Which of the following will allow a technician to extend a partition?（）A、Set the drive up as basicB、Format the drive to FAT32C、Install a second hard driveD、Set the drive as dynamic
Which of the following will allow a technician to extend a partition?（）
- A、Set the drive up as basic
- B、Format the drive to FAT32
- C、Install a second hard drive
- D、Set the drive as dynamic
相关考题：
Which of the following will allow a technician to extend a partition?() A. Set the drive up as basicB. Format the drive to FAT32C. Install a second hard driveD. Set the drive as dynamic
Which of the following should a technician do FIRST in the BIOS to set up drive encryption?() A. Enable eSATA supportB. Run built-in diagnosticsC. Enable TPMD. Enable virtualization support
Which of the following steps would be performed FIRST to install a fresh copy of Windows 7Professional on a new hard drive?() A. Format the partitionB. Load any RAID or SATA drivers neededC. Partition the driveD. Configure Windows settings
After installing a new hard drive into a server for the purpose of mirroring the data from the first drive to the second one， the server displays an “operating system not found” error. Which of the following should the technician do to boot the server from the original drive？（）A、Replace the second drive with a hot swappable one.B、Swap the drive boot order in the BIOSC、Make the second disk active under the disk management tool.D、Rebuild the array using the hardware RAID tool at boot.
A client purchased a new internal hard drive to act as a second drive on a legacy machine. When the client attempts to install the drive, the cable connector on the new drive is not compatible with the available IDE cables. It is determined that the client has purchased a SATA hard drive. Which of the following would the technician recommend as the BEST solution to this situation?（）A、Have the client purchase a SATA compatible system board.B、Have the client purchase a SATA to IDE conversion kit.C、Have the client return the drive and purchase an IDE compatible drive.D、Have the client purchase a SCSI to SATA conversion kit.
Which of the following should a technician do FIRST in the BIOS to set up drive encryption?（）A、Enable eSATA supportB、Run built-in diagnosticsC、Enable TPMD、Enable virtualization support
Which of the following steps would be performed FIRST to install a fresh copy of Windows 7Professional on a new hard drive?（）A、Format the partitionB、Load any RAID or SATA drivers neededC、Partition the driveD、Configure Windows settings
If a technician needs to convert a hard drive from Basic to Dynamic, which of the following utilities would the technician use?（）A、Add Hardware WizardB、Device ManagerC、Computer ManagementD、Disk Management
A technician notices that there is a second partition on the primary hard drive. This partitionis notassigned a drive letter and is not accessible from Windows. Which of the following is the MOST likely explanation for this extra partition?（）A、Space reserved by the drive manufacturer for firmware.B、Space set aside by Windows for use by the virtual memory swap file.C、A potentially dangerous virus has been downloaded onto the system.D、A recovery partition put there by the manufacturer.
In which of the following locations would a technician set the LBA mode for a hard drive？（）A、Jumper SettingsB、Disk ManagerC、Device ManagerD、System BIOS
After installing a new SATA hard drive the technician notices the drive is hot to the touch and is giving off a slight odor. Which of the following should the technician do? （）A、Install a larger fan near the hard drive to cool the system.B、Clean the drive with compressed air and continue to use it.C、Remove and replace the drive.D、Apply more thermal compound and reseat the drive.
A user requires more storage space on their computer. After a technician installs a second IDE drive in the computer, the system will not recognize that there are any hard drives installed. Which of the following is the MOST likely cause of the problem?（）A、The second hard drive has not been formatted for NTFS.B、The jumpers on both drives are set to the cable select position.C、The jumper on the first drive is set to master and the second is set to slave.D、The jumpers on both drives are set to the master position.
A technician is working on a new computer running Windows XP and the hard drive is formatted at 20GB but is an 80GB hard drive. There is not another partition and no extra space can be foundunder Windows explorer. Which of the following would be the BEST way to partition the remainder of the hard drive without data loss？ （）A、Add another hard drive and use that available space.B、Run FDISK.C、Use the Disk Management tool.D、Back up all important data to an external drive then reformat the hard drive.
A user is trying to boot a desktop PC from their A: drive. Which of the following devices is the userdescribing？（）A、The floppy driveB、The hard driveC、The CD-ROM driveD、The DVD-ROM drive
A technician wants to secure a Windows 7 Ultimate notebook hard drive. Which of the following should the technician do to implement BitLocker?（） (Select TWO).A、Disable TPM in the system BIOSB、Run the BitLocker wizard and any necessary partitionsC、Enable TPM in the system BIOSD、Enable TPM in the Windows 7 OS filesE、Set up the OS and the system files on the same partition
Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?（）A、The new drive’s jumper is set for master.B、The new drive is connected to the secondary bus as a slave drive.C、Both drives’ jumpers are set for cable select.D、The old drive’s jumper is set for master and the new drive is set for slave.
