-band B、up to 24 voice channels C、up to 32 voice channels D、signaling travels in time slot 17 E、uses Q.931 signaling protocol in a common channel
Which of the following data structures exist on a router for the OSPF routing protocol？（）A、OSPF topology tableB、OSPF interface tableC、OSPF routing information baseD、OSPF link-state databaseE、OSPF adjacency tableF、OSPF neighbor table
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router
Open Shortes t Path First (OSPF) is a routing protocol developed for Internet Protocol (IP) networks by the Interior Gateway Protocol (IGP) working group of the Internet Engineering Task Force (IETF). Which two statements best describe the OSPF link - state routing pro tocol?（）A、OSPF sends updates every 10 secondsB、OSPF sends triggered updates when a network change occursC、When a link state is changed, the router that detected the change creates a link - state advertisement (LSA) and propagates it to all OSPF devices using the 224.0.0.6 multicast addressD、OSPF sends summaries of individual link- state entries every 30 minutes to ensure LSDB synchronization
Which two statements about route redistribution when implementing OSPF are true?（）A、Routes learned using any IP routing protocol can only be redistributed into non IP routing protocols.B、OSPF can import routes learned using EIGRP, RIP, and IS - IS.C、OSPF routes cannot be exported into EIGRP, RIP, an d IS - IS.D、At the interdomain level, OSPF cannot import routes learned using BGP.E、OSPF routes can be exported into BGP.
Which two statements are correct regarding default protocol preference values?（）A、RIP is preferred over OSPF external routes.B、Direct, local, and static routes have the same preference value.C、OSPF's preference value is lower than BGP.D、OSPF has a single preference value for both internal and external routes.
Which two items should you know when configuring OSPF to dynamically learn routes? （）(Choose two.)A、OSPF area IDB、OSPF neighbor addressC、OSPF loopback addressD、OSPF authentication type
Which two statements are correct regarding default protocol preference values?（）A、OSPF internal routes have a lower preference than static routes.B、Both direct and local routes have the same preference value.C、OSPF's preference value is lower than BGP.D、OSPF has a single preference value for both internal and external routes.
Which two characteristics describe the UDP protocol?（）A、limited error checkingB、defined timersC、no recovery mechanismsD、three-way handshake
What are three characteristics of the OSPF routing protocol?（）A、It converges quickly.B、OSPF is a classful routing protocol.C、It uses cost to determine the best route.D、It uses the DUAL algorithm to determine the best route.E、OSPF routers send the complete routing table to all directly attached routers.F、OSPF routers discover neighbors before exchanging routing information.
Which two are characteristics of the IS -IS protocol but not OSPF?（）A、forms adjacencies with all neighborsB、supports demand circuit routingC、provides routing support for multiple network layer protocolsD、utilizes SPF algorithmE、provides for network scalability by allowing the network to be separated into areasF、three layers of hierarchical routing
Which two of these are characteristics of the 802.1Q protocol?（）A、it is a layer 2 messaging protocol which maintains vlan configurations across network.B、it includes an 8-bit field which specifies the priority of a frame.C、it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.D、it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.E、it is a trunking protocol capable of carring untagged frames.
Which two are NOT characteristics of the OSPF routing protocol?（）A、It confines network instability to a single area of network.B、It increases the routing overhead of the networkC、It supports VLSMD、It routes between Autonomous Systems.E、It allows extensive control of routing updates
Which two statements are correct regarding the default protocol preference values? （）A、RIP is preferred over OSPF external routesB、Direct, local and static routes have the same preference valueC、OSPF's preference value is lower than BGPD、OSPF has a single preference value for both internal and external routes
Which command allows viewing of only OSPF routes?（）A、show ip ospf routeB、show ip route protocol ospfC、show route protocol ospfD、show ospf table
多选题Which two commands are needed to create and apply an export policy that advertises static routes to OSPF neighbors?（）Aedit policy-options policy-statement policy-name set term 1 from protocol static set term 1 then acceptBedit ospf policy set from protocol static set 1 then acceptCset protocols OSPF export policy-nameDset protocols OSPF policy policy-name
多选题Which two are characteristics of the IS -IS protocol but not OSPF?（）Aforms adjacencies with all neighborsBsupports demand circuit routingCprovides routing support for multiple network layer protocolsDutilizes SPF algorithmEprovides for network scalability by allowing the network to be separated into areasFthree layers of hierarchical routing
多选题Which two statements are characteristics of a distance vector routing protocol?（）ARIP is an example of distance vector routing protocolsBUpdates are periodic and include the entire routing tableCRouting updates are sent only after topology changesDThe protocol can be useful in hub-and-spoke and hierarchical networksEConvergence is usually faster than with link state protocolsFEach router has its own view of the topology
多选题Which two characteristics apply to a CAS T1 interface?（）Asignaling travels in-bandBup to 24 voice channelsCup to 32 voice channelsDsignaling travels in time slot 17Euses Q.931 signaling protocol in a common channel
多选题Which two of these are characteristics of the 802.1Q protocol?（）Ait is a layer 2 messaging protocol which maintains vlan configurations across network.Bit includes an 8-bit field which specifies the priority of a frame.Cit is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.Dit modifies the 802.3 frame header,and thus requires that the FCS be recomputed.Eit is a trunking protocol capable of carring untagged frames.
多选题Which two commands would you use to view OSPF routes?（）Ashow ip route ospfBshow ospf routesCshow route protocol ospfDshow route
多选题Which two are NOT characteristics of the OSPF routing protocol?（）AIt confines network instability to a single area of network.BIt increases the routing overhead of the networkCIt supports VLSMDIt routes between Autonomous Systems.EIt allows extensive control of routing updates
多选题Which two characteristics describe the UDP protocol?（）Alimited error checkingBdefined timersCno recovery mechanismsDthree-way handshake
单选题A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）AFor the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.BFor the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.CDirect inter-vlan communication does not require OSPFDOSPF cannot be used if router-on-a-stick is configured on the router