填空题根据ITIC公司在2009年的调查报告，Power System with AIX的宕机时间不超过（）？
填空题
根据ITIC公司在2009年的调查报告，Power System with AIX的宕机时间不超过（）？
参考解析
解析：
暂无解析
相关考题：
AcustomerwantstotakeadvantageofIBM’sMicro－PartitioningcapabilitiesfortheirnewAIXapplications.ThepSeriestechnicalspecialistshouldrecommendpurchasingwhichofthefollowing?() A.p5hardware，AIX5.2，VirtualI/OServerB.POWER4hardware，AIX5.3，VirtualI/OServer，C.p5hardware，AIX5.3，AdvancedPOWERVirtualizationfeatureD.POWER4hardware，AIX5.2，AdvancedPOWERVirtualizationfeature
In addition to a POWER5 system and an HMC， what else is required to enable Micro-Partitions in an AIX environment？（）A、AIX 5.3 and Dynamic Logical PartitioningB、AIX 5.2 and Dynamic Logical PartitioningC、AIX 5.2 and Advanced POWER Virtualization featureD、AIX 5.3 and Advanced POWER Virtualization feature
The system administrator did a new install of AIX on a server about a week ago. The system was not rebooted after the installation. CDE is running on this system as is TCPIP. The system administrator has started configuring the system percompany directives. The power cable was inadvertently disconnected from the wall causing the sever to lose power. Upon reboot, the system appears to hang during log in from the console or from Xterminals. Which of the following is the most probable cause?（）A、It is a hardware problem caused by the power failure.B、There is a network problem, most probably with name resolution.C、Sine the system was never rebooted, devices are marked defined instead of available and need to be activated.D、Some filesets may be marked as broken and need to be reinstalled.
Companycom is migrating from p670 systems running AIX 5.2 to p5 595 systems running AIX 5.3. They will be changing out only the system units. They will re-use the existing 61D drawers and adapters with the new p5 595 systems. What compatibility issue must be considered?（） A、APV features are not supported for some legacy POWER4 adaptersB、APV will require the most current maintenance level for AIX 5.2C、APV features will require that legacy POWER4 adapters be updated with new microcodeD、The Virtual IO Server must run AIX 5.3 and the LPARs can run either AIX 5.2 or AIX 5.3
有关IBM Power 720服务器，下面的哪些说法是合理的（）A、Power 720可以使用Power6处理器B、Power 720是IBM System p 服务器一款超低端产品，可配置4核、6核、8核CPUC、Power 720采用power7芯片，支持3.3GHz，3.55GHz主频D、Power 720支持AIX，LINUX，Windows操作系统
Which operating system can directly host managed storage for IBM i, AIX, Linux, VMware and Windows on a Power Systems server?（）A、AIXB、IBM iC、LinuxD、VIO Server
Which of the following is required to use Simultaneous Multi-Threading (SMT)?（）A、smtctl commandB、A dual core chipC、AIX 5.3 operating system and POWER5 hardwareD、Advanced Virtualization which is a separately purchased product
A customer wants to take advantage of IBM’s Micro-Partitioning capabilities for their new AIX applications. The pSeries technical specialist should recommend purchasing which of the following？（）A、p5 hardware， AIX 5.2， Virtual I/O ServerB、POWER4 hardware， AIX 5.3， Virtual I/O Server，C、p5 hardware， AIX 5.3， Advanced POWER Virtualization featureD、POWER4 hardware， AIX 5.2， Advanced POWER Virtualization feature
A system administrator has just finished upgrading a system to AIX 5.2. If there are future problems， the system administrator would like to add an entry to the AIX errorlog to record this event. Which of the following commands can be issued for this purpose？（）A、/usr/bin/errmsg "System upgraded to AIX 5.2"B、/usr/bin/errlog "System upgraded to AIX 5.2"C、/usr/bin/errupdate "System upgraded to AIX 5.2"D、/usr/bin/errlogger "System upgraded to AIX 5.2"
An IT director is eager to adopt POWER7 servers because of their relative performance ratings and energy efficiency， but is concerned about migrating applications which require AIX 5.3. Which of the following will address his concern？（）A、POWER7 servers running AIX 5.3 operate in POWER5+ mode.B、POWER7 servers running AIX 5.3 operate in POWER6 and POWER6+ mode.C、POWER7 servers running AIX 5.3 operate in POWER5 and POWER6 modes.D、POWER7 servers running AIX 5.3 operate in POWER6 and POWER7 modes.
A customer has a new Power 720 with PowerVM Standard Edition. They plan to migrate their single-partition POWER5 550 to the new Power 720. How can the customer migrate from the POWER5 550 to the Power 720 with minimal effort and down time？（）A、Perform Live Partition Mobility between the two systems.B、Move the boot disks from the old system to the new system.C、Use Tivoli Storage Manager to back up the POWER5 550 and restore on the Power 720.D、Upgrade AIX to the latest level on the POWER5 550 and clone using the mksysb command.
