多选题A network administrator is configuring ACLs on a cisco router,to allow traffic from hosts on networks 192.168.146.0,192.168.147.0,192.168.148.0and192.168.149.0 only.Which two ACL statements when combined are the best for accomplishing the task?（）Aaccess-list 10 permit ip 192.168.147.0 0.0.0.255.255Baccess-list 10 permit ip 192.168.149.0 0.0.0.255.255Caccess-list 10 permit ip 192.168.146.0 0.0.0.0.255Daccess-list 10 permit ip 192.168.146.0 0.0.0.1.255Eaccess-list 10 permit ip 192.168.148.0 0.0.0.1.255Faccess-list 10 permit ip 192.168.146.0 255.255.255.0
多选题
A network administrator is configuring ACLs on a cisco router,to allow traffic from hosts on networks 192.168.146.0,192.168.147.0,192.168.148.0and192.168.149.0 only.Which two ACL statements when combined are the best for accomplishing the task?（）
A
access-list 10 permit ip 192.168.147.0 0.0.0.255.255
B
access-list 10 permit ip 192.168.149.0 0.0.0.255.255
C
access-list 10 permit ip 192.168.146.0 0.0.0.0.255
D
access-list 10 permit ip 192.168.146.0 0.0.0.1.255
E
access-list 10 permit ip 192.168.148.0 0.0.0.1.255
F
access-list 10 permit ip 192.168.146.0 255.255.255.0
参考解析
解析：
暂无解析
相关考题：
A system is experiencing packet routing problems,when the administrator runs ‘netstat -nr‘ the following default routes are displayed: default165.253.251.1UG51601304 en8--default 192.168.50.1UGH01590450 en4-- Assuming the first route is correct.How can the administrator remove the incorrect default route?（）A.route delete default 192.168.50.1B.access smit with the route_remove shortcutC.chdev -l inet0 -a delroute=net,-hopcount,0,,192.168.50.1D.flush the routing table from the console and configuring the 165.253.251.1 route
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）A. using DHCP snoopingB. snooping the incoming 802.1Q VLAN tagC. using CDPD. snooping the CoS marking on the incoming frames
As an experienced network administrator, you are aware of the knowledge that it is unnecessary to configure complex overlay network topologies while applying Cisco Wide Area Application Services (WAAS) technology.What is most probably the reason for that?（）A. Content pre-positioningB. Automatic discovery of Cisco WAEsC. Comprehensive logs, reports, and graphsD. Remote scheduling of software distribution
The network administrator of the Oregon router adds the follwing command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command?() A. The command establishes a static routeB. The command invokes a dynamic routing protocol for 192.168.12.0C. Traffic for network 192.168.12.0 is forwarded to 172.16.12.1D. Traffic for all networks is forwarded to 172.16.12.1E. This route is automatically propagated throughout the entire networkF. Traffic for network 172.16.12.0 is forwarded to the 192.168.12.0 network
Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network.The network administrator connected to console port,issued the show ip route command,and was able to ping the server.Based on the output of the show ip route command topology shown in the graphic,what is the cause of the failure?（）A.IP routing is not enabledB.A static route is configured incorrectlyC.The network has not fully convergedD.The FastEthernet interface on Coffee is disabledE.The routing table on Coffee has not updatedF.The neighbor relationship table is not correctly updated
A network administrator is configuring ACLs on a cisco router, to allow affic from hosts on networks 192.168.146.0,192.168.147.0,192.168.148.0 and 192.168.149.0 only.Which two ACL statements when combined are the best for accomplishing the task?（）A.access-list 10 permit ip 192.168.147.0 0.0.0.255.255B.access-list 10 permit ip 192.168.149.0 0.0.0.255.255C.access-list 10 permit ip 192.168.146.0 0.0.0.0.255D.access-list 10 permit ip 192.168.146.0 0.0.1.255E.access-list 10 permit ip 192.168.148.0 0.0.1.255F.access-list 10 permit ip 192.168.146.0 255.255.255.0
A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-Cisco router.How should the network administrator configure the serial interface of the main office router to make the connection?（）A.B.C.D.
