单选题The power and torque capability of the steering system must be such that the rudder can be swung from （）one side to（）the other side with the ship at maximum speed.A35°；35°B35°；30°C15°；15°D28°；60°
单选题
The power and torque capability of the steering system must be such that the rudder can be swung from （）one side to（）the other side with the ship at maximum speed.
A
35°；35°
B
35°；30°
C
15°；15°
D
28°；60°
参考解析
解析：
暂无解析
相关考题：
According to Regulations, a power driven auxiliary steering gear for a vessel capable of a 12 knot service speed, must be able to meet the rudder movement requirements at which of the minimum vessel speeds listed below?A.6 knotsB.7 knotsC.9 knotsD.12 knots
The “Port-Off-Stbd” selector switch on an autopilot steering stand is used to ______．A.change from hand electric steering to automatic gyroB.change over one steering system to the otherC.change over hand electric steering to non-follow-upD.change over the port to the starboard bow thruster
材料：At 1800，the hydraulic steering system failed once again．The master realized he would require shore assistance to rectify the problem，and diverted towards Portland using the thruster to steer by．The weather at this time was south-south-west force 5．At about three hours later，the thruster drive unit failed due to a leaking fuel injector pipe on the power unit．This was replaced using the spare carried on board．Immediately following the engine restart，an adjacent fuel line failed causing shut down of the unit．With no fuel line spares available，the thruster power unit could not be used．The failure of this unit，and that of the main hydraulic steering system，left the vessel without any steering capability．At 2155，with the weather deteriorating and no steering，the master contacted the Portland Coastguard and a“Pan pan”message was broadcast．A tow to Portland Harbor was arranged and she arrived alongside at 0240 the following morning．The subsequent investigation found that the main hydraulic steering system failure was due to a seized shuttle valve in the main hydraulic solenoid valve block．The solenoid valve had been recently overhauled．It was thought that the“O”rings fitted to the shuttle valve were of either the wrong type or a defective one．The valve had seized in such a position that hydraulic pressure by-passed the system preventing use of the hand steering．问题：The vessel was steered by thruster because ________ failed．A.the hydraulic steering systemB.the solenoid valveC.the thruster driving unitD.the hand steeringThe time that the thruster drive unit failed was ________ hrs．A.1800B.2100C.2155D.0240When the hydraulic steering system failed，________．A.the hand steering system could still be usedB.the auto steering system could still be usedC.both hand and auto steering system were out of useD.neither and steering system nor auto steering system was out of useThe real reason that caused the hydraulic steering system to fail was that ________．A.no fuel line spare were availableB.the weather was deterioratingC.the“O”rings fitted to the shuttle valve were of either the wrong type or a defective oneD.the thruster power unit failed请帮忙给出每个问题的正确答案和分析，谢谢！
Which TWO of the following are required to use the hot-swap memory feature of the x445 while being operating system independent？（）A、Memory Mirroring must be enabled in the BIOS.B、Redundant bit steering must be enabled in the BIOS.C、DIMMs must be the same size and speed as the DIMMs being replaced.D、Memory Mirroring must be enabled in the operating system.E、DIMMs can be of same size or larger or same speed or faster.
After a server has been installed into a rack, an administrator must ensure which of the following?（）A、Warm air flow is permitted through the front bezelB、The system is labeled so that it can be identifiedC、Verify the change control process can be implementedD、Determine the correct power requirements
Following an unscheduled power outage, theadministrator needs to power up an IVM-managed system. For the given system,what is the first step in this process?（）A、Physically press the appropriate button on the system.B、Physically disconnect and reconnect the power cable on the system.C、Log into the IVM using a Web Browser, select the managed-system and select the Power on option from the Operations menu.D、Log into the HMC using a Web Browser, select the managed-system and select the Power on option from the Operations menu.
Which of the following statements is true regarding implementing Live Partition Mobility on two existing POWER6 based systems?（）A、The systems must use internal storage for boot purposes. B、All virtualized ethernet adapters must be numbered below 10. C、The mobile partition's network and disk access must be virtualized. D、Each system must be controlled by a different Hardware Management Console (HMC).
