多选题If an edge Label Switch Router （LSR） is properly configured，which three combinations are possible？（）AA received IP packet is forwarded based on the IP destination address and the packet is sent as an IP packet.BAn IP destination exists in the IP forwarding table. A received labeled packet is dropped because the label is not found in the LFIB table.CThere is an MPLS label-switched path toward the destination. A received IP packet is dropped because the destination is not found in the IP forwarding table.DA received IP packet is forwarded based on the IP destination address and the packet is sent as a labeled packet.EA received labeled IP packet is forwarded based upon both the label and the IP address.FA received labeled packet is forwarded based on the label. After the label is swapped，the newly labeled packet is sent.
多选题
If an edge Label Switch Router （LSR） is properly configured，which three combinations are possible？（）
A
A received IP packet is forwarded based on the IP destination address and the packet is sent as an IP packet.
B
An IP destination exists in the IP forwarding table. A received labeled packet is dropped because the label is not found in the LFIB table.
C
There is an MPLS label-switched path toward the destination. A received IP packet is dropped because the destination is not found in the IP forwarding table.
D
A received IP packet is forwarded based on the IP destination address and the packet is sent as a labeled packet.
E
A received labeled IP packet is forwarded based upon both the label and the IP address.
F
A received labeled packet is forwarded based on the label. After the label is swapped，the newly labeled packet is sent.
参考解析
解析：
暂无解析
相关考题：
The ERX Edge Router is configured for PPP over Ethernet without using VLAN tagging. How many PPP over Ethernet major interfaces can be configured per port?() A.1B.100C.2048D.4096
An ERX Edge Router is operating in an MPLS network using interface label space.What is used to make a forwarding decision?() A. EXP bitsB. VPI / VCIC. shim headerD. SNAP header
Which two authentication protocols can be configured for RIP on an ERX Edge Router? () A.AB.BC.CD.D
Which configuration command removes all log filters currently configured on the ERX Edge Router?() A.AB.BC.CD.D
The router SIS-R has been configured in a CIS network. As a network administrator, you were required to enable MPLS on that router.Which of the following description is making sense on the basis of the output information?（）A. CEF switching is only needed to forward labeled packets.B. CEF switching is needed on both ingress and egress interfaces on which MPLS is enabled.C. Interface-level CEF switching is needed only on egress interfaces that are sending IP packets on which the egress LSR performs the label imposition process.D. Interface-level CEF switching is needed only on ingress interfaces that are receiving IP packets on which the ingress LSR performs the label imposition process.
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）A. Switch1(config)# i nterface fa0 /1 Switch1(config-if)# ip address 192.168.24.3.255.255.255.0B. Switch1 (config)#interface fa0/1 Switch1 (config-if)# switchport mode trunkC. Switch 1 (config)# i nterface fa0 /1 Switch1 (config-if)# duplex full Switch1 (config-if)# speed 100D. Switch1 (config-if)# default-gateway 192.168.24.1E. Switch1 (config)# line con 0 Switch1(config-line)# password cisco Switch1 (config-line)#login
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A. oneB. threeC. twoD. zero
Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? () A.The Router1 WAN port is configured as a trunking port.B.The Router1 port connected to Switch1 is configured using subinterfaces.C.The Router1 port connected to Switch1 is configured as 10 Mbps.D.The Switch1 port connected to Router1 is configured as a trunking port.E.The Switch1 port connected to Host B is configured as an access port.F.The Switch1 port connected to Hub1 is configured as full duplex.
Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs. What is needed to allow communication between VLANs（）。A、a switch with a trunk link that is configured between the switchesB、a router with an IP address on the physical interface that is connected to the switchC、a switch with an access link that is configured between the switchesD、a router with subinterfaces configured on the physical interface that is connected to the switch
Which ERX Edge Router component is responsible for all packet processing and packet forwarding？（）A、I/O adapterB、line moduleC、shared memory fabricD、switch route processor
The Frame Relay network in the diagram is not functioning properly. What is the cause of the problem?（）A、The Gallant router has the wrong LMI type configuredB、Inverse ARP is providing the wrong PVC information to the Gallant routerC、The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf commandD、The frame-relay map statement in the Attalla router for the PVC to Steele is not correctE、The IP address on the serial interface of the Attalla router is configured incorrectly
You are conducting a cdp-based discovery using an edge switch for the seed. there is a router between the switch and the wlse. none of the access points are discovered， and the discovery log shows the switch is snmp unreachable. What is the problem？（）A、the snmp communities on the switch do not match the wlse.B、the snmp communities on the access points do not match the wlse.C、the snmp communities on the access points do not match the switch.D、the snmp communities on the router do not match the wlse.
