To securely transport EIGRP traffic, a network administrator will build VPNs between sites. What is the best method to accomplish the transport of EIGRP traffic?() A. IPSec in tunnel modeB. IPSec in transport modeC. GRE with IPSec in transport modeD. GRE with IPSec in tunnel mode
To securely transport EIGRP traffic, a network administrator will build VPNs between sites. What is the best method to accomplish the transport of EIGRP traffic?()
A. IPSec in tunnel mode
B. IPSec in transport mode
C. GRE with IPSec in transport mode
D. GRE with IPSec in tunnel mode
相关考题：
An administrator replaced a router with a switch. End users are able to access network shares butare not able to access the Internet. Which of the following is the BEST explanation why the usersare unable to access the Internet?（）A. Router routes traffic between different networks and a switch does notB. The new switch is faulty and needs to be replaced and configured correctlyC. The firewall needs to be setup to allow traffic to reach the InternetD. The switch needs to be setup to forward data traffic to the Internet
After implementing EIGRP on your network, you issue the show ip eigrp traffic command on router C. The following output is shown:What information can you determine about this network?() A. The network is stableB. There is a flapping link or interface, and router C knows an alternate path to the networkC. There is a flapping link or interf ace, and router C does not know an alternate path to the networkD. EIGRP is not working correctly on router CE. There is not enough information to make a determination
After implementing EIGRP on your network, you issue the show ip eigrp traffic command on router C. The following output is shown:What can you conclude about this network? () A. The network has been stable for at least the last 45 minutesB. There is a flapping link or interf ace, and router C knows an alternate path to the networkC. There is a flapping link or interface, and router A does not know an alternate path to the networkD. EIGRP is not working correctly on router CE. There is not enough information to make a determination
Refer to the exhibit. You want to use all the routes in the EIGRP topology for IP load balancing. Which two EIGRP subcommands wou ld you use to accomplish this goal?() A. traffic - share balancedB. distanceC. maximum- pathsD. default - networkE. variance
Refer to the exhibit. A Boston company bought the asse ts of a New York company and is trying to route traffic between the two data networks using EIGRP over EoMPLS. As a network consultant, you were asked to verify the interoperability of the two networks. From the show ip route command output, what can yo u tell the customer about the traffic flow between the subnet in New York (172.16.8.0/24) and the subnets in Boston (172.16.16.0/24 and 10.10.16.0/24)?（）A. Traffic is flowing between the 172.16.8.0 subnet and subnets 172.16.16.0 and 10.10.16.0 and no configuration changes are needed.B. Auto - summary must be disabled on N1 and B1 before traffic can flow between the 172.16.8.0 subnet and subnets 172.16.16.0 and 10.10.16.0.C. Traffic will flow between the 172.16.8.0 subnet and 172.16.16.0 without any further configuration changes. However, auto - summary must be disabled on N1 and B1 before traffic can flow between the 172.16.8.0 subnet and the 10.10.16.0 subnet.D. Auto - summary must be disabled on N1 and B1 before traffic can flow between the 172.16 .8.0 subnet and the 172.16.16.0 subnet. However, traffic will flow between the 172.16.8.0 subnet and 10.10.16.0 without any further configuration changes.
Refer to the exhibit. ROUTE.com has just implemented this EIGRP network. A network administrator came to you for advice while trying to implement load balancing across part of their EIGRP network. If the variance value is configured as 2 on all routers and all o ther metric and K values are configured to their default values, traffic from the Internet to the data center will be load balanced across how many paths? （）A. 1B. 2C. 3D. 4E. 5
Refer to the exhibit.The actual speed of the serial links between R2 and R3 are 256 kb/s and 512k b/s respectively. When configuring EIGRP on routers R2 and R3, the network administrator configured the bandwidth of both serial interfaces to 512 kb/s. What will be the effect?（）A. EIGRP will overutilize the 512 kb/s link.B. The interface delay value used in the EIGRP metric calculation will be inaccurate on the 256k b/s serial interface.C. The amount of bandwidth used for EIGRP routing protocol traffic on the 256 kb/s link can become excessive.D. EIGRP can load balance between the two serial links only if the variance is set to 2 or higher.E. Unequal cost load balancing will be disabled.
