What are some of the characteristics of a typical VLAN arrangement, found throughout the Ezonexam switched LAN? (Select all that apply)A. VLANs logically divide a switch into multiple, independent switches at Layer 2.B. Trunk links can carry traffic for multiple VLANs.C. VLAN implementation significantly increases traffic due to added trunking information.D. A VLAN can span multiple switches.E. VLANs typically increase the number of switches neededF. VLANs typically decrease the number of switches needed
What are some of the characteristics of a typical VLAN arrangement, found throughout the Ezonexam switched LAN? (Select all that apply)
A. VLANs logically divide a switch into multiple, independent switches at Layer 2.
B. Trunk links can carry traffic for multiple VLANs.
C. VLAN implementation significantly increases traffic due to added trunking information.
D. A VLAN can span multiple switches.
E. VLANs typically increase the number of switches needed
F. VLANs typically decrease the number of switches needed
相关考题：
A new Ezonexam switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?A．All defined VLANs are allowed on the trunk by default.B．Each VLAN, or VLAN range, that is specified with the switchport mode command.C．Each VLAN, or VLAN range, that is specified with the vtp domain command.D．Each VLAN, or VLAN range, that is specified with the vlan database command.E．None of the above
There are 2 switches in the Ezonexam LAN, with no routers. Ports 1, 2 3 are assigned to VLAN 1 in switch 1 and 2 and ports 4, 5 6 are assigned to VLAN 2 in both switches. These two switches are connected together via a trunked link. Which of the conditions below would verify trunk and VLAN operation? (Select all valid answers)A．Host 1 on VLAN 1 can ping Host 2 on VLAN 1B．Host 1 on VLAN 1 can ping Host 4 on VLAN 2C．Host 1 on VLAN 1 can not ping Host 2 on VLAN 1D．Host 4 on VLAN 2 can not ping Host 1 on VLAN 1E．Host 4 on VLAN 2 can ping Host 2 on VLAN 2
A new trunk has been configured on a switch in the Ezonexam LAN. By default, which VLANs are allowed over this trunk link?A. No VLANsB. Only the VLANs that are specified when creating the trunkC. Only VLANs 1-64D. All VLANsE. All VLAN's except VLAN 1F. None of the above
What must the Ezonexam network administrator do in order to successfully configure a VLAN trunk between two switches named VE1 and VE2? (Select two answer choices)A. Set each end of the trunk line to IEEE 802.1Q encapsulation.B. Set the same VTP management domain name on both switches.C. Set all ports on the two switched as access ports.D. Configure one of the two switches as a VTP server.E. Connect the two switches using a rollover cable.F. Use a router to forward VTP traffic between the VLANs.
What are some characteristics of the typical VLAN arrangement?() A. VLANs logically divide a switch into multiple, independent switches at Layer 2.B. Trunk links can carry traffic for multiple VLANs.C. VLAN implementation significantly increases traffic due to added trunking information.D. A VLAN can span multiple switches.E. VLANs extend the collision domain to include multiple switches.F. VLANs typically decrease the number of multiple switches.
Which of the following can be an expected outcome of a VLAN?() A. VLANs logically divide a switch into multiple, independent switches at Layer 2.B. Trunk links can carry traffic for multiple VLANs.C. VLAN implementation significantly increases traffic due to added trunking information.D. VLANs can span multiple switches.E. VLANs typically decrease the number of switches needed
What must an administrator do in order to successfully configure a VLAN trunk between two switches?() A. Set each end of the trunk line to IEEE 802.1Q encapsulation.B. Set the same VTP management domain name on both switches.C. Set all ports on the two switched as access ports.D. Configure one of the two switches as a VTP server.E. Connect the two switches using a rollover cable.F. Use a router to forward VTP traffic between the VLANs.
A new switch is installed into an existing LAN and a new VTP trunk is set up with an existing switch. Which VLANs will be allowed on this new trunk?() A. All defined VLANs are allowed on the trunk by default.B. Each VLAN, or VLAN range, that is specified with the switchport mode command.C. Each VLAN, or VLAN range, that is specified with the vtp domain command.D. Each VLAN, or VLAN range, that is specified with the vlan database command.