Which statement about Remotely Triggered Black Hole （RTBH） is true？（）A、Route tagging is one of the techniques used by RTBHB、It is used for BGP authenticationC、It cannot work with static routesD、It uses extended ACLs for blocking attacks by creating a black holeE、Before configuring RTBH LDP must be enabled on the interface
The network administrator of the Oregon router adds the follwing command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command?（）A、The command establishes a static routeB、The command invokes a dynamic routing protocol for 192.168.12.0C、Traffic for network 192.168.12.0 is forwarded to 172.16.12.1D、Traffic for all networks is forwarded to 172.16.12.1E、This route is automatically propagated throughout the entire networkF、Traffic for network 172.16.12.0 is forwarded to the 192.168.12.0 network
Which three are used in configuring Call Manager dial plans？ （）A、 route listB、 route groupC、 gateway listD、 route pattern
A network administrator is configuring ACLs on a cisco router, to allow affic from hosts on networks 192.168.146.0,192.168.147.0,192.168.148.0 and 192.168.149.0 only.Which two ACL statements when combined are the best for accomplishing the task?（）A、access-list 10 permit ip 192.168.147.0 0.0.0.255.255B、access-list 10 permit ip 192.168.149.0 0.0.0.255.255C、access-list 10 permit ip 192.168.146.0 0.0.0.0.255D、access-list 10 permit ip 192.168.146.0 0.0.1.255E、access-list 10 permit ip 192.168.148.0 0.0.1.255F、access-list 10 permit ip 192.168.146.0 255.255.255.0
PassGuide has a BGP network and a BGP route of 197.22.129.0/24 that should be propagated to all of the devices. The route is currently not in any of the routing tables. The PassGuide administrator determines that an access list is the cause of the problem. The administrator changes the access list to allow this route, but the route still doesnot appear in any of the routing tables. What should be done to propagate this route（）A、Use the service-policy command to adjust the QOS policy to allow the route to propagate.B、Clear the BGP session.C、Use the release BGP routing command.D、Change both the inbound and outbound policy related to this route.E、None of the other alternatives apply
Which of these is mandatory when configuring Cisco IOS Firewall？ （）A、Cisco IOS IPS enabled on the untrusted interfaceB、NBAR enabled to perform protocol discovery and deep packet inspectionC、a route map to define the trusted outgoing trafficD、a route map to define the application inspection rulesE、an inbound extended ACL applied to the untrusted interface
Which of the following are benefits provided with access control lists (ACLs)?（）A、ACLs monitor the number of bytes and packets.B、Virus detection.C、ACLs dentify interesting traffic for DDR.D、ACLs provide IP route filtering.E、ACLs provide high network availability.F、ACLs classify and organize network traffic.