What parameters must you specify when you enable EIGRP routing?() A. The broadcast address, and AS numberB. The network number and AS numberC. EIGRP routing, network number and passive interfaceD. EIGRP routing, network number, and AS
A virtual (71) network, or VPN, is an encrypted connection over the Internet from a device to a network. The encrypted connection helps ensure that sensitive data is safely (72). It prevents (73) people fromeavesdropping on the traffic and allows the user to conduct work remotely. Traffic on the virtual network is sent securely by establishing an encrypted connection across the Internet known as a (74).A remote access VPN securely connects a device outside the corporate office. A site-to-site VPN connects the corporate office to branch offices over the Internet. Site-to-site VPNs are used when distance makes it impractical to have direct network connections between these offices. Think of site-to-site access as (75) to network. A.encodedB.encryptedC.storedD.transmitted
Overlay Transport Virtualization （OTV） uses the Authoritative Edge Device （AED） to perform which tasks？（）A、 The AED is responsible for sending all unicast traffic in a site， while either node in a site can transmit multicast and broadcast.B、 The AED is responsible for load balancing all traffic for all VLANs across the transport network.C、 The AED is responsible for handling all unicast， broadcast， and multicast traffic for a given VLAN within a site.D、 The AED is responsible for MAC address dispute contention for a given VLAN.
To securely transport EIGRP traffic， a network administrator will build VPNs between sites. Whatis the best method to accomplish the transport of EIGRP traffic？（）A、 IPSec in tunnel modeB、 IPSec in transport modeC、 GRE with IPSec in transport modeD、 GRE with IPSec in tunnel mode
What is a static packet-filtering firewall used for ？（）A、It validates the fact that a packet is either a connection request or a data packet belonging to a connectionB、It evaluates network packets for valid data at the application layer before allowing connectionsC、It analyzes network traffic at the network and transport protocol layersD、It keeps track of the actual communication process through the use of a state table
What parameters must you specify when you enable EIGRP routing?（）A、The broadcast address, and AS numberB、The network number and AS numberC、EIGRP routing, network number and passive interfaceD、EIGRP routing, network number, and AS
Which of the following may be the disadvantages of road transport？（）A、Transport subject to traffic delaysB、Transport subject to breakdownC、Goods susceptible to damage through careless drivingD、Bad weather
If voice and data traffic will be sent and received via a WAN links， what must be configured to provide a certain amount of dedicated bandwidth and to prioritize the voice traffic over other types of network traffic？（）A、IPSec VPNB、QoS mechanismC、FirewallD、NATE、EIGRP routing protocolF、Static routing
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP addresses of the devices with which the router has established adjacency. The retransmit interval and the queue counts for the adjacent routers also need to be checked. What command will display the required information?（）A、Router# show ip eigrp adjacencyB、Router# show ip eigrp topologyC、Router# show ip eigrp interfacesD、Router# show ip eigrp neighbors
While troubleshooting an EIGRP routing problem you notice that one of the company routers havegenerated a large number of SIA messages. What are two possible causes for EIGRP Stuck-In-Active routes？（）A、Some query or reply packets are lost between the routersB、The neighboring router starts receiving route updates from this routerC、A failure causes traffic on a link between two neighboring routers to flow in only one direction（unidirectional link）D、The neighboring router stops receiving ACK packets from this router
When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful.What is the next thing that should be checked?（）A、Verify that the EIGRP hello and hold timers match exactly.B、Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP peer command.C、Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP traffic command.D、Verify that EIGRP is enabled for the appropriate networks on the local and neighboring router.
