单选题Keel scantlings of any vessel are greatest amidships because().Aconnections between forebody and afterbody are most crucialBof maximum longitudinal bending momentsCof severest racking stressesDresistance to grounding is at a maximum amidships

单选题
Keel scantlings of any vessel are greatest amidships because().
A

connections between forebody and afterbody are most crucial

B

of maximum longitudinal bending moments

C

of severest racking stresses

D

resistance to grounding is at a maximum amidships


参考解析

解析: 暂无解析

相关考题:

单选题一般地,货舱装满时,货物实际重心求得的GM比按舱容中心求得的GM()。A大B小C相等D以上均有可能

单选题A fire involving aluminum powder would be a class ().AA fireBB fireCC fireDD fire

单选题一般来说,轮机部应()填写一次物料申请单并报送公司供应部门.A每半年B在每次航修前C每月或每航次D船舶进厂修理前

单选题最为常见的撇缆绳的长度为()。A30mB35mC40mD50m

单选题Coiling new rope against the lay,bringing the lower end up through the center of the coil,then coiling with the lay,in order to remove the kinks,is known as().AcoilingBfakingCflemishingDthoroughfooting

单选题在柴油机中润滑的作用有()。 Ⅰ.减磨 Ⅱ.防腐 Ⅲ.冷却 Ⅳ.调整间隙 Ⅴ.传递动力AⅠ+Ⅱ+ⅢBⅠ+Ⅲ+ⅣCⅠ+Ⅱ+Ⅲ+ⅣDⅠ+Ⅱ+Ⅲ+Ⅴ

单选题在DC C20/K-CHIEF500监视与报警系统中,只有()模块可以实现开关量输出。ARAo-8BRIO-C2CRDi-32DdPSC

单选题对传动轴系理解正确的是()。Ⅰ.长轴系刚性好,对偏差敏感;Ⅱ.短轴系挠性好对偏差不敏感A仅Ⅰ对B仅Ⅱ对CⅠ+ⅡDⅠ,Ⅱ都不对

单选题某轮抵港前dF=5.48m,dA=6.06m,拟在No.1舱和No.4舱间移货以调平船舶吃水,查得在No.1舱加载100t首吃水变化17.59cm,尾吃水变化-7.81cm,No.4舱加载100t首吃水变化-7.58cm,尾吃水变化13.65cm,应移货的数量为()t。A136B141C124D105

单选题活塞销表面裂纹应用()检查。A观察法B着色探伤C磁力探伤DA或B或C

单选题气阀阀杆卡死通常的原因是()。A撞击B烧蚀C滑油高温结炭D间隙过大

单选题下列哪种锚泊方式既能增大锚抓力又能抑制偏荡?()A单锚泊B一字锚C八字锚D一点锚

判断题一艘快速船追越一艘机动船时,因快速船速度较快,因此可以不鸣放追越声号,直接追越就行了。A对B错

问答题公约禁止在船上焚烧的物质有哪些?

单选题Combustion knock occurring in a diesel engine can be caused by ().Aexcessive fuel penetrationBprolonged injection lagCreduced ignition lagDprolonged ignition lag

单选题辅锅炉燃烧器的燃油加热器,不正确的是()。A一般采用电加热的形式B加热采用温度开关进行双位控制C另设有高、低油温报警D烧用轻油时也必须加热

单选题It is during () that work energy is being put into the engine; during the other 3 strokes of the piston, the engine is having to do the work.Athe suction strokeBthe compression strokeCthe expansion strokeDthe exhaust stroke

单选题在液压调速器中,其主要的组成部分有()。A转速感应机构与伺服放大机构B反馈机构与调节机构C飞重与调速弹簧机构DA+B

单选题1.6GHZ的EPIRB又称为()波段的EPIRBALBCCHFDUHF

单选题对于单管共射极基本放大电路,若静态工作点不合适,比较方便的做法是()。A负载大小B基极注入电流大小C电流放大系数的大小D电压放大倍数的大小

单选题当遥控起动SULZER RTA型主机时,如果机旁燃油手柄没有放到遥控位置,则()。A主起动阀打不开B空气分配器不工作C断油伺服器处于停油位置D调速器与油门总杆不能连接

单选题用化学发光法测量氧化氮时,NO2/NO转化器的效率对测量精度有直接影响,更换新的转换器的标准是()。A效率低于60%B效率低于70%C效率低于80%D效率低于90%

单选题液压油中固体污染物造成的危害不包括()。A液压泵和马达磨损加快B阀件故障增多C促使油液分解D对油液氧化起催化作用

单选题测量螺旋桨螺距时采用的量具是()。A螺距规B直尺C塞尺D桥规

单选题在船用柴油机使用的直接喷射系统中,应用最广泛的是()。A分配式B柱塞泵式C泵喷嘴式D电子喷射式

单选题在一般情况下曲轴发生疲劳裂纹的常见原因是()。A扭转力矩B扭转振动C交变弯矩DB+C

单选题Why is it important for fuel oil tanks not to be topped off at the inner bottom level when loading on a cold day?()AIncreased viscosity of the product needs higher loading pressure, which increases the chances of a spillBAir pockets may cause the fuel to bubble out of the ullage holeCThe temperature rise of the fuel will cause an overflowDFueling valve may become stuck closed and cause the fuel oil to spill before the valve can be opened

单选题燃油中的硫分对缸壁产生的硫酸腐蚀,缸套上部较下部()。A轻B重C较重D严重