单选题When configuring non-IP point-to-point networks on clusters that are larger than two nodes， which Type of configuration should be defined？（）A A startB A ringC A target mode fcD A target mode scsi
单选题
When configuring non-IP point-to-point networks on clusters that are larger than two nodes， which Type of configuration should be defined？（）
A
A start
B
A ring
C
A target mode fc
D
A target mode scsi
参考解析
解析：
暂无解析
相关考题：
●In the WAN，when a point-to-point subnet is used，an important design issue is the roucer interconnection (74) ．(74) A．topologyB．computerC．serviceD．lines
In the WAN, when a point-to-point subnet is used, an important design issue is the roucer interconnection(74).A．topologyB．computerC．serviceD．lines
On point－to－point networks, OSPF hello packets are addressed to which address?() A.127.0.0.1B.172.16.0.1C.192.168.0.5D.223.0.0.1E.224.0.0.5F.254.255.255.255
When configuring Frame Relay using point－to－point subinterfaces, which of the following must not be configured?() A. The local DLCI on each subinterface of the Frame Relay.B. The Frame Relay encapsulation on the physical interface.C. An IP address on the physical interface.D. The subinterface type as point-to-point
On what kinds of networks does OSPF elect a backup designated router?（）A、Point-to-point and point-to-multipoint networksB、Nonbroadcast and broadcast multipoint multicastingC、Point-to-point and multi-access broadcastingD、Point-to-multipoint and multi-access broadcastingE、Nonbroadcast and broadcast multi-access
What are the three main types of networks that must be considered when defining a security policy？
When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?（）A、The local DLCI on each subinterface of the Frame Relay.B、The Frame Relay encapsulation on the physical interface.C、An IP address on the physical interface.D、The subinterface type as point-to-point
When configuring a scheduler map, which two are referenced?（）A、Forwarding ClassB、SchedulerC、Rewrite RulesD、Priority
A route-based VPN is required for which scenario? （）A、when the remote VPN peer is behind a NAT deviceB、when multiple networks need to be reached across the tunnelC、when the remote VPN peer is a dialup or remote access clientD、when a dynamic routing protocol such as OSPF is required across the VPN
On point-to-point networks, OSPF hello packets are addressed to which address?（）A、127.0.0.1B、172.16.0.1C、192.168.0.5D、223.0.0.1E、224.0.0.5F、254.255.255.255
What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology?（）A、it avoids split-horizon issues with distance vector routing protocols.B、IP addresses can be conserved if VLSM is not being used for subnetting.C、A multipoint interface offers greater security compared to point-to-point subinterface configurations.D、The multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over point-to-point configurations.
When configuring surround sound systems， speaker delay is used to compensate for speaker（）.A、distanceB、powerC、sizeD、efficiency
When configuring non-IP point-to-point networks on clusters that are larger than two nodes， which Type of configuration should be defined？（）A、 A startB、 A ringC、 A target mode fcD、 A target mode scsi
During the initial cluster design，a disk heartbeat，Point-to-Point non-IP network is being planned as part of a three-node cluster implementation. The disk environment will use LVM mirroring for disk redundancy. The volume groups will be created as Enhanced Concurrent Capable. To facilitate disk heartbeating，how many disks per node and how many networks will be required？（） A、 One disk per node，one networkB、 Two disks per node，one networkC、 Two disks per node，six networksD、 Two disks per node，three networks
When configuring the messaging system， which of the following are valid parameters for the file transport？ （）A、File NameB、Operating SystemC、LocationD、HostE、Mode
During the installation of a cluster， the non-IP network failed. The cause was a connector that was Not properly secured. The customer wants a better notification method in the event that the non-IP network fails in the future. How could customization of the cluster be accomplished？（） A、 Customize the node up event script to send an email to the operator.B、 Have HACMP send mail when the non-IP network fails by customizing the RG_MMOVE event script.C、 Change the network module to be slower so that a temporary failure of the non-IP network would not report an error.D、 Use snmp or clinfo to monitor the status of the non-IP network and dispatch some type of warning message.
Which new key architectural element introduced in WebLogic Server l2c should you take advantage of when designing Disaster Recovery Centers with active - passive mode?（）A、MAN Clusters, because they would allow you to synchronously replicate state in low latency networks B、WAN Clusters, because they would allow you to asynchronously replicate state in nonlow latency networks. C、Transaction Log in the database, because you could avoid synchronizing two replication technologies (database and file) D、Data Guard, because it is the most effective way to replicate a state across locationsE、GoldenGate, because it is the most effective way to replicate a state across locations
Which statement is true about "sticky" load balancing for Clusters? （）A、The "clientip" setting does not apply to clusters, it only pertains to a Forwarder.B、When set to "clientip" it uses the client's IP address to bind the client to a particular target server.C、When set to "clientip" it allows a DX sticky cookie to be sent to and stored by the client based on the IP address.D、When set to "clientip" it ensures that all subsequent requests are directed to the same client that made the initial request.
问答题What are the three main types of networks that must be considered when defining a security policy？
单选题A customer has a requirement to build a 4 node cluster. Disk heartbeating will be used as the non-IP network.What is the maximum number of disk heartbeat point-to-point links one would need to implement in order toachieve the highest level of availability？（）A4B6C8D12
单选题Which new key architectural element introduced in WebLogic Server l2c should you take advantage of when designing Disaster Recovery Centers with active - passive mode?（）AMAN Clusters, because they would allow you to synchronously replicate state in low latency networks BWAN Clusters, because they would allow you to asynchronously replicate state in nonlow latency networks. CTransaction Log in the database, because you could avoid synchronizing two replication technologies (database and file) DData Guard, because it is the most effective way to replicate a state across locationsEGoldenGate, because it is the most effective way to replicate a state across locations
多选题When configuring the messaging system， which of the following are parameters of the e-mail transport？ （）ALocationBProtocolCModeDWeb AddressEHost
单选题What is the advantage of using a multipoint interface instead of point-to-point subinterfaces when configuring a Frame Relay hub in a hub-and-spoke topology?（）Ait avoids split-horizon issues with distance vector routing protocols.BIP addresses can be conserved if VLSM is not being used for subnetting.CA multipoint interface offers greater security compared to point-to-point subinterface configurations.DThe multiple IP network addresses required for a multipoint interface provide greater addressing flexibility over point-to-point configurations.
单选题When configuring Frame Relay using point-to-point subinterfaces, which of the following must not be configured?（）AThe local DLCI on each subinterface of the Frame Relay.BThe Frame Relay encapsulation on the physical interface.CAn IP address on the physical interface.DThe subinterface type as point-to-point
单选题On point-to-point networks, OSPF hello packets are addressed to which address（）。A127.0.0.1B172.16.0.1C192.168.0.5D223.0.0.1E224.0.0.5F254.255.255.255
单选题When configuring a serial interface on a router, what is the default encapsulation?（）Aatm-dxiBframe-relayChdlcDlapbEppp
单选题During the initial cluster design，a disk heartbeat，Point-to-Point non-IP network is being planned as part of a three-node cluster implementation. The disk environment will use LVM mirroring for disk redundancy. The volume groups will be created as Enhanced Concurrent Capable. To facilitate disk heartbeating，how many disks per node and how many networks will be required？（）A One disk per node，one networkB Two disks per node，one networkC Two disks per node，six networksD Two disks per node，three networks