Which two statements describe characteristics of IPv6 unicast addressing?() A. Global addresses start with 2000::/3.B. Link-local addresses start with FE00:/12.C. Link-local addresses start with FF00::/10.D. There is only one loopback address and it is ::1.E. If a global address is assigned to an interface, then that is the only allowable address for the interface.
Which two statements describe characteristics of IPv6 unicast addressing?()
A. Global addresses start with 2000::/3.
B. Link-local addresses start with FE00:/12.
C. Link-local addresses start with FF00::/10.
D. There is only one loopback address and it is ::1.
E. If a global address is assigned to an interface, then that is the only allowable address for the interface.
相关考题：
An ATM PVC is configured as atm pvc 1 0 101 aal5snap 256 128 100 .Which three statements describe the traffic management characteristics of this interface?() A.AB.BC.CD.DE.E
Which two of these correctly describe Fibre Channel? () A. supports multiple protocolsB. works only in a shared or loop environmentC. allows addressing for up to 4 million nodesD. allows addressing for up to 8 million nodesE. provides a high speed transport for SCSI payloadsF. may stretch to a distance of up to100 km before needing extenders
Which two of these statements best describe the benefits of WPAv2？ （Choose two.）（）A、 SSID broadcast preventionB、 man-in-the-middle attack protectionC、 cost reduction through software upgrades in all existing hardwareD、 dynamic key generationE、 RF jamming prevention
Which two statements are characteristics of pin groups?（）A、they are used internally within fcoe to map a vsan to a specifc vlanB、they pin traffic fro a specific compute node mezzanine card to aspecific up link portC、an iplink port for the adapter is chosen automatically if no pin group is set
Which two statements are true about Unicast Reverse Path Forwarding Loose Mode？（）A、It is used in multihome network scenarios.B、It can be used with BGP to mitigate DoS and DDoS.C、It does not need to have CEF enabled.D、It is enabled via the interface level command ip verify unicast reverse-path.E、It cannot be used with "classification" access lists.
Which two statements correctly describe characteristics of the PortFast feature？ （）A、STP will be disabled on the port.B、PortFast can also be configured on trunk ports.C、PortFast is required to enable port-based BPDU guard.D、PortFast is used for both STP and RSTP host ports.E、PortFast is used for STP-only host ports.
Which two characteristics describe the UDP protocol?（）A、limited error checkingB、defined timersC、no recovery mechanismsD、three-way handshake
Which two statements accurately describe an IBGP peering session?（） (Choose two.)A、Peers are statically defined.B、Peers exist within the same AS.C、Peers must be directly connected to each other.D、Peers advertise routes learned from other IBGP neighbors.
Which two of these statements best describe the benefits of WPAv1？ （）A、 SSID broadcast preventionB、 Improved mutual authenticationC、 Improved encryption through AESD、 Improved protection against sniffing initialization vectorsE、 RF jamming prevention
Which two are characteristics of an IPv6 multicast address？（）A、First （most significant ） octet is FF in hexB、Starts with a prefix of FE80 to FEBF in hexC、Starts with a prefix of FECO to FEFF in hexD、Second octet contains a 4-bit multicast scope fieldE、Last 64 bit contains the modified MAC address of the Ethernet interfaceF、Is allocated from the unicast address space
Which two statements describe characteristics of IPv6 unicast addressing?（）A、Global addresses start with 2000::/3.B、Link-local addresses start with FE00:/12.C、Link-local addresses start with FF00::/10.D、There is only one loopback address and it is ::1.E、If a global address is assigned to an interface, then that is the only allowable address for the interface.
