Refer to the above exhibit. Why is the 140.140.0.0 network not used as the gateway of last resort even though it is configured first?() A.The last default - network statement will always be preferred.B.A route to the 140.140.0.0 network does not exist in the routing table.C.Default - network selection will always prefer the statement with the lowest IP address.D.A router will load balance across multiple default - networks; repeatedly issuing the show ip route command would show the gateway of last resort changing between the two networks.
Refer to the above exhibit. Why is the 140.140.0.0 network not used as the gateway of last resort even though it is configured first?()
A.The last default - network statement will always be preferred.
B.A route to the 140.140.0.0 network does not exist in the routing table.
C.Default - network selection will always prefer the statement with the lowest IP address.
D.A router will load balance across multiple default - networks; repeatedly issuing the show ip route command would show the gateway of last resort changing between the two networks.
相关考题：
Refer to the exhibit. The routing protocols EIGRP and OSPF have been configured as indicated in the exhibit. Given the partial configuration of router R2, which network will be present in th e routing table of R4?（）A. Network BB. Network A and Network BC. Network AD. neither Network A nor Network B
Refer to the exhibit. OSPF is configured on all routers in the network. Area 5 is configured as an NSSA areA. The RIPv2 routes are redistributed into the OSPF domain on router R5. What two types of LSAs will be originated by router R5?（）A. type 1 Router LSAB. type 2 Network LSAC. type 3 Network Summary LSAD. type 4 ASBR Summary LSAE. type 5 AS External LSAF. type 7 NSSA External LSA
Refer to the exhibit. How would you confirm on R1 that load balancing is actually occurring on the default － netw ork (0.0.0.0)?() A. Use ping and the show ip route command to confirm the timers for each default network resets to 0.B. Load balancing does not occur over default networks; the second route will only be used for failover.C. Use an extended ping al ong with repeated show ip route commands to confirm the gateway of last resort address toggles back and forth.D. Use the traceroute command to an address that is not explicitly in the routing table.
Refer to the above exhibit. Why are the EIGRP neighbors for this router not learning the routes redistributed from OSPF?() A. Redistribution must be enabled mutually (in both directions) to work correctly.B. auto - summary causes the OSPF routes redistributed into EIGRP to be summarized; thus the OSPF network 116.16.34 is summarized to 116.3 4.0.0, which is already covered by the EIGRP protocol.C. Default metrics are not configured under EIGRP.D. Both routing protocols must have unique autonomous system numbers for redistribution to function correctly.
Refer to the exhibit. ROUTE.com has just implemented this EIGRP network. A network administrator came to you for advice while trying to implement load balancing across part of their EIGRP network. If the variance value is configured as 2 on all routers and all o ther metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths? （）A. 1B. 2C. 3D. 4E. 5
Refer to the exhibit. What statement is true base d upon the configuration in the exhibit? () A. CGMP version 2 is being used.B. The switch will use sparse mode first, dense mode second.C. A rendezvous point must be configured in order for the interface to operate in sparse mode.D. IGMP version 2 is being used.E. The rendezvous point is IP address 172.16.4.16.F. If a rendezvous point is configured, the interface cannot operate in dense mode.
Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q- complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached?（）A.VLANs have not been created yetB.An IP address must be configured for the portC.The port is currently configured for access modeD.The correct encapsulation type has not been configuredE.The no shutdown command has not been entered for the port
If IP routing is enabled, which two commands set the gateway of last resort to the default gateway?() A. ip default-gateway 0.0.0.0B. ip route 172.16.2.1 0.0.0.0 0.0.0.0C. ip default-network 0.0.0.0D. ip default-route 0.0.0.0 0.0.0.0 172.16.2.1E. ip route 0.0.0.0 0.0.0.0 172.16.2.1
Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?() A.data link layerB.application layerC.access layerD.session layerE.network layer
Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?（）A.The design will function as intendedB.Spanning-tree will need to be used.C.The router will not accept the addressing scheme.D.The connection between switches should be a trunk.E.The router interfaces must be encapsulated with the 802.1Q protocol.
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?() A.10.0.0.0B.10.0.0.254C.192.223.129.0D.192.223.129.254
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）A、As numbers must be changed to match on all the routers.B、Loopback interface must be configured so a DR is elected.C、The no auto-summary command is needed on Router A and Router C.D、Router B needs to have two network statements, one for each connected network.
Multicast is being deployed in the network， and only ip pim sparse-dense mode has been configured on all interfaces in the network to support a new video streaming application. No other multicast configuration was applied anywhere in the network. Since enabling multicast， the network monitoring tools show periodic spikes in link utilization throughout the network， even in areas where the video application is not being used. What could be a possible cause？（）A、PIM sparse mode is being used.B、PIM dense mode is being used.C、The BGP multicast address family has not been configured.D、IGMP version 3 is being used.E、IP PIM neighbor filters have not been applied.
