单选题Refer to the exhibit.All switch ports are assigned to the correct VLANs, but none of the hosts connected to SwitchA can communicate with hosts in the same VLAN connected to SwitchB. Based on the output shown, what is the most likely problem?（）A The access link needs to be configured in multiple VLANs.B The link between the switches is configured in the wrong VLAN.C The link between the switches needs to be configured as a trunk.D VTP is not configured to carry VLAN information between the switches.E Switch IP addresses must be configured in order for traffic to be forwarded between the switches
单选题
Refer to the exhibit.All switch ports are assigned to the correct VLANs, but none of the hosts connected to SwitchA can communicate with hosts in the same VLAN connected to SwitchB. Based on the output shown, what is the most likely problem?（）
A
The access link needs to be configured in multiple VLANs.
B
The link between the switches is configured in the wrong VLAN.
C
The link between the switches needs to be configured as a trunk.
D
VTP is not configured to carry VLAN information between the switches.
E
Switch IP addresses must be configured in order for traffic to be forwarded between the switches
参考解析
解析：
暂无解析
相关考题：
A Ezonexam switch is configured with all ports assigned to VLAN 2. In addition, all ports are configured as full-duplex FastEthernet. What is the effect of adding switch ports to a new VLAN on this switch?A．The additions will create more collisions domains.B．IP address utilization will be more efficient.C．More bandwidth will be required than was needed previously.D．An additional broadcast domain will be created.E．The possibility that switching loops will occur will increase dramatically.
Refer to the exhibit. What switch proves the spanning－tree designated port role for the network segment that services the printers?() A.Switch1B.Switch2C.Switch3D.Switch4
Refer to the exhibit.The network administrator normally establishes a telnet session with the switch from host A.However,host A is unavailable.The administrators attempt to the switch from host B fails,but pings to the other two hosts are successful.what is the issue?（）A.Host B and the switch need to be in the same subnet.B.The switch needs and appropriate default gateway assigned.C.The switch interface connected to the router is down.D.Host B need to be assigned an IP address in vlan 1.E.The switch interfaces need the appropriate IP addresses assigned.
Refer to the topology shown in the exhibit. Which ports will be STP designated ports if all the links are operating at the same bandwidth? () A.Switch A - Fa0/0B.Switch A - Fa0/1C.Switch B - Fa0/0D.Switch B - Fa0/1E.Switch C - Fa0/0F.Switch C - Fa0/1
Refer to the exhibit.Switch－1 needs to send data to a host with a MAC address of 00b0.d056.efa4.What will Switch－1 do with this data?() A.switch-1 will drop the data because it dose not have an entry for that MAC addressB.switch-1 will flood the data out all of its port from which the data originatedC.switch-1 will forward the data to its default gatewayD.tch-1 will send an ARP request out all its ports except the port from which the data originated
Refer to the exibit. Three cisco 2950 switches are set to their default priority sttings.During the spanningtree process,which switch will be elected as the root bridge?() A.Switch3B.Switch4C.Switch2D.Switch1
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?（）A、More collision domains will be created.B、IP address utilization will be more efficient.C、More bandwidth will be required than was needed previously.D、An additional broadcast domain will be created.
Refer to the output shown on switch SW1 below： Warning： Spantree port fast start should only be enabled on ports connected to a single host.Connecting hubs， concentrators， switches， bridges， etc. to a fast start port can cause temporaryspanning tree loops. Use with caution. Spantree ports 4/1-24 fast start enabled. What command could you enter to reproduce this output？
You are assigning VLANs to the ports of switch R1. What VLAN number value is an assigned tothe default VLAN？（）A、VLAN 1003B、VLAN 1C、VLAN OND、VLAN AE、VLAN 0
The DAI feature has been implemented in the Company switched LAN. Which three statements are true about the dynamic ARP inspection （DAI） feature？ （）A、 DAI can be performed on ingress ports only.B、 DAI can be performed on both ingress and egress ports.C、 DAI is supported on access ports， trunk ports， EtherChannel ports， and private VLAN ports. D、 DAI should be enabled on the root switch for particular VLANs only in order to secure the ARP caches of hosts in the domain.E、 DAI should be configured on all access switch ports as untrusted and on all switch ports connected to other switches as trusted.F、 DAI is supported on access and trunk ports only.
Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?（）A、Ensure that the Ethernet encapsulations match on the interconnected router and switch ports.B、Ensure that cables A and B are straight-through cables.C、Ensure cable A is plugged into a trunk port.D、Ensure the switch has power.E、Reboot all of the devices.F、Reseat all cables.
Refer to the exhibit. The output that is shown is generated at a switch. Which three of these statements are true? （）A、All ports will be in a state of discarding, learning, or forwarding.B、Thirty VLANs have been configured on this switch.C、The bridge priority is lower than the default value for spanning tree.D、All interfaces that are shown are on shared media.E、All designated ports are in a forwarding state.F、The switch must be the root bridge for all VLANs on this switch.
What are the switch and bridge port characteristics of a layer two spanning-tree network that is fully converged?（）A、All switch and bridge ports are in the forwarding state.B、All switch and bridge ports are in the stand-by state.C、All switch and bridge ports are assigned as either root or designated ports.D、All switch and bridge ports are in either the forwarding or blocking state.E、All switch and bridge are either blocking or looping.
