单选题An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）ASATA to SCSIBSATA to HBACSATA to USBDSATA to SAS
单选题
An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）
A
SATA to SCSI
B
SATA to HBA
C
SATA to USB
D
SATA to SAS
参考解析
解析：
暂无解析
相关考题：
Which of the following internal storage media types has the GREATEST storage capacity?() A. Compact flash driveB. SATA hard driveC. Blu-Ray driveD. SDLT Tape drive
A client purchased a new internal hard drive to act as a second drive on a legacy machine. When the client attempts to install the drive, the cable connector on the new drive is not compatible with the available IDE cables. It is determined that the client has purchased a SATA hard drive. Which of the following would the technician recommend as the BEST solution to this situation?（）A、Have the client purchase a SATA compatible system board.B、Have the client purchase a SATA to IDE conversion kit.C、Have the client return the drive and purchase an IDE compatible drive.D、Have the client purchase a SCSI to SATA conversion kit.
A system administrator has a failed disk drive that is mirrored to another disk drive. They successfully removed the logical volume copies off of the failed disk drive. Which of the following commands should be used to remove the failed disk drive from the volume group？（）A、chvgB、rmdevC、reducevgD、exportvg
Which of the following steps would be performed FIRST to install a fresh copy of Windows 7Professional on a new hard drive?（）A、Format the partitionB、Load any RAID or SATA drivers neededC、Partition the driveD、Configure Windows settings
An administrator has removed a SATA hard drive from a failed server. Which of the following adapters would MOST likely be used by the administrator to transfer files from the drive to a laptop？（）A、SATA to SCSIB、SATA to HBAC、SATA to USBD、SATA to SAS
Which of the following will occur if a laptop SATA 1 drive is installed on a SATA 2 controller?（）A、The drive will run at the lower SATA 1 speed.B、The drive will not work due to incompatibility.C、The drive will run at the higher SATA 2 speed.D、The drive will have intermittent POST errors.
Which of the following is eliminated when using SATA instead of PATA technology？（）A、Jumper selectionB、Power connectorC、Data port connectorD、Hard drive LEDs
Which of the following is the correct connector for an internal floppy drive?（）A、50-pin SCSIB、40-pin ribbonC、34-pin ribbonD、4-pin SATA
An administrator is configuring RAID 1 in a server. The administrator has been given two matching 80GB SATA-2 hard drives， two SATA-2 cables， and a SATA-2 RAID adapter. How should the administrator BEST configure these drives？（）A、Install one drive on the first channel and install the second drive on the second channel.B、Install one drive on the first cable， on the first channel. Install the second drive on the secondcable， on the second channel.C、Install both drives on the same channel. Cable both drives as the primary master on the samecable.D、Install both drives on the same channel. On the same cable one drive should be set as primaryslave and the other drive as the primary master.
A user has recently added a second IDE CD-RW drive to a machine in addition to the primary DVD-ROM drive. The drive opens and closes; however, they do not see it show up in Windows. Which of the following is the MOST likely cause?（）A、The drive jumper settings are incorrect.B、The drive is not receiving power from PSU.C、Windows only supports one optical drive.D、The user connected the drive with a SATA cable.
An administrator adds a new SATA hard drive into a functional server and attempts to boot the server. The server will no longer boot into the operating system. The administrator checks all the connections and reboots the server. The server still will not load the operating system. Which of the following is the MOST probable cause？（）A、The BIOS is set with the wrong boot order.B、The jumpers have not been set on the hard drive.C、The hard drive is not compatible with the system board.D、The boot.ini file needs to be modified.
Which of the following connector interfaces is MOST likely used to connect several peripheraldevices such as printers, digital cameras, and scanners?（）A、ParallelB、USBC、FibreD、SATA3
Which of the following internal storage media types has the GREATEST storage capacity?（）A、Compact flash driveB、SATA hard driveC、Blu-Ray driveD、SDLT Tape drive
A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem？（）A、Windows cannot be booted from a controller card.B、The hard drive must have Windows reinstalled because a new controller card was installed.C、The SATA controller card was not set as a boot device in the computer BIOS.D、The new controller must have the correct jumper settings for Windows mode.
