单选题When hoisting a boat on gravity type davits using an electric motor driven winch,the davit arms should be brought up().Ato their final position with the winch operating at slow speedBto the bar stop,and then hand cranked to their final positionCuntil just before they make contact with the limit switch,and then hand cranked to their final positionDto the embarkation deck,and then hand cranked to their final position

单选题
When hoisting a boat on gravity type davits using an electric motor driven winch,the davit arms should be brought up().
A

to their final position with the winch operating at slow speed

B

to the bar stop,and then hand cranked to their final position

C

until just before they make contact with the limit switch,and then hand cranked to their final position

D

to the embarkation deck,and then hand cranked to their final position


参考解析

解析: 暂无解析

相关考题:

The chart of a beach area shows a very flat slope to the underwater beach bottom. What type of breakers can be expected when trying to land a boat on this beach?A.SurgingB.SpillingC.PlungingD.Converging

What is the purpose of the limit switch on gravity davits?A.To cut off the power when the davits hit the track safety stopsB.To stop the davits from going too fastC.To cut off the power when the davits are about 12 inches or more from the track safety stopsD.None of the above

Frapping lines ______.A.secure the lifeboat in the davits when in the stowed positionB.bring the lifeboat close alongside the rail in the embarkation positionC.give the occupants a safety line when the boat is being lowered from the embarkation levelD.reduce the swinging of the lifeboat at the embarkation level

Frapping lines are fitted to lifeboat davits to ______.A.secure the lifeboat in the davits when in the stowed positionB.bring the life boat close along the rail in the embarkation positionC.give the occupants a safety line when the boat is being lowered from the embarkation levelD.reduce the swinging of the lifeboat at the embarkation level

In determining the scope of anchor line to pay out when anchoring a small boat, one must consider the ______.A.charted depth of water onlyB.depth of water, including tidal differencesC.time and date of anchoringD.type of anchor being used

When using a lightning arrestor, connect which type of ground wire to a good earth ground?()A、#6 solid copperB、#12 solid copperC、#20 solid copperD、#22 solid copper

When using Cisco Network Assistant to configure smartports, Which tow of the following roles can belong to a VLAN of the type "access" ?()A、Phone+DesktopB、DesktopC、SwitchD、RouterE、Trunk

When you are performing media recover, and an archived log is lost or corrupt, which type of recover must you perform?()A、Until SCNB、Until timeC、Until cancelD、Recover using backup control file.

When a client using the SERVER_ENCRYPT authentication type connects to a server using the SERVER authentication type, what happens?()A、An error will occur.B、Data passed between the client and the server is encrypted.C、User IDs and passwords are passed to the server unencrypted.D、User IDs and passwords are encrypted before they are passed to the server.

单选题On a lifeboat equipped with Rottmer-type releasing gear,turning the releasing lever releases().Athe painterBthe after boat fall only if the boat is waterborneCboth falls at the same time only if the boat is waterborneDboth falls at the same time even if the boat has not reached the water

单选题The maximum speed of lowering for a lifeboat on gravity davits is controlled by the().Alimit switchesBemergency disconnect switchCgovernor brakeDposition of the counterweight on the brake handle

单选题When launching a lifeboat,the tricing pennants should be released().Abefore the boat is lowered from the stowed positionBas the boat-fall blocks break clear of the davit headCbefore the boat is lowered from the embarkation levelDafter the boat is released into the water

多选题When using Cisco Network Assistant to configure smartports, Which tow of the following roles can belong to a VLAN of the type "access" ?()APhone+DesktopBDesktopCSwitchDRouterETrunk

单选题The lifeboats on your vessel are stowed on cradles on deck and are handled by sheath-screw boom davits. Which of the following statements about launching a boat is TRUE?()AThe boat should be hoisted a few inches clear of the cradle before cranking out the davitsBThe inboard gripes should be cast off before the outboard gripesCThe outboard section of the cradle must be releasedDThe tricing pendants will automatically bring the boat alongside at the embarkation deck

单选题A vessel is “engaged in fishing” when().Aher gear extends more than 100 meters from the vesselBshe is using any type of gear,other than linesCshe is using fishing apparatus which restricts her maneuverabilityDshe has any fishing gear on board

单选题In order to prevent galvanic corrosion,an aluminum boat must be insulated from the davits and gripes. Which of the following is acceptable as an insulator?()AHard rubberBCanvasCLeatherDSponge rubber

单选题Limit switches on gravity davits should be tested by().Athe engineers,from a panel in the engine roomBshutting off the current to the winchCpushing the switch lever arm while the winch is runningDAll of the above

单选题Frapping lines are fitted to lifeboat davits to().Asecure the lifeboat in the davits when in the stowed positionBbring the lifeboat close along the rail in the embarkation positionCgive the occupants a safety line when the boat is being lowered from the embarkation levelDreduce the swinging of the lifeboat at the embarkation level

单选题Frapping lines().Asecure the lifeboat in the davits when in the stowed positionBbring the lifeboat close alongside the rail in the embarkation positionCgive the occupants a safety line when the boat is being lowered from the embarkation levelDreduce the swinging of the lifeboat at the embarkation level

单选题Frapping lines are fitted to lifeboat davits to().Areduce the swinging of the lifeboat as it is being lowered from the embarkation levelBsecure the lifeboat in the davits when in the stowed positionChold the lifeboat to the ship's side until the tricing lines are passedDbe used as a safety line in an emergency

单选题Which statement is TRUE concerning lifeboat gripes?()AThey must be released by freeing a safety shackleBThey should not be released until the boat is in lowering positionCThey may be adjusted by a turnbuckleDThey are normally used only with radial davits

单选题On open lifeboats,the purpose of the wire stretched between the davit heads is to().Akeep the movement of the davits at the same speedBkeep the davits from slipping when they are in the stowed positionCprevent vibration during lowering of the boatDsupport the manropes

单选题When launching a lifeboat in the rough sea, the davit gears should be released().Abefore the boat is lowered from the stowed positionBas the boat fall blocks break clear of the davit headCbefore the boat is lowered from the embarkation levelDafter the boat is released into the water

单选题What is the purpose of the limit switch on gravity davits?()ATo cut off the power when the davits hit the track safety stopsBTo stop the davits from going too fastCTo cut off the power when the davits are about 12 inches or more from the track safety stopsDNone of the above

单选题The falls on gravity davits are().AmanilaBnylonCwireDAll of the above

单选题Which sequence is correct when launching a lifeboat stowed in gravity davits?()ARelease gripes,turn on emergency disconnect switch,release frapping linesBRelease tricing pennants,turn on emergency disconnect switch,release frapping linesCOperate limit switches,release gripes,lift brakeDRelease gripes,lift brake,release tricing pennants

单选题The chart of a beach area shows a very flat slope to the underwater beach bottom. What type of breakers can be expected when trying to land a boat on this beach? ()ASurgingBSpillingCPlungingDConverging