To securely transport EIGRP traffic, a network administrator will build VPNs between sites. What is the best method to accomplish the transport of EIGRP traffic?（）A、IPSec in tunnel modeB、IPSec in transport modeC、GRE with IPSec in transport modeD、GRE with IPSec in tunnel mode
An administrator replaced a router with a switch. End users are able to access network shares butare not able to access the Internet. Which of the following is the BEST explanation why the usersare unable to access the Internet?（）A、Router routes traffic between different networks and a switch does notB、The new switch is faulty and needs to be replaced and configured correctlyC、The firewall needs to be setup to allow traffic to reach the InternetD、The switch needs to be setup to forward data traffic to the Internet
You work as the enterprise exchange administrator at TestKing.com. TestKing.com makes use of Microsoft Exchange Server messaging solution. The TestKing.com network consists of two offices that areconfigured as an Active Directory site named Site A and Site B. You are planning to configure an Exchange Server 2010 environment in both sites. A direct Internet connections resides from both sites with a direct link. The connection between these two sites is via a highspeed WAN link. You have received instructions from the CIO to install Exchange Server 2010 Mailboxserves in both sites. You thus need to ensure that the Hub Transport server is automatically load balancedat every site as well as ensuring that outbound e-mail messages is delivered in the event of a singleserver failure. You should also ensure that the least amound of servers is deployed. What should you do？（）A、The best option is to install two Hub Transport servers and create and configure one Send connector.B、The best option is to install one Edge Transport server and create two Send connectors.C、The best option is to install two Edge Transport servers and create two Send connectors.D、The best option is to install one Hub Transport server and create and configure one Send connector.
单选题You work as the enterprise exchange administrator at TestKing.com. TestKing.com makes use of Microsoft Exchange Server messaging solution. The TestKing.com network consists of two offices that areconfigured as an Active Directory site named Site A and Site B. You are planning to configure an Exchange Server 2010 environment in both sites. A direct Internet connections resides from both sites with a direct link. The connection between these two sites is via a highspeed WAN link. You have received instructions from the CIO to install Exchange Server 2010 Mailboxserves in both sites. You thus need to ensure that the Hub Transport server is automatically load balancedat every site as well as ensuring that outbound e-mail messages is delivered in the event of a singleserver failure. You should also ensure that the least amound of servers is deployed. What should you do？（）AThe best option is to install two Hub Transport servers and create and configure one Send connector.BThe best option is to install one Edge Transport server and create two Send connectors.CThe best option is to install two Edge Transport servers and create two Send connectors.DThe best option is to install one Hub Transport server and create and configure one Send connector.
单选题To securely transport EIGRP traffic， a network administrator will build VPNs between sites. Whatis the best method to accomplish the transport of EIGRP traffic？（）A IPSec in tunnel modeB IPSec in transport modeC GRE with IPSec in transport modeD GRE with IPSec in tunnel mode
单选题You add the following commands into a routed topology： router eigrp 1 variance 3 traffic-share min across-interfaces. Users now complain about voice quality in your VoIP system. What should be done？ （）A Add the command： router eigrp 1 traffic-share voice interface fast 0/0B Reconfigure EIGRP to recognize voice packetsC Remove the variance from the configurationD Reconfigure the VoIP system to use RTP sequence number headersE Use an H '323 gatekeeper for your VoIP system to negotiate an H'245 uneven packet bufferF Reconfigure EIGRP to version 2
单选题You work as the exchange administrator at TestKing.com. The TestKing.com network contains an Exchange Server 2010 Organization. You are responsible for managing the Exchange network for TestKing.com The organization contains three Exchange Server 2010 Edge Transport Servers and seven ExchangeServer 2010 Hub Transport servers. The Edge Transport server is used to transfer e-mail from your organization to the Internet. During the course of day you receive an instruction form the CIO to ensure that all clients is able to send encrypted messages to other organizations over the Internet as well asensuring that communications between the Hub Transport servers and the Edge Transport servers isencrypted. What should you do？（）AYour best option would be to deploy SMTP over SSL.BYour best option would be to implement Security/Multipurpose Internet Mail Extensions （S/MINE）.CYour best option would be to deploy IPsec.DYour best option would be to implement Domain Securtiy.
多选题While troubleshooting an EIGRP routing problem you notice that one of the company routers havegenerated a large number of SIA messages. What are two possible causes for EIGRP Stuck-In-Active routes？（）ASome query or reply packets are lost between the routersBThe neighboring router starts receiving route updates from this routerCA failure causes traffic on a link between two neighboring routers to flow in only one direction（unidirectional link）DThe neighboring router stops receiving ACK packets from this router