What is the default protocol preference for BGP EBGP routes?（）A、10B、100C、170D、175
What is the default protocol preference for BGP EBGP routes?（）
- A、10
- B、100
- C、170
- D、175
相关考题：
What is the purpose of the Spanning Tree Protocol (STP)?A．To prevent routing loopsB．To create a default routeC．To provide multiple gateways for hostsD．To maintain a loop-free Layer 2 network topologyE．To enhance the functions of SNMP
What kind ofpre－sequence is A’s first utterance in the following discourse? ()A: Do you have a rubber?B: Yes.A: May I use it?B: Here you are. A.Pre-invitationB.Pre-requestC.Pre-announcementD.Pre-apology
What is the purpose of Spanning Tree Protocol?() A. to prevent routing loopsB. to create a default routeC. to provide multiple gateways for hostsD. to maintain a loop-free Layer 2 network topologyE. to enhance the functions of SNMP
You have just configured a static default route on router TK1. What is the purpose of a default route?() A. It is a route to be used when the routing protocol fails.B. It is a route configured by an ISP that sends traffic into a corporate network.C. It is a route used when a packet is destined for a remote network that is not listed in the routing table.D. It is a route manually configured for a specific remote network for which a routing protocol is not configured.E. It is used to send traffic to a stub network.
The Testking network has been configured with OSPF as the routing protocol.What is the default administrative distance of the OSPF routing protocol?() A.90B.100C.110D.120E.130F.170G.200
What is the protocol of following described： there are 4 priority queues：high，medium，normal.low the high and medium queue have precedence over the default queue the classifcation is configuration via the command ‘priority-list’ the default queue is the normal queue.
You are a technician at TestKing. Your newly appointed TestKing trainee wants to know what the CDP is.What would your reply be?（）A、It is globally enabled by default on Cisco routers.B、It is globally enabled by default on all routers.C、It is a proprietary protocol.D、It is a non-proprietary protocol.E、It can be used to gather hardware and protocol information about neighbor devices.
What is the effect of applying the switchport trunk encapsulation dot1q command to a port on a Cisco Catalyst switch？（）A、By default， native VLAN packets going out this port will be tagged.B、Without an encapsulation command， 802.1Q will be the default encapsulation if DTP fails to negotiate a trunking protocol.C、The interface will support the reception of tagged and untagged traffic.D、If the device connected to this port is not 802.1Q-enabled， it will not be able to handle 802.1Q packets.
The Testking network has been configured with OSPF as the routing protocol.What is the default administrative distance of the OSPF routing protocol?（）A、90B、100C、110D、120E、130F、170G、200
What is the purpose of Spanning Tree Protocol?（）A、to prevent routing loopsB、to create a default routeC、to provide multiple gateways for hostsD、to maintain a loop-free Layer 2 network topologyE、to enhance the functions of SNMP
What does the protocol field inside the PPP frame indicate？（）A、the protocol used to determine the authentication methodB、the protocol used to identify the data in the Information fieldC、the protocol used to carry the PPP frameD、the protocol used to decode the FCS fieldE、the protocol used to detect the number of padding bytes
When you display the routing table by entering the show route command, what does the* indicate?（）A、The route is a direct route.B、The route was selected as active.C、The route is a default route.D、The route was learned using a dynamic routing protocol.
Which three protocols use UDP as a transport protocol by default?（）A、HTTPB、TFTPC、DNSD、SNMPE、SMTP
How will router A choose a path to the 10.1.2.0/24 network when different routing protocols are configured (Choose three.)（）。A、If RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.B、If RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.C、If EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.D、If EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.E、If EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.F、If EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.
What network information do you need when you plan to implement a VLAN-based solution？（）A、default VLAN information for all unused switch portsB、802.1x configuration parameters C、number of IP subnets neededD、IP routing protocol information
Which routing protocol by default uses bandwidth and delay as metrics（）。A、RIPB、BGPC、OSPFD、EIGRP
单选题When you display the routing table by entering the show route command, what does the* indicate?（）AThe route is a direct route.BThe route was selected as active.CThe route is a default route.DThe route was learned using a dynamic routing protocol.
多选题You are a technician at TestKing. Your newly appointed TestKing trainee wants to know what the CDP is.What would your reply be?（）AIt is globally enabled by default on Cisco routers.BIt is globally enabled by default on all routers.CIt is a proprietary protocol.DIt is a non-proprietary protocol.EIt can be used to gather hardware and protocol information about neighbor devices.
单选题What is the purpose of Spanning Tree Protocol?（）Ato prevent routing loopsBto create a default routeCto provide multiple gateways for hostsDto maintain a loop-free Layer 2 network topologyEto enhance the functions of SNMP
单选题You have just configured a static default route on router TK1. What is the purpose of a default route?（）AIt is a route to be used when the routing protocol fails.BIt is a route configured by an ISP that sends traffic into a corporate network.CIt is a route used when a packet is destined for a remote network that is not listed in the routing table.DIt is a route manually configured for a specific remote network for which a routing protocol is not configured.EIt is used to send traffic to a stub network.
单选题The Testking network has been configured with OSPF as the routing protocol.What is the default administrative distance of the OSPF routing protocol?（）A90B100C110D120E130F170G200
单选题You administer a SQL Server 2008 Reporting Services (SSRS) instance. You plan to design an authentication method for SSRS reports that use SQL Server data connections. You need to ensure that all SSRS reports communicate to the SQL Server instance by using the Kerberos authentication protocol. What should you do?（）AConfigure the default Web site on the instance to use the Integrated Security type.BConfigure the application pool used by the default Web site to use a domain account. CConfigure the default Web site on the instance to use the Secure Sockets Layer (SSL) protocol.DRegister a service principal name (SPN) in the Active Directory directory service for the SSRSinstance.
问答题What is the protocol of following described： there are 4 priority queues：high，medium，normal.low the high and medium queue have precedence over the default queue the classifcation is configuration via the command ‘priority-list’ the default queue is the normal queue.
多选题How will router A choose a path to the 10.1.2.0/24 network when different routing protocols are configured (Choose three.)（）。AIf RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.BIf RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.CIf EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.DIf EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.EIf EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.FIf EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.