Which command enables IPv6 forwarding on a cisco router?（）A、ipv6 hostB、ipv6 unicast-routingC、ipv6 localD、ipv6 neighbor
Which two of these correctly describe Fibre Channel？（）A、 supports multiple protocolsB、 works only in a shared or loop environmentC、 allows addressing for up to 4 million nodesD、 allows addressing for up to 8 million nodesE、 provides a high speed transport for SCSI payloadsF、 may stretch to a distance of up to 100 km before needing extenders
Which two of these correctly describe Fibre Channel? （）A、supports multiple protocolsB、works only in a shared or loop environmentC、allows addressing for up to 4 million nodesD、allows addressing for up to 8 million nodesE、provides a high speed transport for SCSI payloadsF、may stretch to a distance of up to100 km before needing extenders
Which two statements describe the advantages to the use of RIP over the use of OSPF?（）A、RIP requires less time to convergeB、RIP uses less bandwidthC、RIP is less complex to configureD、RIP demands fewer router resourcesE、RIP has a more accurate metric
Which two of these statements are true of IPv6 address representation?（）A、There are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.B、A single interface may be assigned multiple IPv6 addresses of any type.C、Every IPv6 interface contains at least one loopback address.D、The first 64 bits represent the dynamically created interface ID.E、Leading zeros in an IPv6 16 bit hexadecimal field are mandatory.
Which command must be globally enabled on a Cisco router to support IPv6?（）A、ip routing ipv6B、ipv6 unicast - routingC、ipv6 routingD、ip classlessE、ipv6 cef
Which two of these statements best describe fast secure roaming？ （Choose two.）（） A、 available only in autonomous APsB、 available in autonomous and lightweight APsC、 a feature of WDS in autonomous APsD、 a feature of WDS in lightweight APsE、 requires at least one AP and one Wireless LAN Services Module
多选题Which two of these correctly describe Fibre Channel？（）Asupports multiple protocolsBworks only in a shared or loop environmentCallows addressing for up to 4 million nodesDallows addressing for up to 8 million nodesEprovides a high speed transport for SCSI payloadsFmay stretch to a distance of up to 100 km before needing extenders
多选题Which two of these statements best describe fast secure roaming？ （Choose two.）（）Aavailable only in autonomous APsBavailable in autonomous and lightweight APsCa feature of WDS in autonomous APsDa feature of WDS in lightweight APsErequires at least one AP and one Wireless LAN Services Module
多选题Which two of these statements best describe the benefits of WPAv2？ （Choose two.）（）ASSID broadcast preventionBman-in-the-middle attack protectionCcost reduction through software upgrades in all existing hardwareDdynamic key generationERF jamming prevention
多选题Which two of these statements are true of IPv6 address representation? （）AThere are four types of IPv6 addresses: unicast, multicast, anycast, and broadcast.BA single interface may be assigned multiple IPv6 addresses of any type.CEvery IPv6 interface contains at least one loopback address.DThe first 64 bits represent the dynamically created interface ID.ELeading zeros in an IPv6 16 bit hexadecimal field are mandatory.
多选题Which two of these statements best describe the benefits of WPAv1？ （）ASSID broadcast preventionBImproved mutual authenticationCImproved encryption through AESDImproved protection against sniffing initialization vectorsERF jamming prevention
多选题Which two statements describe the advantages to the use of RIP over the use of OSPF?（）ARIP requires less time to convergeBRIP uses less bandwidthCRIP is less complex to configureDRIP demands fewer router resourcesERIP has a more accurate metric
多选题Which two statements describe the criteria bandwidth detection uses to dynamically alter bandwidth allocation?（）(Choose two.)AThroughput is raised as latency decreases.BThroughput is based on available bandwidth.CThroughput is lowered as latency decreases.DLatency is measured by SYNs returned for each metapacket.
多选题Which two statements correctly describe characteristics of the PortFast feature？ （）ASTP will be disabled on the port.BPortFast can also be configured on trunk ports.CPortFast is required to enable port-based BPDU guard.DPortFast is used for both STP and RSTP host ports.EPortFast is used for STP-only host ports.
多选题Which two characteristics describe the UDP protocol?（）Alimited error checkingBdefined timersCno recovery mechanismsDthree-way handshake