Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? （）A、All ports will be in a state of discarding, learning, or forwarding.B、Thirty VLANs have been configured on this switch.C、The bridge priority is lower than the default value for spanning tree.D、All interfaces that are shown are on shared media.E、All designated ports are in a forwarding state.F、The switch must be the root bridge for all VLANs on this switch.
Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? （）
- A、All ports will be in a state of discarding, learning, or forwarding.
- B、Thirty VLANs have been configured on this switch.
- C、The bridge priority is lower than the default value for spanning tree.
- D、All interfaces that are shown are on shared media.
- E、All designated ports are in a forwarding state.
- F、The switch must be the root bridge for all VLANs on this switch.
相关考题：
Refer to the exhibit. Which of the following statements is true? () A. BGP NSF awareness is enabledB. SSO for BGP NSF capability is enabledC. BGP graceful restart awareness is enabledD. 10.11.1.187 is configured as an NSF-capable BGP neighbor
Refer to the exhibit. This shows the NetFlow statistics for a router. You are analyzing the traffic pattern and you are interested in the percentage of packets between 32 and 64 bytes in size and the number of flows in progress. Which of these identifies both numbers correctly?（）A. 69.4%, 4061B. 24.9%, 980C. 69.4%, 35D. 6.94%, 980E. cannot be determined from this output
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B
Refer to the exhibit. Which command would verify if PBR reacts to packets sourced from 172.16.0.0／16?() A. show ip routeB. show policy - mapC. show access - listsD. show route - map
Refer to the exhibit. Based on this command output, what can we conclude about R3?() A. R3 is an ABR.B. R3 is not connec ted to the backbone.C. R3 has four neighbors.D. R3 is the DR for area 2.
Refer to the parti al configurations in the exhibit. What address is utilized for DR and BDR identification on Router1?() A. the serial 1/1 addressB. the serial 2/0 addressC. a randomly generated internal addressD. the configured router - id address
Refer to the output. What IOS command produces this output?() A. show i p ospfB. show ip ospf interfaceC. show ipv6 ospf interfaceD. show ipv6 ospf
Refer to the exhibit. Router R1 is connected to networks 172.1 6.1.0 ／26 and 172.16.1.64 ／27. On the basis of the partial output in the exhibit, which statement is true? () A. Router R1 will deny the 172.16.1.0/26 route while permitting the 172.16.1.64/27 route to be advertised.B. Router R1 will advertise both rou tes.C. Router R1 should be reconfigured with an ACL instead of an ip prefix - list command.D. Router R1 will deny the 172.16.1.0/27 route while permitting the 172.16.1.0/26 route to be advertised.
Refer to the exhibit. What is the most appropriate summarization for these routes?() A.10.0.0.0/21B.10.0.0.0/22C.10.0.0.0/23D.10.0.0.0/24
Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?() A.255.255.255.0B.255.255.254.0C.255.255.252.0D.255.255.248.0
Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?() A.data link layerB.application layerC.access layerD.session layerE.network layer
Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?() A.Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500.B.Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes.C.Theminimumpacketsizethatcantraversethisinterfaceis1500bytes.D.Themaximumpacketsizethatcantraversethisinterfaceis1500bytes.E.Themaximumframesizethatcantraversethisinterfaceis1500bytes.
Refer to the exhibit. What does the (*) represent in the output?() A.Packet is destined for a local interface to the router.B.Packet was translated, but no response was received from the distant device.C.Packet was not translated, because no additional ports are available.D.Packet was translated and fast switched to the destination.
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?() A.10.0.0.0B.10.0.0.254C.192.223.129.0D.192.223.129.254
Refer to the exhibit. What are three of the basic components of a VoIP network？（）A、software voice applicationsB、multipoint control unit （MCU） C、gatekeeper D、call agentE、interactive voice response （IVR） systems F、softphones
Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）A、The Serial0/0 interface is passing traffic.B、The DLCI 100 was dynamically allocated by the routerC、The Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP serverD、The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloudE、The mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
Refer to the exhibit. What is the configuration an example of？（）A、enabling modular QoS over Frame RelayB、enabling Real-Time Transport Protocol （RTP） header compressionC、enabling distributed compressed Transmission Control ProtocolD、enabling latency and jitter reduction for Transmission Control trafficE、enabling TCP header compression
单选题Refer to the exhibit. What is the meaning of the output MTU 1500 bytes?（）A Themaximumnumberofbytesthatcantraversethisinterfacepersecondis1500.B Theminimumsegmentsizethatcantraversethisinterfaceis1500bytes.C Theminimumpacketsizethatcantraversethisinterfaceis1500bytes.D Themaximumpacketsizethatcantraversethisinterfaceis1500bytes.E Themaximumframesizethatcantraversethisinterfaceis1500bytes.
单选题Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this RouterD?（）A 10.1.1.2B 10.154.154.1C 172.16.5.1D 192.168.5.3
单选题Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）A data link layerB application layerC access layerD session layerE network layer
单选题Refer to the exhibit. Which statement is correct based on the show login command output shown？（）AWhen the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.BThe login block-for command is configured to block login hosts for 93 seconds.CAll logins from any sources are blocked for another 193 seconds.DThree or more login requests have failed within the last 100 seconds.
单选题Refer to the exhibit. What is the configuration an example of？（）Aenabling modular QoS over Frame RelayBenabling Real-Time Transport Protocol （RTP） header compressionCenabling distributed compressed Transmission Control ProtocolDenabling latency and jitter reduction for Transmission Control trafficEenabling TCP header compression
多选题Refer to the exhibit. Which two statements are correct？（）AAll six routes will be installed in the routing tableBTwo routes will be installed in the routing tableCFour routes will be installed in the routing tableDAll the routes were redistributed into BGP from an IGPEAll the routes were originated by BGP with the network command
单选题Refer to the exhibit. What switch proves the spanning-tree designated port role for the network segment that services the printers?（）A Switch1B Switch2C Switch3D Switch4
单选题Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown?（）AThe Serial0/0 interface is passing traffic.BThe DLCI 100 was dynamically allocated by the routerCThe Serial0/0 interface acquired the IP address of 172.16.3.1 from a DHCP serverDThe DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloudEThe mapping between DLCI 100 and the end station IP address 172.16.3.1 was learned through Inverse ARP
多选题Refer to the exhibit. On the basis of the information in the exhibit， which two statements are true？（）AWhen traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose2 because of the higher MED value of SanJose2BThe serial 0/0/1 interface on the ISP router has been configured with the set metric 50commandCThe output was generated by entering the show ip bgp command on the SanJose1 routerDThe output was generated by entering the show ip bgp command on the ISP routerEThe serial 0/0/1 interface on the ISP router has been configured with the set metric 75commandFWhen traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose1 because of the lower MED value of SanJose1
多选题Refer to the exhibit. What are three of the basic components of a VoIP network？（）Asoftware voice applicationsBmultipoint control unit （MCU）CgatekeeperDcall agentEinteractive voice response （IVR） systemsFsoftphones