单选题What is the purpose of the limit switch on gravity davits?（）ATo cut off the power when the davits hit the track safety stopsBTo stop the davits from going too fastCTo cut off the power when the davits are about 12 inches or more from the track safety stopsDNone of the above
单选题
What is the purpose of the limit switch on gravity davits?（）
A
To cut off the power when the davits hit the track safety stops
B
To stop the davits from going too fast
C
To cut off the power when the davits are about 12 inches or more from the track safety stops
D
None of the above
参考解析
解析：
暂无解析
相关考题：
You need to perform. some initial configuration tasks on a new Ezonexam switch. What is the purpose of assigning an IP address to a switch?A．To provide local hosts with a default gateway addressB．To allow remote management of the switch.C．To allow the switch to respond to ARP requests between two hostsD．To ensure that hosts on the same LAN can communicate with each other.E．None of the above
What is the purpose of the cisco Vlan Trunking protocol?() A. to provide a mechanism to dynamically assign vlan membership to switch portsB. to allow traffic to be carried from multiple vlans over a single link between switchesC. to allow native vlan information to be carried over a trunk linkD. to provide a mechanism to manually assign vlan membership to switch portsE. to allow for managing the additions,deletions,and changes of vlans between switchs
What is the purpose of the limit switch on gravity davits?A.To cut off the power when the davits hit the track safety stopsB.To stop the davits from going too fastC.To cut off the power when the davits are about 12 inches or more from the track safety stopsD.None of the above
What could be a result of insufficient lubrication of lifeboat winches and davits ________．A.Moisture accumulation in winch motor damaging the electrical wiringB.Freezing of gears in cold weatherC.Corroding of sheaves on the davits so they will not rotateD.All of the above
The main purpose of the Customs supervision and control is to （）China’s economic， trade，scientific， technological and cultural exchanges with other countries。A、superviseB、controlC、promoteD、limit
Why would a network administrator configure port security on a switch?（）A、to prevent unauthorized Telnet access to a switch portB、to limit the number of Layer 2 broadcasts on a particular switch portC、to prevent unauthorized hosts from accessing the LAND、to protect the IP and MAC address of the switch and associated portsE、to block unauthorized access to the switch management interfaces over common TCP ports
In the context of configuring dial-on-demand routing using ISDN, what is the purpose of the dialer-list command?（）A、to identify valid numbers for incoming callsB、to define the type of ISDN switch at the central officeC、to specify the list of outgoing phone numbers used by the routerD、to associate a dial configuration with a physical interfaceE、to define interesting traffic that will enable the link
On a Cisco Nexus 7000 Series Switch， what is the purpose of this command？（） switch# config terminal switch（config）# mac address-table learning-mode conversational vlan 1-10 switch（config）# A、 Enable conversational learning on FabricPath vlans 1-10 for F-Series moduleB、 Enable FabricPath protocol on VLANs 1–10C、 No need for this command as conversational learning is enabled by default for all VLANs.D、 Enable conversational learning on Classical Ethernet VLAN for F-Series module
What is the purpose of assigning an IP address to a switch?（）A、Provides local hosts with a default gateway addressB、Allows remote management of the switch.C、Allows the switch to respond to ARP requests between two hostsD、Ensures that hosts on the same LAN can communicate with each other.
What is the purpose of the cisco Vlan Trunking protocol?（）A、to provide a mechanism to dynamically assign vlan membership to switch portsB、to allow traffic to be carried from multiple vlans over a single link between switchesC、to allow native vlan information to be carried over a trunk linkD、to provide a mechanism to manually assign vlan membership to switch portsE、to allow for managing the additions,deletions,and changes of vlans between switchs
Which of the following is the MOST accurate description of a L2/L3 switch?（）A、Performs switching and routing dutiesB、A router that directly connects to a switchC、A multi-purpose switch fabric used in full mesh environmentsD、A switch that directly connects to a router
单选题What could be a result of insufficient lubrication of lifeboat winches and davits?（）AMoisture accumulation in winch motor damaging the electrical wiringBFreezing of gears in cold weatherCCorroding of sheaves on the davits so they will not rotateDAll of the above
单选题The maximum speed of lowering for a lifeboat on gravity davits is controlled by the（）.Alimit switchesBemergency disconnect switchCgovernor brakeDposition of the counterweight on the brake handle
单选题When hoisting a boat on gravity type davits using an electric motor driven winch，the davit arms should be brought up（）.Ato their final position with the winch operating at slow speedBto the bar stop，and then hand cranked to their final positionCuntil just before they make contact with the limit switch，and then hand cranked to their final positionDto the embarkation deck，and then hand cranked to their final position
单选题Limit switches on gravity davits should be tested by（）.Athe engineers，from a panel in the engine roomBshutting off the current to the winchCpushing the switch lever arm while the winch is runningDAll of the above
单选题Why would a network administrator configure port security on a switch（）。Ato prevent unauthorized Telnet access to a switch portBto limit the number of Layer 2 broadcasts on a particular switch portCto prevent unauthorized hosts from accessing the LANDto protect the IP and MAC address of the switch and associated portsEto block unauthorized access to the switch management interfaces over common TCP ports
单选题On open lifeboats，the purpose of the wire stretched between the davit heads is to（）.Akeep the movement of the davits at the same speedBkeep the davits from slipping when they are in the stowed positionCprevent vibration during lowering of the boatDsupport the manropes
单选题Wlse uses snmp communication with an ethernet switch for what purpose？（）Ashut down rogue access pointsBconfigure access pointsCdiscover access pointsDinventory access points
单选题What is the purpose of the cisco Vlan Trunking protocol?（）Ato provide a mechanism to dynamically assign vlan membership to switch portsBto allow traffic to be carried from multiple vlans over a single link between switchesCto allow native vlan information to be carried over a trunk linkDto provide a mechanism to manually assign vlan membership to switch portsEto allow for managing the additions,deletions,and changes of vlans between switchs
单选题Which of the following statements describes the relationship between viscosity and specific gravity?（）ALiquids with different viscosities will always have the same specific gravityBLiquids with different viscosities will never have the same specific gravityCViscosity and specific gravity are directly proportionalDViscosity and specific gravity are not related in that one does not define or limit the other
单选题What is the purpose of Dual Ring Interconnect with D C for SDH rings？（）AProtects signals when a ring switch failsBProtects signals when multiple span switches failCProtects pre-emptible traffic from being dropped when a ring switch occursDProtects signals against any combination of link failure in each ring
单选题Which sequence is correct when launching a lifeboat stowed in gravity davits?（）ARelease gripes，turn on emergency disconnect switch，release frapping linesBRelease tricing pennants，turn on emergency disconnect switch，release frapping linesCOperate limit switches，release gripes，lift brakeDRelease gripes，lift brake，release tricing pennants
单选题Limit switches are used on which davits?（）ASheath-screw davitsBGravity davitsCRadial davitsDQuadrantal davits