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）A、using DHCP snoopingB、snooping the incoming 802.1Q VLAN tagC、using CDPD、snooping the CoS marking on the incoming frames
A network administrator enters the command clear ip route * and as a result he sees the message，"Please update the network documentation to record why the ip routing table was cleared." Which router feature was used in this case？（）A、NetFlowB、SNMPC、DebugD、SysLogE、EEMF、CEF
A system is experiencing packet routing problems，when the administrator runs ’netstat -nr’ the following default routes are displayed： default165.253.251.1UG51601304 en8-- default192.168.50.1UGH01590450 en4-- Assuming the first route is correct，how can the administrator remove the incorrect default route？（）A、route delete default 192.168.50.1B、access smit with the route_remove shortcutC、chdev -l inet0 -a delroute=net，-hopcount，0，，192.168.50.1D、flush the routing table from the console and configuring the 165.253.251.1 route
单选题A company has a BGP network and a BGP route of 196.27.125.0/24 that should be propagated toall of the devices. The route is not now in any of the routing tables. The administrator determinesthat an access list is the cause of the problem. The administrator changes the access list to allowthis route， but the route still does not appear in any of the routing tables. What should be done topropagate this route？（）AClear the BGP sessionBChange both the inbound and outbound policy related to this routeCUse the service-policy command to adjust the QOS policy to allow the route to propagateDUse the release BGP routing command
单选题As an experienced network administrator, you are aware of the knowledge that it is unnecessary to configure complex overlay network topologies while applying Cisco Wide Area Application Services (WAAS) technology. What is most probably the reason for that?（）AContent pre-positioningBAutomatic discovery of Cisco WAEsCComprehensive logs, reports, and graphsDRemote scheduling of software distribution
单选题You are an administrator of a switched network and your goal is to reduce some of the administrative overhead on your network. You plan on achieving this by configuring a new VLAN for each department in your network. However, you need to share the VLAN information across numerous switches throughout your network. Which of the following would allow you accomplish this?（）ASTPBGVRPCSNMPDVTPEDHCP
单选题PassGuide has a BGP network and a BGP route of 197.22.129.0/24 that should be propagated to all of the devices. The route is currently not in any of the routing tables. The PassGuide administrator determines that an access list is the cause of the problem. The administrator changes the access list to allow this route, but the route still doesnot appear in any of the routing tables. What should be done to propagate this route（）AUse the service-policy command to adjust the QOS policy to allow the route to propagate.BClear the BGP session.CUse the release BGP routing command.DChange both the inbound and outbound policy related to this route.ENone of the other alternatives apply
多选题The network administrator of the Oregon router adds the following command to the router configuration: ip route 192.168.12.0 255.255.255.0 172.16.12.1. What are the results of adding this command (Choose two.)（）。AThe command establishes a static route.BThe command invokes a dynamic routing protocol for 192.168.12.0.CTraffic for network 192.168.12.0 is forwarded to 172.16.12.1.DTraffic for all networks is forwarded to 172.16.12.1.EThis route is automatically propagated throughout the entire network.FTrafficfor network 172.16.12.0 is forwarded to the 192.168.12.0 network.
多选题Which of the following are benefits provided with access control lists (ACLs)?（）AACLs monitor the number of bytes and packets.BVirus detection.CACLs dentify interesting traffic for DDR.DACLs provide IP route filtering.EACLs provide high network availability.FACLs classify and organize network traffic.
多选题Cisco IOS is the software used on the vast majority of Cisco Systems routers and current Cisco network switches. As a network administrator, you are required to configure MPLS on Cisco IOS. In such a situation, which three of the following steps are necessary to take?（）AStart LDP.BEnable CEF switching.CConfigure conditional label advertising.DEnable label switching on frame mode interfaces.Edisable IP TTL propagationFconfigure conditional label advertising
单选题A system is experiencing packet routing problems，when the administrator runs ’netstat -nr’ the following default routes are displayed： default165.253.251.1UG51601304 en8-- default192.168.50.1UGH01590450 en4-- Assuming the first route is correct，how can the administrator remove the incorrect default route？（）Aroute delete default 192.168.50.1Baccess smit with the route_remove shortcutCchdev -l inet0 -a delroute=net，-hopcount，0，，192.168.50.1Dflush the routing table from the console and configuring the 165.253.251.1 route
单选题Which of these is mandatory when configuring Cisco IOS Firewall？ （）ACisco IOS IPS enabled on the untrusted interfaceBNBAR enabled to perform protocol discovery and deep packet inspectionCa route map to define the trusted outgoing trafficDa route map to define the application inspection rulesEan inbound extended ACL applied to the untrusted interface
单选题A network administrator enters the command clear ip route * and as a result he sees the message，"Please update the network documentation to record why the ip routing table was cleared." Which router feature was used in this case？（）ANetFlowBSNMPCDebugDSysLogEEEMFCEF