Before engaging the turning gear and turning the diesel engine, which of the following operation should be done except______.A.open the indicator cocksB.supply some CYL.Oil to cylinder liner wall with lubricator (only for two stoke diesel engine)C.put the fuel handle in the "stop" positionD.pump up the air bottle

Before engaging the turning gear and turning the diesel engine, which of the following operation should be done except______.

A.open the indicator cocks

B.supply some CYL.Oil to cylinder liner wall with lubricator (only for two stoke diesel engine)

C.put the fuel handle in the "stop" position

D.pump up the air bottle


相关考题:

[A] turning [B] tuning [C] tucking [D] tugging

Therehasbeenacollision___anumberofcarsonthemainroadtotown.A)composingB)consistingC)involvingD)engaging

You’re going to have a quiz ( )by another two in the ( )month. A. followed,followedB. followed,followingC. following,followedD. following,following

The effect of wind on exposed areas of the vessel is most noticeable when ______.A.backingB.going slow aheadC.going full aheadD.turning

I saw your man not operating the winch gear ______ gear.A.inB.byC.ofD.against

GEAR路由协议不适合在移动WSN使用。

在UG NX10中,对零件模型进行平面铣加工编程应选择()。A.mill_planarB.mill_contourC.drillD.turning

UG常用的CAM会话配置中通用加工配置是下列哪项?A.cam_generalB.cam_libraryC.hole_makingD.turning

在UG NX中,对零件模型进行平面铣加工编程应选择()。A.mill_planarB.mill_contourC.drillD.turning

UG常用的CAM会话配置中通用加工配置是下列哪项?()。A.cam_generalB.cam_libraryC.hole_makingD.turning