What is the purpose of the cisco Vlan Trunking protocol?() A. to provide a mechanism to dynamically assign vlan membership to switch portsB. to allow traffic to be carried from multiple vlans over a single link between switchesC. to allow native vlan information to be carried over a trunk linkD. to provide a mechanism to manually assign vlan membership to switch portsE. to allow for managing the additions,deletions,and changes of vlans between switchs
Which three statements are typical characteristics of VLAN arrangements?() A. A new switch has no VLANs configured.B. Connectivity between VLANs requires a Layer 3 device.C. VLANs typically decrease the number of collision domains.D. Each VLAN uses a separate address space.E. A switch maintains a separate bridging table for each VLAN.F. VLANs cannot span multiple switches.
Refer to the exhibit.All switch ports are assigned to the correct VLANs, but none of the hosts connected to SwitchA can communicate with hosts in the same VLAN connected to SwitchB. Based on the output shown, what is the most likely problem?（）A.The access link needs to be configured in multiple VLANs.B.The link between the switches is configured in the wrong VLAN.C.The link between the switches needs to be configured as a trunk.D.VTP is not configured to carry VLAN information between the switches.E.Switch IP addresses must be configured in order for traffic to be forwarded between the switches
Which two statements about voice VLANs are correct？（）A、Voice VLANs eliminate the need for QoS configurationB、Voice VLANs are used on trunk links to eliminate the need for QoS CoS markingsC、Voice VLANs are mainly used to reduce the number of access switch ports that are used in the networkD、Voice VLANs can be configured to forward existing CoS priorities or override themE、Voice VLANs are mainly used between access layer switches and distribution layer switchesF、Voice VLANs can be configured on Layer 2 ports only
You have configured voice VLANs on Catalyst switch R1. Which two statements are true about the operation of voice VLANs on this device？ （）A、 When the voice VLAN feature is enabled， all untagged traffic is sent according to the default CoS priority of the port.B、 Enabling voice VLANs enables the switch to create multiple queues for traffic that is entering a port.C、 When voice VLANs are configured on a trunk link， UplinkFast must also be enabled.D、 Voice VLANs are configured to enable the switch to forward frames marked with the proper CoS values over separate physical links.E、 Enabling voice VLANs enables the switch to forward frames with a specific 802.1P marking.
What are some characteristics of the typical VLAN arrangement?（）A、VLANs logically divide a switch into multiple, independent switches at Layer 2.B、Trunk links can carry traffic for multiple VLANs.C、VLAN implementation significantly increases traffic due to added trunking information.D、A VLAN can span multiple switches.E、VLANs extend the collision domain to include multiple switches.F、VLANs typically decrease the number of multiple switches.
The DAI feature has been implemented in the Company switched LAN. Which three statements are true about the dynamic ARP inspection （DAI） feature？ （）A、 DAI can be performed on ingress ports only.B、 DAI can be performed on both ingress and egress ports.C、 DAI is supported on access ports， trunk ports， EtherChannel ports， and private VLAN ports. D、 DAI should be enabled on the root switch for particular VLANs only in order to secure the ARP caches of hosts in the domain.E、 DAI should be configured on all access switch ports as untrusted and on all switch ports connected to other switches as trusted.F、 DAI is supported on access and trunk ports only.
Which three statements are typical characteristics of VLAN arrangements?（）A、A new switch has no VLANs configured.B、Connectivity between VLANs requires a Layer 3 device.C、VLANs typically decrease the number of collision domains.D、Each VLAN uses a separate address space.E、A switch maintains a separate bridging table for each VLAN.F、VLANs cannot span multiple switches.
What must an administrator do in order to successfully configure a VLAN trunk between two switches?（）A、Set each end of the trunk line to IEEE 802.1Q encapsulation.B、Set the same VTP management domain name on both switches.C、Set all ports on the two switched as access ports.D、Configure one of the two switches as a VTP server.E、Connect the two switches using a rollover cable.F、Use a router to forward VTP traffic between the VLANs.