A customer requires two 12X loops on their new POWER7 system. What is the smallest system that will support two loops?（）A、Power 710B、Power 720C、Power 730D、Power 740
单选题A vessel constrained by her draught shall，when risk of collision with another vessel in a crossing or head-on situation exists，（）.Aapply the relevant Steering and Sailing Rules as a power-driven vesselBapply the relevant Steering and Sailing Rules as a Sailing vesselCapply the relevant Steering and Sailing Rules as a vessel not under commandDapply the relevant Steering and Sailing Rules as a vessel engaged in a towing operation
单选题The test of a towing vessel’s steering gear control system includes each item EXCEPT（）.Aa test from the alternative power supply，if installedBtiming the movement of the rudder from hard over to hard overCverification that the rudder angle indicator shows the actual position of the rudder(s)Dvisual inspection of the steering linkage
单选题Accidental grounds in a shipboard electrical system must be repaired as soon as possible as they will （）Aresult in immediate power outagesBdamage circuit breakersCappear on the ground detection systemDdamage insulation and may cause outages
单选题An AC synchronous transmission type remote steering control system consists of a （）.Atransmitter at the steering station and a receiver at the steering engineBreversible motor at the steering station geared to the steering pumpsCsmall induction motor on the bridge which controls the redder through pulleysDvariable displacement hydraulic pump driven by a reversible DC motor
单选题Which of the following statements is true regarding implementing Live Partition Mobility on two existing POWER6 based systems？ （）A The systems must use internal storage for boot purposes.B All virtualized Ethernet adapters must be numbered below 10.C The mobile partition’s network and disk access must be virtualized.D Each system must be controlled by a different Hardware Management Console （HMC）.
单选题Certain requirements must currently be met by a ship’s steering system.There must be （）independent means of steering, although where two identical power units are provided, an auxiliary unit is not required.AoneBtwoCthreeDfour
多选题Which TWO of the following are required to use the hot-swap memory feature of the x445 while being operating system independent？（）AMemory Mirroring must be enabled in the BIOS.BRedundant bit steering must be enabled in the BIOS.CDIMMs must be the same size and speed as the DIMMs being replaced.DMemory Mirroring must be enabled in the operating system.EDIMMs can be of same size or larger or same speed or faster.
单选题Which of the following is NOT true according to the passage?（）ABoth the main steering gear and the auxiliary steering gear should be operatedBThe alarms fitted to the remote control system should be operatedCThe emergency generator compartment should be checkedDThe communication system between the bridge and the steering gear compartment should be operated
单选题The power and torque capability of the steering system must be such that the rudder can be swung from （）one side to（）the other side with the ship at maximum speed.A35°；35°B35°；30°C15°；15°D28°；60°
单选题According to Regulations, a power driven auxiliary steering gear for a vessel capable of a 12 knot service speed, must be able to meet the rudder movement requirements at which of the minimum vessel speeds listed below?（）A6 knotsB7 knotsC9 knotsD12 knots
单选题According to Regulations, a power driven auxiliary steering gear for a vessel capable of a 20 knot service speed, must be capable of producing a rudder movement at which of the minimum speeds listed below?（）A7 knotsB10 knotsC15 knotsD20 knots
单选题Under normal operating conditions, the rudder is hydraulically locked unless （）.Athe manual trick wheel is engaged for steeringBthe variable stroke pump is off strokeCa rudder order is given by the control systemDan electric power system failure occurs at the steering gear
单选题A power failure in the hydraulic system of a compact type steering gear would cause the rudder to（）Aswing 35°right or leftBremain locked in its last positionCmove to the mid-ship position automaticallyDjam against the rudder emergency stops
单选题In an electro-hydraulic steering system, under movement is maintained in close synchronization with the steering wheel position by means of the （）.Atrick-wheelBfollow-up controlCsix-way valveDRapson slide
单选题With reference to rules governing steering gear, which one of the following rules is incorrect? （）AIt is required that all ships are provided with two independent steering gear systems that is one main and one auxiliaryBThe auxiliary gear could be power operated in passenger shipsCThe auxiliary gear must be of adequate strength and sufficient to steer a ship at navigable speedDAll moving parts of the steering gear must be guarded against any possible damage
单选题Which of the following precautions must be taken if an electric immersion heater is used to keep the coolant in a diesel engine warm during the time the engine is secured?（）AThe coolant temperature must be maintained at 180℃BThe thermostatic bypass valves must be manually opened before the engine is startedCThe pressure cap must be removed while the engine is securedDElectrical power to the heater must be secured before the cooling system is drained
单选题According to the Robinson Graph, suddenly astern maneuvering of main engine during navigating will cause（）Arapid reduction of ship’s friction forceBshaft system over mechanical loadCsharp growth of the torque of diesel engineDpropeller torque change along J=0 curve
单选题On offshore drilling units，emergency lighting and each emergency power system must be tested at least once a（）.AdayBweekCmonthDyear