单选题What is an appropriate use of a default route？（）Ato provide routing to a local web serverBto provide routing from an ISP to a stub networkCto provide routing that will override the configured dynamic routing protocolDto provide routing to a destination that is not specified in the routing table and which is outside the local network
单选题
What is an appropriate use of a default route？（）
A
to provide routing to a local web server
B
to provide routing from an ISP to a stub network
C
to provide routing that will override the configured dynamic routing protocol
D
to provide routing to a destination that is not specified in the routing table and which is outside the local network
参考解析
解析：
暂无解析
相关考题：
Which multicast address does RIPv2 use for route updates by default?() A.224.0.0.2B.224.0.0.5C.224.0.0.9D.255.255.255.255
Assuming both paths shown in the exhibit are available, which statement is correct?() A. Traffic matching the default route will use 10.1.1.1 as the next hop.B. Traffic matching the default route will use 10.1.1.254 as the next hop.C. Traffic matching the default route will be load-balanced per packet across both next hops.D. Traffic matching the default route will be load-balanced per flow across both next hops.
What happens when a route does not match any user configured policies?() A.The route is rejected.B.The route is accepted.C.The route is given a lower priority.D.The route is sent to the default policy.
When you display the routing table by entering the show route command, what does the* indicate?() A.The route is a direct route.B.The route was selected as active.C.The route is a default route.D.The route was learned using a dynamic routing protocol.
Refer to the exhibit. How would you confirm on R1 that load balancing is actually occurring on the default － netw ork (0.0.0.0)?() A. Use ping and the show ip route command to confirm the timers for each default network resets to 0.B. Load balancing does not occur over default networks; the second route will only be used for failover.C. Use an extended ping al ong with repeated show ip route commands to confirm the gateway of last resort address toggles back and forth.D. Use the traceroute command to an address that is not explicitly in the routing table.
Which of the following commands would you use, to configure a default route to any destination NOT found in the routing table?() A. Router(config)# ip default-route 0.0.0.0 255.255.255.255 s0B. Router(config)# ip route 0.0.0.0 255.255.255.255 s0C. Router(config)# ip default-route 0.0.0.0 0.0.0.0 s0D. Router(config)# ip route 0.0.0.0 0.0.0.0 s0E. Router(config)# ip route any any e0
Which two design recommendations are most appropriate when EIGRP is the data center core routing protocol?() A. Summarize data center subnets.B. Use passive interfaces to ensure appropriate adjacencies.C. Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.D. Adjust the default bandwidth value to ensure proper bandwidth on all links.E. Advertise a default summary route into the data center core from the aggregation layer.
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。A.The router will use the static route.B.The router will use the OSPF route.C.The router will use the EIGRP route.D.The router will load balance and use all three routes.
A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。A、The router will use the static route.B、The router will use the OSPF route.C、The router will use the EIGRP route.D、The router will load balance and use all three routes.
Which of the following is a valid method for defining a seed metric？（Choose all that apply.）（）A、The default-metric command configured under the appropriate interfaceB、The metric parameter in the network command of a routing processC、The metric parameter in the redistribute commandD、The default-metric commandE、A route-map containing a seed commandF、A route map containing a metric command
What happens when a route does not match any user configured policies?（）A、The route is rejected.B、The route is accepted.C、The route is given a lower priority.D、The route is sent to the default policy.
When you display the routing table by entering the show route command, what does the* indicate?（）A、The route is a direct route.B、The route was selected as active.C、The route is a default route.D、The route was learned using a dynamic routing protocol.
A router leams about a remote network from EIGRP.OSPF. and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?（）A、The router will use the static route.B、The router will use the OSPF route.C、The route will use the EIGRP route.D、The router will load balance and use all three routes.
Which two design recommendations are most appropriate when EIGRP is the data center corerouting protocol？ （）A、 Summarize data center subnets.B、 Use passive interfaces to ensure appropriate adjacencies.C、 Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.D、 Adjust the default bandwidth value to ensure proper bandwidth on all links.E、 Advertise a default summary route into the data center core from the aggregation layer.
What is an appropriate use of a default route？（）A、to provide routing to a local web serverB、to provide routing from an ISP to a stub networkC、to provide routing that will override the configured dynamic routing protocolD、to provide routing to a destination that is not specified in the routing table and which is outside the local network
A machine must have the most direct access possible to two different networks. However， it cannot act as a router between the networks. Which of the following arrangements is most appropriate to facilitate the machine’s accessibility？（）A、ipforwarding turned on and two adaptersB、One adapter， with a route to a default gatewayC、An adapter in each network， and ipforwarding offD、An adapter in each network， with a route only to the default gateway
What is the maximum suppress time for a dampened route, by default?（）A、5 minutesB、30 minutesC、60 minutesD、90 minutes
单选题When you display the routing table by entering the show route command, what does the* indicate?（）AThe route is a direct route.BThe route was selected as active.CThe route is a default route.DThe route was learned using a dynamic routing protocol.
单选题A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。AThe router will use the static route.BThe router will use the OSPF route.CThe router will use the EIGRP route.DThe router will load balance and use all three routes.
单选题Which of the following commands would you use, to configure a default route to any destination NOT found in the routing table?（）ARouter(config)# ip default-route 0.0.0.0 255.255.255.255 s0BRouter(config)# ip route 0.0.0.0 255.255.255.255 s0CRouter(config)# ip default-route 0.0.0.0 0.0.0.0 s0DRouter(config)# ip route 0.0.0.0 0.0.0.0 s0ERouter(config)# ip route any any e0
单选题What happens when a route does not match any user configured policies?（）AThe route is rejected.BThe route is accepted.CThe route is given a lower priority.DThe route is sent to the default policy.
单选题As a TestKing trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?（）ATestKSwitch(config)# ip route-default 192.168.1.115BTestKSwitch(config)# ip default-gateway 192.168.1.115CTestKSwitch(config)# ip route 192.168.1.115 0.0.0.0DTestKSwitch(config)# ip default-network 192.168.1.115
单选题A router leams about a remote network from EIGRP.OSPF. and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?（）AThe router will use the static route.BThe router will use the OSPF route.CThe route will use the EIGRP route.DThe router will load balance and use all three routes.
单选题A machine must have the most direct access possible to two different networks. However， it cannot act as a router between the networks. Which of the following arrangements is most appropriate to facilitate the machine’s accessibility？（）Aipforwarding turned on and two adaptersBOne adapter， with a route to a default gatewayCAn adapter in each network， and ipforwarding offDAn adapter in each network， with a route only to the default gateway
单选题Assuming both paths shown in the exhibit are available, which statement is correct?（）A Traffic matching the default route will use 10.1.1.1 as the next hop.B Traffic matching the default route will use 10.1.1.254 as the next hop.C Traffic matching the default route will be load-balanced per packet across both next hops.D Traffic matching the default route will be load-balanced per flow across both next hops.