单选题A new floppy drive was just installed into a PC. The drive powers on at system boot but the status LED does not turn off during operation. Which of the following is MOST likely the issue?（）AThe power cable was installed incorrectly and needs to be flipped.BThe floppy drive was not enabled within the motherboard’s BIOS.CThe FDD cable was installed incorrectly and needs to be flipped.DA Molex power cable was used instead of a Berg cable.
单选题
A new floppy drive was just installed into a PC. The drive powers on at system boot but the status LED does not turn off during operation. Which of the following is MOST likely the issue?（）
A
The power cable was installed incorrectly and needs to be flipped.
B
The floppy drive was not enabled within the motherboard’s BIOS.
C
The FDD cable was installed incorrectly and needs to be flipped.
D
A Molex power cable was used instead of a Berg cable.
参考解析
解析：
暂无解析
相关考题：
A new floppy drive was just installed into a PC. The drive powers on at system boot but the status LED does not turn off during operation. Which of the following is MOST likely the issue?（）A、The power cable was installed incorrectly and needs to be flipped.B、The floppy drive was not enabled within the motherboard’s BIOS.C、The FDD cable was installed incorrectly and needs to be flipped.D、A Molex power cable was used instead of a Berg cable.
When Bob, a technician, powers up a desktop PC, the unit will repeat three short beeps and will not POST. Which of the following is MOST likely the problem?（）A、The memory is failing.B、The CPU is overheating.C、The hard drive is not attached properly.D、The operating system is not installed.
After installing the Windows operating system, Device Manager shows a number of devices with a yellow question mark next to them. Which of the following is the MOST likely reason?（）A、The latest service pack needs to be installed.B、The created hard drive partition is not large enough.C、The motherboard chipset driver needs to be installed.D、The processor does not support the Windows OS.
A user installed a Blu-Ray drive in their PC. The user reports that the new drive and their existing DVD-RW drive are not operating. Which of the following needs to be replaced?（）A、Power supplyB、DVD-RWC、Blu-Ray driveD、Motherboard
A user reports that after configuring the BIOS to boot to the hard drive first, the system still tries to boot from the optical drive. Which of the following is the MOST likely cause?（）A、Optical driveB、Power supplyC、CMOS batteryD、CD-ROM disk
A customer reports to Karen, a technician, that he is experiencing problems with the display after his computer is fully booted but reports seeing the BIOS splash screen during boot. Which of the following would MOST likely be the cause?（）A、The video cable is incorrectly attached.B、A corrupted or incorrect video driver is installed.C、An incorrect video card is installed in the computer.D、The video card is defective and needs to be replaced.
A technician has just installed a new power supply into a desktop computer and now the computer will not turn on. Which of the following is the MOST likely cause?（）A、The voltage selector switch on the power supply is set incorrectly.B、The 3.3v power line is connected to the wrong input on the motherboard.C、The new power supply voltage rating is too high.D、The 12v power cord is installed incorrectly.
A computer has been upgraded with a new hard drive and after reassembling the computer and turning the computer on， the drive LED remains lit and an error message during power-on self test （POST） states， ’No Drive Present.’ Which of the following would MOST likely be the cause？（）A、The motherboard was damaged and needs replacing.B、The floppy drive was not reconnected.C、A configuration disk was left in the floppy drive.D、The ribbon cable has been installed incorrectly.
Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?（）A、The new drive’s jumper is set for master.B、The new drive is connected to the secondary bus as a slave drive.C、Both drives’ jumpers are set for cable select.D、The old drive’s jumper is set for master and the new drive is set for slave.
A floppy drive is replaced in a computer and now when the computer is turned on the floppy drive light is constantly lit. Which of the following is the MOST likely cause?（）A、The power supply has failed.B、The drive cable is connected backwards.C、The floppy drive has failed.D、The proper drivers have not been loaded.
A newly installed floppy drive activity light stays on. Which of the following is the MOST likely problem?（）A、The computer does not support this type of drive.B、Connector is plugged in backwards.C、Power is plugged in backwards.D、All floppies are corrupt.
When attempting to boot a PC, the POST process completes without error. The PC then displays,‘non system disk or disk error’. Which of the following would MOST likely cause the issue?（）A、Out-of-date BIOSB、Invalid motherboard jumper settingsC、Failing power supplyD、Floppy disk in the drive
A defective CD-ROM drive is replaced with a new CD-ROM drive. The new CD-ROM drive is able to read any CD that it accesses， but music CDs do not play music. What is the MOST likely cause of this problem？（）A、The audio cable is not connected to the drive.B、The ribbon cable is not connected.C、The power cable is not connected.D、The CD-ROM drivers are not installed.
