单选题The rusty plates should be wiped clean before paint is （）.AappliedBsuppliedCplacedDwatered
单选题
The rusty plates should be wiped clean before paint is （）.
A
applied
B
supplied
C
placed
D
watered
参考解析
解析：
暂无解析
相关考题：
When checking zinc plates in the refrigerating system condenser, you shouldA.paint and insulate the plates to prevent corrosionB.renew the plates at each inspectionC.replace the zincs if deteriorated by 50%D.file the plates to change the negative value
The patches where rust have been removed should be wiped clean before paint is ______.A.appliedB.suppliedC.repliedD.complied
Before any machinery is put in operation，you should ______.A.ventilate all compartments，see that the machinery is clean and there are no obstructionsB.just turn the key and start upC.take for granted that there are no fuel leaksD.assume there are no volatile fumes in the engine space
The rubbish should be collected on the poop deck and （）(处理) 25 miles off the shore.A、made up ofB、disposed ofC、worked outD、wiped out
Which of the following should be performed after a maintenance kit has been applied and fullfunctionality tested?（）A、Roller regenerator appliedB、Page count resetC、New network settings appliedD、Printer drum replacement
The rusty plates should be scrapped and brushed to （）(出白金属).A、cleanB、smooth surfaceC、bare metalD、clear
稀料能稀释油漆。（）A、The thinner can thin down paint.B、The thinner can clean.C、The thinner isn’t the paint.D、The thinner is the paint.
清扫艏艉甲板，准备出海。（）A、Repair fore and aft decks and prepare for sea.B、Clean up lower deck and prepare for sea.C、Clean up fore and aft decks and prepare for sea.D、Paint fore and aft decks and prepare for sea.
Which of the following should a technician use to clean the glass on a flatbed scanner？（）A、glass cleaner and paper towelsB、dish soap and a wet towelC、a soft， pre-moistened towel or wipeD、dry paper towels
Which of the following should be done FIRST to a hard drive before it is disposed?（）A、PartitionB、Physical damageC、Data wipeD、Format
Which of these recommendations should be followed before capturing a workload？（）A、 Make sure your replay database has the same structure as the capture database， except without data.B、 Make sure the replay and capture databases are similar in data content.C、 Perform a clean shutdown and restart of the capture database before beginning a workload capture.D、 Start the capture database in UNRESTRICTED mode， then start the capture.E、 Define inclusion and exclusion filters.
单选题Before charging a refrigeration unit, the refrigerant charging lines should be（）Aflushed with clean refrigerant oilBpurged with the refrigerantCwashed with an ammonia and alcohol solutionDgrounded to compressor
单选题Before the oily water separator put into operation, it should be （）Afilled with bilge waterBfilled with oilCfilled with clean waterDbe emptied
单选题稀料能稀释油漆。（）AThe thinner can thin down paint.BThe thinner can clean.CThe thinner isn’t the paint.DThe thinner is the paint.
单选题Before any machinery is put in operation，you should（）.Aventilate all compartments，see that the machinery is clean and there are no obstructionsBjust turn the key and start upCtake for granted that there are no fuel leaksDassume there are no volatile fumes in the engine space
单选题The patches where rust have been removed should be wiped clean before paint is（）.AappliedBsuppliedCrepliedDcomplied
单选题Bales close to the deckhead should be covered to prevent（）.Adamage by dripping sweatBdamage by odor contaminationCfrom striking structureDfrom steel rusty
单选题Dirty oil must be （） before being used again.Amixed with clean oilBpurifiedCheatedDstrained