The command "ip route 192.168.24.64 255.255.255.192 192.168.8.2 100" was configured on a router named TK1. No routing protocols or other static routes are configured on the Corporate router yet.Based on this information, which statement is true about this command?（）A、This command sets a gateway of last resort for the TK1 router.B、The number 100 indicates the number of hops to the destination network.C、The interface with IP address 192.168.8.2 is on the TK1 router.D、The command creates a static route for all IP traffic with the source address 192.168.24.64.E、Packets destined for host 192.168.24.124 will be sent to 192.168.8.2.F、None of the above
Cat6500（config）# router ospf 1 Cat6500（config-router）# network 0.0.0.0 255.255.255.255 area 0 Cat6500（config-router）# nsf Cat6500（config-router）#end Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series Switch with redundant supervisor engines. The default CEF configuration is unchanged. After testing， user traffic is interrupted and NSF is not operational. What is the most likely reason？ （）A、CEF was not properly configured.B、OSPF was not properly configured for graceful restart.C、Stateful switchover was not correctly configured.D、NSF for OSPF is only supported in area 0.
Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0". Whic h of the following is most likely to have caused this output to occur on R1?（）A、R1 has been configured with an ip default- network 2.0.0.0 command.B、R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.C、R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.D、Another router has been configured with an ip default - network 2.0.0.0 command.E、Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
Given a new implementation， which of the following procedures should be used to determine a default gateway’s IP address？（）A、The address will always end in 255.B、The address will always be the first interface’s IP addressC、The address will always be the network with a 1 as the final octet.D、It is important to consult with the network administrator prior to making assumptions regarding the default gateway’s IP addres
Your network contains a server named Server1. Server1 runs Windows Server 2008 R2 and has a single network connection. The connection is configured to use a default gateway address of 10.0.0.1.The default gateway has a metric value of 100.You configure a second default gateway that uses an address of 10.0.0.2.You need to ensure that 10.0.0.2 is only used as the default gateway if 10.0.0.1 is unreachable. What should you do？（）A、For the interface, set the interface metric to 100.B、For the 10.0.0.2 gateway, set the metric to 50.C、For the 10.0.0.2 gateway, set the metric to 200.D、For the 10.0.0.1 gateway and the 10.0.0.2 gateway, enable automatic metric.
单选题The command "ip route 192.168.24.64 255.255.255.192 192.168.8.2 100" was configured on a router named TK1. No routing protocols or other static routes are configured on the Corporate router yet.Based on this information, which statement is true about this command?（）AThis command sets a gateway of last resort for the TK1 router.BThe number 100 indicates the number of hops to the destination network.CThe interface with IP address 192.168.8.2 is on the TK1 router.DThe command creates a static route for all IP traffic with the source address 192.168.24.64.EPackets destined for host 192.168.24.124 will be sent to 192.168.8.2.FNone of the above
单选题Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?（）A data link layerB application layerC access layerD session layerE network layer
单选题Given a new implementation， which of the following procedures should be used to determine a default gateway’s IP address？（）AThe address will always end in 255.BThe address will always be the first interface’s IP addressCThe address will always be the network with a 1 as the final octet.DIt is important to consult with the network administrator prior to making assumptions regarding the default gateway’s IP addres
单选题Refer to the exhibit. A network technician is asked to design a small network with redundancy. The exhibit represents this design, with all hosts configured in the same VLAN. What conclusions can be made about this design?（）A The design will function as intendedB Spanning-tree will need to be used.C The router will not accept the addressing scheme.D The connection between switches should be a trunk.E The router interfaces must be encapsulated with the 802.1Q protocol.
单选题Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）AAs numbers must be changed to match on all the routers.BLoopback interface must be configured so a DR is elected.CThe no auto-summary command is needed on Router A and Router C.DRouter B needs to have two network statements, one for each connected network.
单选题Refer to the exhibit. Which statement is true about a voice VLAN？（）A Physically the voice network and the data network are separate.B The voice traffic will normally be on a different IP subnet than will the data traffic.C End user intervention is necessary to place the phone into the proper VLAN.D The same security policy should be implemented for both voice and data traffic.E The data VLAN must be configured as the native VLAN.
多选题If IP routing is enabled, which two commands set the gateway of last resort to the default gateway?（）Aip default-gateway 0.0.0.0Bip route 172.16.2.1 0.0.0.0 0.0.0.0Cip default-network 0.0.0.0Dip default-route 0.0.0.0 0.0.0.0 172.16.2.1Eip route 0.0.0.0 0.0.0.0 172.16.2.1
单选题Refer to the exhibit. Which statement is true about a voice VLAN？（）A Physically the voice network and the data network are separateB The voice traffic will normally be on a different IP subnet than will the data trafficC End user intervention is necessary to place the phone into the proper VLAND The same security policy should be implemented for both voice and data trafficE The data VLAN must be configured as the native VLAN
单选题As a last resort，a tourniquet can be used to（）.Ahold a victim in a stretcherBstop uncontrolled bleedingChold a large bandage in placeDrestrain a delirious victim