An administrator reboots a ten drive server, with a RAID 10 array, after a power failure and receives an error logical drive failed. Which of the following is the MOST likely cause?（）A、Corrupt file system tableB、Backplane failureC、Multiple drive failureD、Bad cable
A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem？（）A、Windows cannot be booted from a controller card.B、The hard drive must have Windows reinstalled because a new controller card was installed.C、The SATA controller card was not set as a boot device in the computer BIOS.D、The new controller must have the correct jumper settings for Windows mode.
单选题A newly installed floppy drive activity light stays on. Which of the following is the MOST likely problem?（）AThe computer does not support this type of drive.BConnector is plugged in backwards.CPower is plugged in backwards.DAll floppies are corrupt.
单选题A computer has been upgraded with a new hard drive and after reassembling the computer and turning the computer on， the drive LED remains lit and an error message during power-on self test （POST） states， ’No Drive Present.’ Which of the following would MOST likely be the cause？（）AThe motherboard was damaged and needs replacing.BThe floppy drive was not reconnected.CA configuration disk was left in the floppy drive.DThe ribbon cable has been installed incorrectly.
单选题A floppy drive is replaced in a computer and now when the computer is turned on the floppy drive light is constantly lit. Which of the following is the MOST likely cause?（）AThe power supply has failed.BThe drive cable is connected backwards.CThe floppy drive has failed.DThe proper drivers have not been loaded.
单选题A user installed a Blu-Ray drive in their PC. The user reports that the new drive and their existing DVD-RW drive are not operating. Which of the following needs to be replaced?（）APower supplyBDVD-RWCBlu-Ray driveDMotherboard
单选题Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?（）AThe new drive’s jumper is set for master.BThe new drive is connected to the secondary bus as a slave drive.CBoth drives’ jumpers are set for cable select.DThe old drive’s jumper is set for master and the new drive is set for slave.
单选题After installing the Windows operating system, Device Manager shows a number of devices with a yellow question mark next to them. Which of the following is the MOST likely reason?（）AThe latest service pack needs to be installed.BThe created hard drive partition is not large enough.CThe motherboard chipset driver needs to be installed.DThe processor does not support the Windows OS.
单选题A defective CD-ROM drive is replaced with a new CD-ROM drive. The new CD-ROM drive is able to read any CD that it accesses， but music CDs do not play music. What is the MOST likely cause of this problem？（）AThe audio cable is not connected to the drive.BThe ribbon cable is not connected.CThe power cable is not connected.DThe CD-ROM drivers are not installed.
单选题A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem？（）AWindows cannot be booted from a controller card.BThe hard drive must have Windows reinstalled because a new controller card was installed.CThe SATA controller card was not set as a boot device in the computer BIOS.DThe new controller must have the correct jumper settings for Windows mode.
单选题A customer reports to Karen, a technician, that he is experiencing problems with the display after his computer is fully booted but reports seeing the BIOS splash screen during boot. Which of the following would MOST likely be the cause?（）AThe video cable is incorrectly attached.BA corrupted or incorrect video driver is installed.CAn incorrect video card is installed in the computer.DThe video card is defective and needs to be replaced.
单选题A technician has just installed a new power supply into a desktop computer and now the computer will not turn on. Which of the following is the MOST likely cause?（）AThe voltage selector switch on the power supply is set incorrectly.BThe 3.3v power line is connected to the wrong input on the motherboard.CThe new power supply voltage rating is too high.DThe 12v power cord is installed incorrectly.
单选题An administrator reboots a ten drive server, with a RAID 10 array, after a power failure and receives an error logical drive failed. Which of the following is the MOST likely cause?（）ACorrupt file system tableBBackplane failureCMultiple drive failureDBad cable
单选题An administrator reboots a ten drive server， with a RAID 10 array， after a power failure and receives an error logical drive failed. Which of the following is the MOST likely cause？（）A Corrupt file system tableB Backplane failureC Multiple drive failureD Bad cable
单选题A new floppy drive was just installed into a PC. The drive powers on at system boot but the status LED does not turn off during operation. Which of the following is MOST likely the issue?（）AThe power cable was installed incorrectly and needs to be flipped.BThe floppy drive was not enabled within the motherboard’s BIOS.CThe FDD cable was installed incorrectly and needs to be flipped.DA Molex power cable was used instead of a Berg cable.