多选题Which two characteristics apply to a CAS T1 interface?（）Asignaling travels in-bandBup to 24 voice channelsCup to 32 voice channelsDsignaling travels in time slot 17Euses Q.931 signaling protocol in a common channel
多选题
Which two characteristics apply to a CAS T1 interface?（）
A
signaling travels in-band
B
up to 24 voice channels
C
up to 32 voice channels
D
signaling travels in time slot 17
E
uses Q.931 signaling protocol in a common channel
参考解析
解析：
暂无解析
相关考题：
Which of the following commands would be applied to a WAN interface, but not on LAN Interface? (Choose all that apply)A. IP addressB. encapsulation PPPC. no shutdownD. authentication CHAPE. SpeedF. None of the above
You would like to configure an Ethernet interface with the following characteristics:Which set of configuration commands accurately completes this task?() A.AB.BC.CD.D
Which IBM tape interface architecture has the best performance and distance characteristics? () A.SASB.SCSIC.ESCOND.Fibre Channel
Which two of these are characteristics of an IPS device?() A. passively listens to network trafficB. is an active device in the traffic pathC. has a permissive interface that is used to monitor networksD. traffic arrives on one IPS interface and exits on another
Which two statements describe characteristics of IPv6 unicast addressing?() A. Global addresses start with 2000::/3.B. Link-local addresses start with FE00:/12.C. Link-local addresses start with FF00::/10.D. There is only one loopback address and it is ::1.E. If a global address is assigned to an interface, then that is the only allowable address for the interface.
Which two characteristics apply to a CAS T1 interface?（）A、signaling travels in-band B、up to 24 voice channels C、up to 32 voice channels D、signaling travels in time slot 17 E、uses Q.931 signaling protocol in a common channel
Which two of these are characteristics of an IPS device？（）A、 passively listens to network trafficB、 is an active device in the traffic pathC、 has a permissive interface that is used to monitor networksD、 traffic arrives on one IPS interface and exits on another
Which two characteristics apply to Cisco Catalyst 6500 Series Switch supervisor redundancy using NSF？（）A、 independent of SSOB、 NSF combined with SSO enables supervisor engine load balancingC、 supported by RIPv2， OSPF， IS-IS， and EIGRPD、 supports IPv4 and IPv6 multicastE、 prevents route flappingF、 dependent on FIB tables
You want to implement a high availability network using two Cisco routers. You also want to ensure that the stat of the WAN interfaces can be tracked in doing so. Which router redundancy protocol cannot be configured for interface tracking？ （）A、 GLBPB、 HSRPC、 RPRD、 VRRPE、 SLBF、 RPR+G、 None of the other alternatives apply
Which of the following characteristics are true assuming you are troubleshooting a networkcurrently enabled for VRRP？（Choose all that apply.）（）A、The network is load balancing among different members of the VRRP groupB、The default hello timers are 1 secondC、The interface IP address is being used as the virtual IP addressD、There are several routers in the group simultaneously forwarding traffic for the groupE、It is a Cisco Proprietary protocolF、The default hello timers are 3 seconds
Two switches are connected through a trunk link.which two commands show that there is a native VLAN mismatch on that link？（）A、show interfaces interfaceB、show vlan briefC、show interfaces interface switchportD、show interface interface trunkE、show interfaces vlan
Which two statements describe characteristics of IPv6 unicast addressing?（）A、Global addresses start with 2000::/3.B、Link-local addresses start with FE00:/12.C、Link-local addresses start with FF00::/10.D、There is only one loopback address and it is ::1.E、If a global address is assigned to an interface, then that is the only allowable address for the interface.
Cisco IDS sensors form the eyes and ears of your Cisco network intrusion detection system. Placing sensors correctly throughout your network is crucial to successfully implementing your Cisco intrusion detection system .Which two of these are characteristics of an IDS sensor？（）A、 has a permissive interface that is used to monitor networksB、 is an active device in the traffic pathC、 passively listens to network trafficD、 has a promiscuous interface that is used to monitor the network
Which IBM tape interface architecture has the best performance and distance characteristics? （）A、SASB、SCSIC、ESCOND、Fibre Channel
Which two are characteristics of the Transfer Object design pattern？（）A、It reduces network traffic by collapsing multiple remote requests into one.B、It increases the complexity of the remote interface by removing coarse-grained methods.C、It increases the complexity of the design due to remote synchronization and version control issues.D、It increases network performance introducing multiple fine-grained remote requests which return verysmall amounts of data.
多选题Two switches are connected through a trunk link.which two commands show that there is a native VLAN mismatch on that link？（）Ashow interfaces interfaceBshow vlan briefCshow interfaces interface switchportDshow interface interface trunkEshow interfaces vlan
多选题Which two characteristics apply to Cisco Catalyst 6500 Series Switch supervisor redundancy using NSF？（）Aindependent of SSOBNSF combined with SSO enables supervisor engine load balancingCsupported by RIPv2， OSPF， IS-IS， and EIGRPDsupports IPv4 and IPv6 multicastEprevents route flappingFdependent on FIB tables
多选题Which two of these are characteristics of an IDS sensor？（）Apassively listens to network trafficBis an active device in the traffic pathChas a permissive interface that is used to monitor networksDtraffic arrives on one IDS interface and exits on anotherEhas a promiscuous interface that is used to monitor the network
多选题Which of the following characteristics are true assuming you are troubleshooting a networkcurrently enabled for VRRP？（Choose all that apply.）（）AThe network is load balancing among different members of the VRRP groupBThe default hello timers are 1 secondCThe interface IP address is being used as the virtual IP addressDThere are several routers in the group simultaneously forwarding traffic for the groupEIt is a Cisco Proprietary protocolFThe default hello timers are 3 seconds
单选题You need to control SSH. HTTP, and Telnet access to an MX240 router through any interface. You have decided to use a firewall filter. How should you apply the firewall filter?（）Aas an outbound filter on interface fxp0Bas an outbound filter on interface lo0Cas an inbound filter on interface fxp0Das an inbound filter on interface lo0
多选题Which two characteristics apply to Cisco Catalyst 6500 Series Switch supervisor redundancyusing NSF？（）Aindependent of SSOBNSF combined with SSO enables supervisor engine load balancingCsupported by RIPv2， OSPF， IS-IS， and EIGRPDsupports IPv4 and IPv6 multicastEprevents route flappingFdependent on FIB tables
多选题Which two are characteristics of the Transfer Object design pattern？（）AIt reduces network traffic by collapsing multiple remote requests into one.BIt increases the complexity of the remote interface by removing coarse-grained methods.CIt increases the complexity of the design due to remote synchronization and version control issues.DIt increases network performance introducing multiple fine-grained remote requests which return verysmall amounts of data.
多选题Which two of these are characteristics of an IPS device?（）Apassively listens to network trafficBis an active device in the traffic pathChas a permissive interface that is used to monitor networksDtraffic arrives on one IPS interface and exits on another
单选题You need to control SSH, HTTP, and Telnet access to an MX240 router through any interface.You have decided to use a firewall filter. How should you apply the firewall filter?（）Aas an outbound filter on interface fxp0Bas an outbound filter on interface lo0Cas an inbound filter on interface fxp0Das an inbound filter on interface lo0
单选题Which port state is interface Fa0/2 of switch 2 in for VLANs 1 and 160？ （）AListeningBLearningCDisabledDBlockingEForwardingFDiscardingGNone of the other alternatives apply