Running both IPv4 and IPv6 on a router simultaneously is known as what?() A.4to6 routingB.6to4 routingC.binary routingD.dual-stack routingE.NextGen routing
Running both IPv4 and IPv6 on a router simultaneously is known as what?()
A.4to6 routing
B.6to4 routing
C.binary routing
D.dual-stack routing
E.NextGen routing
相关考题：
During the IPv6 autoconfiguration, what does the device append to the 64－ bit prefix that it receives from the router to create its IPv6 address?() A. a pseudora ndom generated numberB. its locally configured IPv4 addressC. the DHCP - supplied device IDD. its MAC address
Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? () A. IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.B. IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.C. Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.D. Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.E. IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.
You wish to upgrade the IOS of a router without removing the image currently installed.What command will display the amount of memory that is being used by the current IOS image and whether there is enough room available to hold both the current and new images?（）A. Router# show versionB. Router# show flashC. Router# show memoryD. Router# show buffersE. Router# show running-configF. All of the above
What is known as "one－to－nearest" addressing in IPv6?() A. global unicastB. anycastC. multicastD. unspecified address
the network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two valid reasons for adopting ipv6 over ipv4?() A. telnet access does not require a passwordB. natC. no broadcastD. chanage of destination address in the ipv6 headerE. chanage of source address in the ipv6 headerF. autoconfiguration
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?() A.The loopback addresses are on different subnetsB.The value of the dead timers on the router are differentC.Route summarization is enabled on both routersD.The process indentifier on router A is different than the process identifier on router B
Router A is unable to reach Router B.Both routers are running ios version 12.0.After reviewing the command output and graphic,what is the most likely cause of the problem?() A.incorrect bandwidth configurationB.incorrect LMI configurationC.incorrect map statementD.incorrect IP address
During the IPv6 autoconfiguration, what does the device append to the 64- bit prefix that it receives from the router to create its IPv6 address?（）A、a pseudora ndom generated numberB、its locally configured IPv4 addressC、the DHCP - supplied device IDD、its MAC address
Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? （）A、IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.B、IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.C、Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.D、Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.E、IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.
Which of the following solutions will encapsulate IPv6 packets with IPv4 headers？（）A、Create an IPv4 tunnel and assign the tunnel IPv6 addressesB、Create IPv4 interfaces on both ends of the network， and use either static routes or a routingprocess to direct IPv6 packets through those interfacesC、IPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatibleD、Create IFV6 interfaces on both ends of the network， and use static routes to point the IPv4address to those interfacesE、Use an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that processF、Create an IPv4 tunnel and use the tunnel mode ipv6ip command
the network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two valid reasons for adopting ipv6 over ipv4?（）A、telnet access does not require a passwordB、natC、no broadcastD、chanage of destination address in the ipv6 headerE、chanage of source address in the ipv6 headerF、autoconfiguration
Your company is researching a new application that runs over IPv6， but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network， but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation？ （）A、 Tunnel IPv6 over IPv4 to connect far-end IPv6 networksB、 Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possibleC、 Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possibleD、 What is the meaning of EUI-64 and how does it work？E、 Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
What is known as "one-to-nearest" addressing in IPv6?（）A、global unicastB、anycastC、multicastD、unspecified address
Company network is implemting IPv6 into their existing IPv4 netwrok. Which statement is trueabout incorporating IPv6 into an already existing IPv4 network？（）A、Only OSPF version 3 can be utilized for routing IPv4 and IPv6B、IPv4 and IPv6 networks can be routed simultaneouslyC、IPv6 can be routed using the same routing protocol versions as IPv4D、A router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route themE、None of the other alternatives apply
Router R-1 is configured for BGP routing as shown below： router bgp 65300network 27.0.0.0neighbor 192.23.1.1 remote-as 65300 From the perspective of router R-1， what kind of router is the router with IP address 192.23.1.1？（）A、A peer router running IBGPB、A peer router running EBGPC、A community member running IBGPD、A peer group member running IBGPE、A peer group member running EBGP
Running both IPv4 and IPv6 on a router simultaneously is known as what?（）A、4to6 routingB、6to4 routingC、binary routingD、dual-stack routingE、NextGen routing
You wish to upgrade the IOS of a router without removing the image currently installed.What command will display the amount of memory that is being used by the current IOS image and whether there is enough room available to hold both the current and new images?（）A、Router# show versionB、Router# show flashC、Router# show memoryD、Router# show buffersE、Router# show running-configF、All of the above
多选题Your company is researching a new application that runs over IPv6， but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network， but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation？ （）ATunnel IPv6 over IPv4 to connect far-end IPv6 networksBExplain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possibleCExplain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possibleDWhat is the meaning of EUI-64 and how does it work？ETunnel IPv4 over IPv6 to connect far-end IPv4 networks.
单选题Router A is unable to reach Router B.Both routers are running ios version 12.0.After reviewing the command output and graphic,what is the most likely cause of the problem?（）A incorrect bandwidth configurationB incorrect LMI configurationC incorrect map statementD incorrect IP address
多选题Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? （）AIPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.BIPv6 provides for more host IP addresses but IPv4 provides for more network addresses.CHosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.DHost configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.EIPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.
单选题Company network is implemting IPv6 into their existing IPv4 netwrok. Which statement is trueabout incorporating IPv6 into an already existing IPv4 network？（）AOnly OSPF version 3 can be utilized for routing IPv4 and IPv6BIPv4 and IPv6 networks can be routed simultaneouslyCIPv6 can be routed using the same routing protocol versions as IPv4DA router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route themENone of the other alternatives apply
多选题The network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two validreasons for adopting ipv6 over ipv4？（）Atelnet access does not require a passwordBnatCno broadcastDchanage of destination address in the ipv6 headerEchanage of source address in the ipv6 headerFautoconfiguration
单选题During the IPv6 autoconfiguration, what does the device append to the 64- bit prefix that it receives from the router to create its IPv6 address?（）Aa pseudora ndom generated numberBits locally configured IPv4 addressCthe DHCP - supplied device IDDits MAC address
单选题Router A is unable to reach Router B.Both routers are running ios version 12.0.After reviewing the command output and graphic,what is the most likely cause of the problem?（）Aincorrect bandwidt h configurationBincorrect LMI configurationCincorrect map statementDincorrect IP address
多选题Your company is researching a new application that runs over IPv6， but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network， but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation？（）ATunnel IPv6 over IPv4 to connect far-end IPv6 networks.BExplain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possible.CExplain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possible.DWhat is the meaning of EUI-64 and how does it work？ETunnel IPv4 over IPv6 to connect far-end IPv4 networks.
单选题Router R-1 is configured for BGP routing as shown below： router bgp 65300network 27.0.0.0neighbor 192.23.1.1 remote-as 65300 From the perspective of router R-1， what kind of router is the router with IP address 192.23.1.1？（）AA peer router running IBGPBA peer router running EBGPCA community member running IBGPDA peer group member running IBGPEA peer group member running EBGP
单选题Which of the following solutions will encapsulate IPv6 packets with IPv4 headers？（）ACreate an IPv4 tunnel and assign the tunnel IPv6 addressesBCreate IPv4 interfaces on both ends of the network， and use either static routes or a routingprocess to direct IPv6 packets through those interfacesCIPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatibleDCreate IFV6 interfaces on both ends of the network， and use static routes to point the IPv4address to those interfacesEUse an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that processFCreate an IPv4 tunnel and use the tunnel mode ipv6ip command