An administrator is configuring RAID 1 in a server. The administrator has been given two matching 80GB SATA-2 hard drives， two SATA-2 cables， and a SATA-2 RAID adapter. How should the administrator BEST configure these drives？（）A、Install one drive on the first channel and install the second drive on the second channel.B、Install one drive on the first cable， on the first channel. Install the second drive on the secondcable， on the second channel.C、Install both drives on the same channel. Cable both drives as the primary master on the samecable.D、Install both drives on the same channel. On the same cable one drive should be set as primaryslave and the other drive as the primary master.
A technician notices that there is a second partition on the primary hard drive. This partition is not assigned a drive letter and is not accessible from Windows. Which of the following is the MOST likely explanation for this extra partition?（）A、Space reserved by the drive manufacturer for firmware.B、Space set aside by Windows for use by the virtual memory swap file.C、A potentially dangerous virus has been downloaded onto the system.D、A recovery partition put there by the manufacturer.
The technician is working on a system and has determined that the hard drive must be reimaged. However, the customer wants to retain all the data. Which of the following would take the LEAST amount of time to implement?（）A、Create a new partition on the hard drive, copy all data to the new partition, reimage the drive, and the old data will be on the new partition and accessible.B、Install a new hard drive, slave the old drive, image the new drive, and show the customer how to access their data on the old drive.C、Upload the data to an external FTP server, reimage the drive, and then restore the data to the newly imaged drive.D、Copy data to a USB connected hard drive, reimage the drive, and then restore the data to the newly imaged drive.
A technician is preparing to update the BIOS on a laptop. Which of the following should thetechnician do to prevent problems during the update?（）A、Remove all of the memoryB、Plug in the AC adapterC、Remove the hard drive and optical driveD、Clear the partitions on the hard drive
You are a network administrator for ExamSheet.net. You plan to configure your computer to use Windows 98, Windows 2000 Professional and indows NT Workstation 4.0. You also plan to configure a data drive that can be accessed by all operating systems on your computer. Your computer has one 20 GB hard disk. You want to configure your computer as shown in the exhibit. What should do? （）A、Create the boot drive on drive C and format as a FAT16 partition. B、Create the boot drive on drive C and format as a NTFS partition.C、Configure the boot drive as a basic volume and format the volume as FAT32.D、Configure the boot drive as a dynamic volume and format the volume as a FAT16 partition. E、Configure the boot drive as a dynamic volume and format the volume as a FAT32 partition.
After removing several obsolete programs from a PC, a user is experiencing slower than usuallyprocessing times. Which of the following would be the BEST way to speed up the processing? （）A、Use an external hard drive.B、Defrag the hard drive.C、Add more RAM to the computer.D、Install a larger hard drive.
单选题Bob, a technician, is adding a secondary IDE hard drive to an older system. After installation and the first boot, the drive is not showing in Disk Management. Which of the following is the MOST likely cause of the issue?（）AThe new drive’s jumper is set for master.BThe new drive is connected to the secondary bus as a slave drive.CBoth drives’ jumpers are set for cable select.DThe old drive’s jumper is set for master and the new drive is set for slave.
单选题After installing a new SATA hard drive the technician notices the drive is hot to the touch and is giving off a slight odor. Which of the following should the technician do? （）AInstall a larger fan near the hard drive to cool the system.BClean the drive with compressed air and continue to use it.CRemove and replace the drive.DApply more thermal compound and reseat the drive.
单选题A user requires more storage space on their computer. After a technician installs a second IDE drive in the computer, the system will not recognize that there are any hard drives installed. Which of the following is the MOST likely cause of the problem?（）AThe second hard drive has not been formatted for NTFS.BThe jumpers on both drives are set to the cable select position.CThe jumper on the first drive is set to master and the second is set to slave.DThe jumpers on both drives are set to the master position.
单选题Which of the following will allow a technician to extend a partition?（）ASet the drive up as basicBFormat the drive to FAT32CInstall a second hard driveDSet the drive as dynamic
单选题The technician is working on a system and has determined that the hard drive must be reimaged. However, the customer wants to retain all the data. Which of the following would take the LEAST amount of time to implement?（）ACreate a new partition on the hard drive, copy all data to the new partition, reimage the drive, and the old data will be on the new partition and accessible.BInstall a new hard drive, slave the old drive, image the new drive, and show the customer how to access their data on the old drive.CUpload the data to an external FTP server, reimage the drive, and then restore the data to the newly imaged drive.DCopy data to a USB connected hard drive, reimage the drive, and then restore the data to the newly imaged drive.