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location？ （）A、The switch must be configured with an IP address,subnet mask,and default gateway.B、The switch must be connected to a router over a VLAN trunk.C、The switch must be reachable through a port connected to its management VLAN.D、The switch console port must be connected to the Ethernet LAN.E、The switch management VLAN must be created and have a membership of at least one switch port.F、The switch must be fully configured as an SNMP agent.
what is the cause of this problem?（）A、The OSPF area is not configured properly.B、The priority on R1 should be set higher.C、The cost on R1 should be set higher.D、The hello and dead timers are not configured properly.E、A backup designated router needs to be added to the network.F、The OSPF process ID numbers must match.
Cat6500（config）# router ospf 1 Cat6500（config-router）# network 0.0.0.0 255.255.255.255 area 0 Cat6500（config-router）# nsf Cat6500（config-router）#end Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series Switch with redundant supervisor engines. The default CEF configuration is unchanged. After testing， user traffic is interrupted and NSF is not operational. What is the most likely reason？ （）A、CEF was not properly configured.B、OSPF was not properly configured for graceful restart.C、Stateful switchover was not correctly configured.D、NSF for OSPF is only supported in area 0.
On corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?（）A、a router with subinterfaces configured on the physical interface that is connected to the switchB、a router with an IP address on the physical interface connected to the switchC、a switch with an access link that is configured between the switchesD、a switch with a trunk link that is configured between the switches
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A、oneB、threeC、twoD、zero
Which configuration command removes all log filters currently configured on the ERX Edge Router？（）A、 no log hereB、 no log fieldsC、 no log filtersD、 no log severity
单选题Which configuration command removes all log filters currently configured on the ERX Edge Router？（）A no log hereB no log fieldsC no log filtersD no log severity
单选题Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs. What is needed to allow communication between VLANs（）。Aa switch with a trunk link that is configured between the switchesBa router with an IP address on the physical interface that is connected to the switchCa switch with an access link that is configured between the switchesDa router with subinterfaces configured on the physical interface that is connected to the switch
单选题A company has a small network，consisting of a single switch and a single router.The switch has beenconfigured with two vlans，and route-on-a-stick is being configured on the router for inter-vlan routing.Atrunk is configured to connect the switch to the router.What is the minimum number of router subinterfacesthat are required for all the vlans to communicate？（）AoneBthreeCtwoDzero
多选题If an edge Label Switch Router （LSR） is properly configured，which three combinations are possible？（）AA received IP packet is forwarded based on the IP destination address and the packet is sent as an IP packet.BAn IP destination exists in the IP forwarding table. A received labeled packet is dropped because the label is not found in the LFIB table.CThere is an MPLS label-switched path toward the destination. A received IP packet is dropped because the destination is not found in the IP forwarding table.DA received IP packet is forwarded based on the IP destination address and the packet is sent as a labeled packet.EA received labeled IP packet is forwarded based upon both the label and the IP address.FA received labeled packet is forwarded based on the label. After the label is swapped，the newly labeled packet is sent.
单选题You are conducting a cdp-based discovery using an edge switch for the seed. there is a router between the switch and the wlse. none of the access points are discovered， and the discovery log shows the switch is snmp unreachable. What is the problem？（）Athe snmp communities on the switch do not match the wlse.Bthe snmp communities on the access points do not match the wlse.Cthe snmp communities on the access points do not match the switch.Dthe snmp communities on the router do not match the wlse.
单选题On corporate network, hosts on the same VLAN can communicate with each other, but they are unable to communicate with hosts on different VLANs. What is needed to allow communication between the VLANs?（）Aa router with subinterfaces configured on the physical interface that is connected to the switchBa router with an IP address on the physical interface connected to the switchCa switch with an access link that is configured between the switchesDa switch with a trunk link that is configured between the switches
单选题Which attribute can be associated with an LDP-signaled LSP?（）Alink coloringBbandwidth reservationCforwarding equivalence classDtransit label-switch router's IP address
单选题Which RIP configuration command allows the ERX Edge Router to send Unicast updates to configured neighbors?（）AneighborBunicast-neighborCtriggered-updateDpassive-interface
单选题An ERX Edge Router is operating in an MPLS network using interface label space.What is used to make a forwarding decision?（）AEXP bitsBVPI / VCICshim headerDSNAP header