A technician needs to install additional access points for a new high speed connection being added in the new office space. Which of the following will MOST likely be installed to allow additional CAT5 cable connections?（）A、Smart JackB、DemarcC、110 BlockD、66 Block
A technician needs to install additional access points for a new high speed connection being added in the new office space. Which of the following will MOST likely be installed to allow additional CAT5 cable connections?（）
- A、Smart Jack
- B、Demarc
- C、110 Block
- D、66 Block
相关考题：
Mike, a technician, is replacing a wireless router on an existing small office home office (SOHO) network. The SSID, WPA and DHCP information has been correctly added. Which of the following must also be addressed?（）A. The administrative password needs to be changed.B. The TKIP option needs to be enabled.C. The WEP key needs to be changed.D. Wireless access points need to be added.
The network administrator has just finished installing a new 10/100/1000 switch, but receives reports from the server administrator that servers connected to the new switch seem to be experiencing slow LAN connections. The network administrator checks the port connecting the new switch to the core switch and sees the following information:Which of the following is the MOST likely cause of the slow connections?（）A. The servers have not had VLAN tagging enabled on their NICs.B. Speed and duplex have not been set.C. VLAN tagging was not set on the trunk.D. The servers have been connected with CAT5 cable.
A technician needs to install additional access points for a new high speed connection being added in the new office space. Which of the following will MOST likely be installed to allow additional CAT5 cable connections?（）A. Smart JackB. DemarcC. 110 BlockD. 66 Block
A technician installs an additional hard drive controller. Which of the following processes will MOST likely prevent errors? () A.B.C.D.
A technician temporarily needs an additional network connection in their office to test a newworkstation. Which of the following is the BEST solution to add a temporary network connection?() A. Install a small network switchB. Use port mirroring on the switchC. Split the pairs of the existing jackD. Install a CSU/DSU
A new floppy drive was just installed into a PC. The drive powers on at system boot but the status LED does not turn off during operation. Which of the following is MOST likely the issue?（）A、The power cable was installed incorrectly and needs to be flipped.B、The floppy drive was not enabled within the motherboard’s BIOS.C、The FDD cable was installed incorrectly and needs to be flipped.D、A Molex power cable was used instead of a Berg cable.
A client needs to be able to install a new local printer, but does not currently have permission to do so. Which of the following is the BEST user group to put the client in, to allow the printer to be installed?（）A、Power UsersB、UsersC、Backup UsersD、Guest
A technician is trying to install a previous-generation expansion card into their new laptop.However, the card refuses to fit into the expansion slot. Which of the following is MOST likely the reason?（）A、The card needs to have the compatibility jumpers set before it can be installed into the system.B、The card is a PCI Express card and the laptop supports pcmica.C、The expansion slot needs to be enabled in theblos first.D、The card is a PCMCIA card and the laptop supports PCI Express cards.
A new department is formed and a new section of the building is being built out for them. All 50 new employees will need access to the wireless network. Which of the following should be completed to allow these new employees access to the wireless network?（）A、Frequency settings should be changedB、Additional WAPs should be installedC、Channels should be changedD、VLANs should be added
A technician is performing a memory upgrade by installing an additional 1GB stick of DDR RAM into a system. When the installation is complete, the computer shows 2GB of RAM at POST; however, it now indicates a lower speed setting for the memory. Which of the following is the MOST likely cause?（）A、The newly installed RAM has a lower clock speed than the existing RAM.B、The CPU is not configured to work with the additional RAM.C、The system is incompatible with the new RAM.D、The new RAM is of lower quality, and not dependable at higher speeds.
After a technician came out and installed a new wireless router, one of the wired workstations began having problems connecting to the file server. This is only an intermittent problem. Which of the following actions will the technician MOST likely perform to resolve this problem?（）A、Change the router's SSIDB、Move the router's locationC、Check user permissionsD、Check the cable ends
A network administrator needs to add an additional connection to a room. The administrator adds a new Ethernet switch and must connect it to an existing switch. Which cable type should be used to connect the two switches?（）A、CAT3 cableB、Serial cableC、Crossover cableD、Rollover cable
A technician wants to use an existing DHCP server for three additional VLANs. Which of the following features needs to be configured to allow for this addition?（）A、DHCP serverB、Proxy serverC、RepeaterD、DHCP relay
A technician has just installed a new power supply into a desktop computer and now the computer will not turn on. Which of the following is the MOST likely cause?（）A、The voltage selector switch on the power supply is set incorrectly.B、The 3.3v power line is connected to the wrong input on the motherboard.C、The new power supply voltage rating is too high.D、The 12v power cord is installed incorrectly.