Which of the following drive types can be combined in a single EXP5000 expansion unit?（）A、SSD, SATA and FC only B、SSD, SAS and FDE only C、SSD, FDE, SATA and FC only D、SSD, SAS, FDE, FC and SATA
单选题Which of the following is the correct connector for an internal floppy drive?（）A50-pin SCSIB40-pin ribbonC34-pin ribbonD4-pin SATA
单选题A customer needs approximately 24 TB of RAW storage for some media files. SATA or nearline SAS drives are the obvious choice but rack space and budget are dominating factors. Which of thefollowing choices would be the best solution for this customer?（）A N6210 with 12 2 TB SATA drives B DS5020 with 24 1 TB SATA drives C Storwize V7000 with 24 1 TB SATA drives D DS3500 with 12 2 TB nearline SAS drives
单选题Which of the following will occur if a laptop SATA 1 drive is installed on a SATA 2 controller?（）AThe drive will run at the lower SATA 1 speed.BThe drive will not work due to incompatibility.CThe drive will run at the higher SATA 2 speed.DThe drive will have intermittent POST errors.
单选题An administrator adds a new SATA hard drive into a functional server and attempts to boot the server. The server will no longer boot into the operating system. The administrator checks all the connections and reboots the server. The server still will not load the operating system. Which of the following is the MOST probable cause？（）AThe BIOS is set with the wrong boot order.BThe jumpers have not been set on the hard drive.CThe hard drive is not compatible with the system board.DThe boot.ini file needs to be modified.
单选题A client purchased a new internal hard drive to act as a second drive on a legacy machine. When the client attempts to install the drive, the cable connector on the new drive is not compatible with the available IDE cables. It is determined that the client has purchased a SATA hard drive. Which of the following would the technician recommend as the BEST solution to this situation?（）AHave the client purchase a SATA compatible system board.BHave the client purchase a SATA to IDE conversion kit.CHave the client return the drive and purchase an IDE compatible drive.DHave the client purchase a SCSI to SATA conversion kit.
单选题A user has recently added a second IDE CD-RW drive to a machine in addition to the primary DVD-ROM drive. The drive opens and closes; however, they do not see it show up in Windows. Which of the following is the MOST likely cause?（）AThe drive jumper settings are incorrect.BThe drive is not receiving power from PSU.CWindows only supports one optical drive.DThe user connected the drive with a SATA cable.
单选题Which of the following drive types can be combined in a single EXP5000 expansion unit?（）ASSD, SATA and FC only BSSD, SAS and FDE only CSSD, FDE, SATA and FC only DSSD, SAS, FDE, FC and SATA
单选题A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem？（）AWindows cannot be booted from a controller card.BThe hard drive must have Windows reinstalled because a new controller card was installed.CThe SATA controller card was not set as a boot device in the computer BIOS.DThe new controller must have the correct jumper settings for Windows mode.
单选题Which of the following internal storage media types has the GREATEST storage capacity？（）A Compact flash driveB SATA hard driveC Blu-Ray driveD SDLT Tape drive
单选题Which of the following steps would be performed FIRST to install a fresh copy of Windows 7Professional on a new hard drive?（）AFormat the partitionBLoad any RAID or SATA drivers neededCPartition the driveDConfigure Windows settings
单选题An administrator is configuring RAID 1 in a server. The administrator has been given two matching 80GB SATA-2 hard drives， two SATA-2 cables， and a SATA-2 RAID adapter. How should the administrator BEST configure these drives？（）AInstall one drive on the first channel and install the second drive on the second channel.BInstall one drive on the first cable， on the first channel. Install the second drive on the secondcable， on the second channel.CInstall both drives on the same channel. Cable both drives as the primary master on the samecable.DInstall both drives on the same channel. On the same cable one drive should be set as primaryslave and the other drive as the primary master.
单选题A system administrator has a failed disk drive that is mirrored to another disk drive. They successfully removed the logical volume copies off of the failed disk drive. Which of the following commands should be used to remove the failed disk drive from the volume group？（）AchvgBrmdevCreducevgDexportvg