What are some of the characteristics of a typical VLAN arrangement?（）A、VLANs logically divide a switch into multiple, independent switches at Layer 2.B、Trunk links can carry traffic for multiple VLANs.C、VLAN implementation significantly increases traffic due to added trunking information.D、A VLAN can span multiple switches.E、VLANs typically increase the number of switches neededF、VLANs typically decrease the number of switches needed
Which of the following can be an expected outcome of a VLAN?（）A、VLANs logically divide a switch into multiple, independent switches at Layer 2.B、Trunk links can carry traffic for multiple VLANs.C、VLAN implementation significantly increases traffic due to added trunking information.D、VLANs can span multiple switches.E、VLANs typically decrease the number of switches needed
Switch R1 is configured to use the VLAN Trunking Protocol （VTP）. What does R1 advertise in its VTP domain？（）A、The VLAN ID of all known VLANs，the management domain name，and the total number of trunk links on the switch.B、The VLAN ID of all known VLANs，a 1-bit canonical format （CF1 Indicator），and the switch configuration revision number.C、The management domain name，the switch configuration revision number，the known VLANs， and their specific parameters.D、A 2-byte TPID with a fixed value of 0x8100 for the management domain number，the switch configuration revision number，the known VLANs，and their specific parameters.E、None of the other alternatives apply.
What is the purpose of the cisco Vlan Trunking protocol?（）A、to provide a mechanism to dynamically assign vlan membership to switch portsB、to allow traffic to be carried from multiple vlans over a single link between switchesC、to allow native vlan information to be carried over a trunk linkD、to provide a mechanism to manually assign vlan membership to switch portsE、to allow for managing the additions,deletions,and changes of vlans between switchs
多选题What are some of the characteristics of a typical VLAN arrangement?（）AVLANs logically divide a switch into multiple, independent switches at Layer 2.BTrunk links can carry traffic for multiple VLANs.CVLAN implementation significantly increases traffic due to added trunking information.DA VLAN can span multiple switches.EVLANs typically increase the number of switches neededFVLANs typically decrease the number of switches needed
多选题The DAI feature has been implemented in the Company switched LAN. Which three statements are true about the dynamic ARP inspection （DAI） feature？ （）ADAI can be performed on ingress ports only.BDAI can be performed on both ingress and egress ports.CDAI is supported on access ports， trunk ports， EtherChannel ports， and private VLAN ports.DDAI should be enabled on the root switch for particular VLANs only in order to secure the ARP caches of hosts in the domain.EDAI should be configured on all access switch ports as untrusted and on all switch ports connected to other switches as trusted.FDAI is supported on access and trunk ports only.
多选题What are some characteristics of the typical VLAN arrangement?（）AVLANs logically divide a switch into multiple, independent switches at Layer 2.BTrunk links can carry traffic for multiple VLANs.CVLAN implementation significantly increases traffic due to added trunking information.DA VLAN can span multiple switches.EVLANs extend the collision domain to include multiple switches.FVLANs typically decrease the number of multiple switches.
多选题Which three statements are typical characteristics of VLAN arrangements?（）AA new switch has no VLANs configured.BConnectivity between VLANs requires a Layer 3 device.CVLANs typically decrease the number of collision domains.DEach VLAN uses a separate address space.EA switch maintains a separate bridging table for each VLAN.FVLANs cannot span multiple switches.
多选题Which of the following can be an expected outcome of a VLAN?（）AVLANs logically divide a switch into multiple, independent switches at Layer 2.BTrunk links can carry traffic for multiple VLANs.CVLAN implementation significantly increases traffic due to added trunking information.DVLANs can span multiple switches.EVLANs typically decrease the number of switches needed
单选题What is the purpose of the cisco Vlan Trunking protocol？（）Ato provide a mechanism to dynamically assign vlan membership to switch portsBto allow traffic to be carried from multiple vlans over a single link between switchesCto allow native vlan information to be carried over a trunk linkDto provide a mechanism to manually assign vlan membership to switch portsEto allow for managing the additions，deletions，and changes of vlans between switchs