Mike, a technician, is replacing a wireless router on an existing small office home office (SOHO) network. The SSID, WPA and DHCP information has been correctly added. Which of the following must also be addressed?（）A、The administrative password needs to be changed.B、The TKIP option needs to be enabled.C、The WEP key needs to be changed.D、Wireless access points need to be added.
After testing a new 100BaseTX cable, the technician determines that only pairs 4, 5, 7, and 8 are straight-thru wires. Which of the following MOST likely describes this cable type?（）A、Crossover cable with open pairsB、Crossover cableC、Rollover cableD、Straight-thru cable with open pairs
A technician installed a new video card on a motherboard which has onboard video. When the monitor was plugged into the new card and the power was turned on, a no signal message appeared on the monitor. Which of the following is MOST likely the issue?（）A、In the BIOS, the onboard video adapter must be disabled.B、The video resolution is set too high.C、The LCD panel is defective.D、The drivers for the new video card must be installed before installing the card.
A technician temporarily needs an additional network connection in their office to test a newworkstation. Which of the following is the BEST solution to add a temporary network connection?（）A、Install a small network switchB、Use port mirroring on the switchC、Split the pairs of the existing jackD、Install a CSU/DSU
A server in the production environment monitors output from various sensors along an assembly line.New equipment is being added to the line that will require monitoring.The server administrator needs to add additional inputs to the server for this new equipment. Which of the following input types is MOST likely required？（）A、EIDEB、SATAC、SerialD、Video
单选题A technician is performing a memory upgrade by installing an additional 1GB stick of DDR RAM into a system. When the installation is complete, the computer shows 2GB of RAM at POST; however, it now indicates a lower speed setting for the memory. Which of the following is the MOST likely cause?（）AThe newly installed RAM has a lower clock speed than the existing RAM.BThe CPU is not configured to work with the additional RAM.CThe system is incompatible with the new RAM.DThe new RAM is of lower quality, and not dependable at higher speeds.
单选题A technician needs to install additional access points for a new high speed connection being added in the new office space. Which of the following will MOST likely be installed to allow additional CAT5 cable connections?（）ASmart JackBDemarcC110 BlockD66 Block
单选题A technician installed a new video card on a motherboard which has onboard video. When the monitor was plugged into the new card and the power was turned on, a no signal message appeared on the monitor. Which of the following is MOST likely the issue?（）AIn the BIOS, the onboard video adapter must be disabled.BThe video resolution is set too high.CThe LCD panel is defective.DThe drivers for the new video card must be installed before installing the card.
单选题A new department is formed and a new section of the building is being built out for them. All 50 new employees will need access to the wireless network. Which of the following should be completed to allow these new employees access to the wireless network?（）AFrequency settings should be changedBAdditional WAPs should be installedCChannels should be changedDVLANs should be added
单选题A technician temporarily needs an additional network connection in their office to test a newworkstation. Which of the following is the BEST solution to add a temporary network connection?（）AInstall a small network switchBUse port mirroring on the switchCSplit the pairs of the existing jackDInstall a CSU/DSU
单选题A technician has just installed a new power supply into a desktop computer and now the computer will not turn on. Which of the following is the MOST likely cause?（）AThe voltage selector switch on the power supply is set incorrectly.BThe 3.3v power line is connected to the wrong input on the motherboard.CThe new power supply voltage rating is too high.DThe 12v power cord is installed incorrectly.
单选题Mike, a technician, is replacing a wireless router on an existing small office home office (SOHO) network. The SSID, WPA and DHCP information has been correctly added. Which of the following must also be addressed?（）AThe administrative password needs to be changed.BThe TKIP option needs to be enabled.CThe WEP key needs to be changed.DWireless access points need to be added.
单选题A new floppy drive was just installed into a PC. The drive powers on at system boot but the status LED does not turn off during operation. Which of the following is MOST likely the issue?（）AThe power cable was installed incorrectly and needs to be flipped.BThe floppy drive was not enabled within the motherboard’s BIOS.CThe FDD cable was installed incorrectly and needs to be flipped.DA Molex power cable was used instead of a Berg cable.