A customer needs a system supporting four partitions， each with the following requirements： ？ 0.6 1.65GHz processors ？ 2GB memory ？ AIX 5.2 They also need the ability to grow the system in the future. Which pSeries system would be positioned best to meet this customer’s requirements？（）A、p5-550 with the Advanced POWER Virtualization feature and AIX 5.2B、p5-550 with the POWER5 processor technology and AIX 5.2C、p5-570 with the Advanced POWER Virtualization feature and AIX 5.3D、p5-570 with the POWER5 processor technology and AIX 5.2
Which operating system can directly host managed storage for IBM i, AIX, Linux, VMware and Windows on a Power Systems server?（）A、AIXB、IBMiC、LinuxD、VIO Server
Which functionality would a customer use to share available CPU resources between AIX and Linux partitions on a Power system?（）A、 Dynamic LPARB、 Micro PartitionsC、 Entitled capacityD、 Multiple Shared Processor Pools
A system administrator is deploying a new POWER5 server. The application requires AIX 5L V5.2. Which of the following virtualization technologies can be used？（）A、DLPARB、Micro-PartitioningC、Virtual StorageD、Virtual Ethernet
A customer has a storage requirement for a mixed IBM Power AIX and System z environment. They require approximately 3 TB of high performance disk for their System z environment. They require approximately 32 TB of low-performance disk for their System p environment. The storage specialist is using Capacity Magic to configure an IBM DS8700. Which configuration is most appropriate for this customer（）A、2 x 300 GB 15k rpm disk drive sets for System z； and 4 x 2 TB 7.2k rpm disk drive sets for Power AIXB、4 x 146 GB 15k rpm disk drive sets for System z； and 4 x 2 TB 7.2k rpm disk drive sets for Power AIXC、2 x 300 GB 10k rpm disk drive sets for System z； and 4 x 300 GB 15k rpm disk drive sets for Power AIXD、2 x 300 GB 15k rpm disk drive sets for System z； and 2 x 1 TB 7.2k rpm disk drive sets for Power AIX
A customer plans to consolidate to high-end enterprise level servers using multiple partitions. They are evaluating an IBM POWER5 solution for their server consolidation environment. Which of the following best describes the value of the IBM solution as compared with the competition？（）A、The POWER5 system has greater memory and processor granularity and can also run both Linux and AIX at the same time in different LPARs.B、The POWER5 system supports more partitions， processors， and memory than any competitor’s solution.C、The POWER5 system has the lowest partitioning overhead and can also run both Linux and AIX at the same time in different LPARs.D、The POWER5 system supports more partitions and has the lowest partitioning overhead.
Which of the following lists of items all require an HMC to function with POWER5？（）A、Running AIX 5.3 Implementing HACMP Implementing Static LPARB、Implementing Advanced POWER Virtualization Running Linux Attaching RIO drawersC、Implementing VIO Server Implementing Dynamic LPAR Running with SMT turned "On"D、Running AIX and Linux on the same system Implementing CoD Implementing Micro-Partitioning
单选题The system administrator did a new install of AIX on a server about a week ago. The system was not rebooted after the installation. CDE is running on this system as is TCPIP. The system administrator has started configuring the system percompany directives. The power cable was inadvertently disconnected from the wall causing the sever to lose power. Upon reboot, the system appears to hang during log in from the console or from Xterminals. Which of the following is the most probable cause?（）AIt is a hardware problem caused by the power failure.BThere is a network problem, most probably with name resolution.CSine the system was never rebooted, devices are marked defined instead of available and need to be activated.DSome filesets may be marked as broken and need to be reinstalled.
单选题A customer needs a system supporting four partitions， each with the following requirements： ？ 0.6 1.65GHz processors ？ 2GB memory ？ AIX 5.2 They also need the ability to grow the system in the future. Which pSeries system would be positioned best to meet this customer’s requirements？（）Ap5-550 with the Advanced POWER Virtualization feature and AIX 5.2Bp5-550 with the POWER5 processor technology and AIX 5.2Cp5-570 with the Advanced POWER Virtualization feature and AIX 5.3Dp5-570 with the POWER5 processor technology and AIX 5.2
单选题A customer plans to consolidate to high-end enterprise level servers using multiple partitions. They are evaluating an IBM POWER5 solution for their server consolidation environment. Which of the following best describes the value of the IBM solution as compared with the competition？（）AThe POWER5 system has greater memory and processor granularity and can also run both Linux and AIX at the same time in different LPARs.BThe POWER5 system supports more partitions， processors， and memory than any competitor’s solution.CThe POWER5 system has the lowest partitioning overhead and can also run both Linux and AIX at the same time in different LPARs.DThe POWER5 system supports more partitions and has the lowest partitioning overhead.
单选题In addition to a POWER5 system and an HMC， what else is required to enable Micro-Partitions in an AIX environment？（）AAIX 5.3 and Dynamic Logical PartitioningBAIX 5.2 and Dynamic Logical PartitioningCAIX 5.2 and Advanced POWER Virtualization featureDAIX 5.3 and Advanced POWER Virtualization feature
单选题A system administrator has just finished upgrading a system to AIX 5.2. If there are future problems， the system administrator would like to add an entry to the AIX errorlog to record this event. Which of the following commands can be issued for this purpose？（）A/usr/bin/errmsg System upgraded to AIX 5.2B/usr/bin/errlog System upgraded to AIX 5.2C/usr/bin/errupdate System upgraded to AIX 5.2D/usr/bin/errlogger System upgraded to AIX 5.2
单选题An IT director is eager to adopt POWER7 servers because of their relative performance ratings and energy efficiency， but is concerned about migrating applications which require AIX 5.3. Which of the following will address his concern？（）APOWER7 servers running AIX 5.3 operate in POWER5+ mode.BPOWER7 servers running AIX 5.3 operate in POWER6 and POWER6+ mode.CPOWER7 servers running AIX 5.3 operate in POWER5 and POWER6 modes.DPOWER7 servers running AIX 5.3 operate in POWER6 and POWER7 modes.