You have just created a new VLAN on your network. What is one step that you should include in your VLAN-based implementation and verification plan？ （）A、Verify that trunked links are configured to allow the VLAN traffic.B、Verify that the switch is configured to allow for trunking on the switch ports.C、Verify that each switch port has the correct IP address space assigned to it for the new VLAN.D、Verify that different native VLANs exist between two switches for security purposes.
Which two of the following steps are necessary to configure inter-VLAN routing between multilayer switches？（）A、Configure a dynamic routing protocol.B、Configure SVI interfaces with IP addresses and subnet masks.C、Configure switch ports with network addresses.D、Configure switch ports with the autostate exclude command.E、Document the MAC addresses of the switch ports.
By default, each port in a Cisco Catalyst switch is assigned to VLAN1. Which two recommendations are key to avoid unauthorized management access? （）A、Create an additional ACL to block the access to VLAN 1.B、Move the management VLAN to something other than default.C、Move all ports to another VLAN and deactivate the default VLAN.D、Limit the access in the switch using port security configuration.E、Use static VLAN in trunks and access ports to restrict connections.F、Shutdown all unused ports in the Catalyst switch.
单选题You are assigning VLANs to the ports of switch R1. What VLAN number value is an assigned tothe default VLAN？（）AVLAN 1003BVLAN 1CVLAN ONDVLAN AEVLAN 0
单选题Refer to the exhibit.The network administrator normally establishes a telnet session with the switch from host A.However,host A is unavailable.The administrator′s attempt to the switch from host B fails,but pings to the other two hosts are successful.what is the issue?（）A Host B and the switch need to be in the same subnet.B The switch needs and appropriate default gateway assigned.C The switch interface connected to the router is down.D Host B need to be assigned an IP address in vlan 1.E The switch interfaces need the appropriate IP addresses assigned.
单选题Refer to the exhibit.Switch-1 needs to send data to a host with a MAC address of 00b0.d056.efa4.What will Switch-1 do with this data?（）A switch-1 will drop the data because it dose not have an entry for that MAC addressB switch-1 will flood the data out all of its port from which the data originatedC switch-1 will forward the data to its default gatewayD tch-1 will send an ARP request out all its ports except the port from which the data originated
多选题By default, each port in a Cisco Catalyst switch is assigned to VLAN1. Which two recommendations are key to avoid unauthorized management access?（）ACreate an additional ACL to block the access to VLAN 1.BMove the management VLAN to something other than default.CMove all ports to another VLAN and deactivate the default VLAN.DLimit the access in the switch using port security configuration.EUse static VLAN in trunks and access ports to restrict connections.FShutdown all unused ports in the Catalyst switch.
问答题Refer to the output shown on switch SW1 below： Warning： Spantree port fast start should only be enabled on ports connected to a single host.Connecting hubs， concentrators， switches， bridges， etc. to a fast start port can cause temporaryspanning tree loops. Use with caution. Spantree ports 4/1-24 fast start enabled. What command could you enter to reproduce this output？
单选题Which statement describes a spanning-tree network that has converged?（）AAll switch and bridge ports are in the forwarding state.BAll switch and bridge ports are assigned as either root or designated ports.CAll switch and bridge ports are in either the forwarding or blocking state.DAll switch and bridge ports are either blocking or looping.
多选题The DAI feature has been implemented in the Company switched LAN. Which three statements are true about the dynamic ARP inspection （DAI） feature？ （）ADAI can be performed on ingress ports only.BDAI can be performed on both ingress and egress ports.CDAI is supported on access ports， trunk ports， EtherChannel ports， and private VLAN ports.DDAI should be enabled on the root switch for particular VLANs only in order to secure the ARP caches of hosts in the domain.EDAI should be configured on all access switch ports as untrusted and on all switch ports connected to other switches as trusted.FDAI is supported on access and trunk ports only.
多选题Refer to the exhibit. The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?（）AEnsure that the Ethernet encapsulations match on the interconnected router and switch ports.BEnsure that cables A and B are straight-through cables.CEnsure cable A is plugged into a trunk port.DEnsure the switch has power.EReboot all of the devices.FReseat all cables.
单选题You are implementing basic switch security best practices. Which of these is a tactic that you can use to mitigate compromises from being launched through the switch？（）AMake all ports private VLAN ports.BPlace all unused ports in native VLAN 1 until needed.CProactively configure unused switch ports as access ports.DDisable Cisco Discovery Protocol globally.
单选题You have just created a new VLAN on your network for inter-VLAN routing. What is one step that you should include in your VLAN-based implementation and verification plan？（）AVerify that different native VLANs exist between two switches for security purposes.BVerify that the switch is configured to allow for trunking on the switch ports.CVerify that each switch port has the proper IP address space assigned to it for the new VLAN. DVerify that the VLAN virtual interface has been correctly created and enabled.
单选题A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?（）AMore collision domains will be created.BIP address utilization will be more efficient.CMore bandwidth will be required than was needed previously.DAn additional broadcast domain will be created.