Bus Interface Unit BIU
Bus Interface Unit BIU
相关考题：
, the brains of a computer, it contains the ALU, the clock, many registers, the bus interface, and circuitry that makes these pans work together.A．I/O deviceB．CPUC．MemoryD．Operating system
The major goal of USB was to define an external expansion bus which makes adding(71) to a PC as easy as hooking up a telephone to a wall-jack. USB 2.0 is an evolution of the USB 1.1(72), providing a higher performance interface.A．peripheralsB．outsideC．insideD．beside
Messages that are sent electronically over a network．(72)A series of instructions(commands) performed in a sequence specifying actions to accomplish a task．(73)The character code built into most modern personal computers．(74)The minimal unit of information，it can have the value 1 or 0．(75)The brains of a computer, it contains the ALU，the clock，many registers，the bus interface，and circuitry that makes these parts work together．A．inputB．outputC．dataD．E-Mail
Administrators report that they are unable to access the management interface of the EX Series device shown in the exhibit.Which command will resolve this problem?() A. delete me0 disableB. activate me0C. set me0 unit 0 enableD. deactivate me0
To troubleshoot interface problems, you can use both the disable command and the deactivate command. Which two statements are correct?() A.If the interface is disabled, the logical unit will administratively shutdown.B.If the interface is deactivated, the physical interface will administratively shutdown.C.If the interface is deactivated, the interface configuration is ignored during commit.D.If the interface is disabled, the logical unit configuration is ignored during commit.
Which two statements are true regarding interface properties? () A.MTU and speed must be configured under each unit.B.Physical parameters such as MTU, duplex mode, and speed are configured under the interface name.C.IP and IPv6 addresses are configured under a unit-number.D.DLCI numbers, VPI/VCI values, and VLAN tags are physical parameters.
When selecting a Network Interface Card (NIC), which of the following factors need to be considered?（）A、The type of application used on the networkB、The type of system bus used by the computersC、The type of memory installed in each computerD、The type of media used in the network topologyE、The type of protocols used in the networkF、The physical layout of the network hosts
What is the default maximum transmission unit on the Cisco router ATM interface？（）A、4470 bytesB、1516 bytesC、9288 bytesD、1500 bytesE、1492 bytes
You are at the top of the hierarchy and must configure OSPF on interface so-0/0/0 unit 100. Which two achieve this result?（）A、set protocols setospf area 0 set interface so-0/0/0.100B、set protocols ospf area 0 interface so-0/0/0.100C、edit protocols ospf interface so-0/0/0.100D、edit protocols ospf area 0 set interface so-0/0/0.100
Which logical unit number must be configured on an interface using PPP encapsulation?（）A、unit 0B、unit 1C、unit 100D、unit 255
Which two statements are correct regarding units in JUNOS?（）A、Units in JUNOS are always required for any interface configured with logical addresses such as IP and IPv6.B、Units in JUNOS are only required when you are configuring sub-interfaces for inter-VLAN routing.C、Unit numbers must match the DLCI or VCI numbers configured on the interface.D、Unit 0 is the only value allowed on interfaces running HDLC, PPP, or for Ethernet interfaces not doing VLAN-tagging.
Regarding secure tunnel （st） interfaces， which statement is true？（）A、You cannot assign st interfaces to a security zone.B、You cannot apply static NAT on an st interface logical unit.C、st interfaces are optional when configuring a route-based VPND、A static route can reference the st interface logical unit as the next-hop
Which code causes only a Level 2 adjacency to be formed under the SONET interface so-2/2/2 with Frame Relay encapsulation？（）A、so-2/2/2 { unit0 { disable familyiso }}B、isis{ level1 disable； interfaceso-2/2/2.0 { disable } interfaceall；C、so-2/2/2 { unit0 { disablelevel 1； familyiso }}D、isis{ level1 disable； interfaceall； }
Which command configures an address of 192.168.1.1 with a mask of 255.255.255.0 on interface ge-0/0/0?（）A、set ip interface ge-0/0/0 address 192.168.1.1 255.255.255.0B、set ip interface ge-0/0/0 address 192.168.1.1/24C、set interface ge-0/0/0 ip4 address 192.168.1.1 mask 255.255.255.0D、set interfaces ge-0/0/0 unit 0 family inet address 192.168.1.1/24
Which two commands would change the default OSPF metric calculation for interface ge-0/3/0 inJUNOS software?（）A、set interfaces ge-0/3/0 unit 0 metric 10B、set protocols ospf reference-bandwidth 10gC、set interfaces ge-0/3/0 unit 0 bandwidth 10gD、set protocols ospf area 0 interface ge-0/3/0 metric 10E、set protocols ospf area 0 interface ge-0/3/0 bandwidth 10g
增强型电源系统是如何同MCDU相连？A、直接通过每一个GCUB、通过GAPCU和CFDIUC、通过CFDIU同EGIU(ELECTRICAL GENERATION INTERFACE UNIT)
多选题To troubleshoot interface problems, you can use both the disable command and the deactivate command. Which two statements are correct?（）AIf the interface is disabled, the logical unit will administratively shutdown.BIf the interface is deactivated, the physical interface will administratively shutdown.CIf the interface is deactivated, the interface configuration is ignored during commit.DIf the interface is disabled, the logical unit configuration is ignored during commit.
单选题Which logical unit number must be configured on an interface using PPP encapsulation?（）Aunit 0Bunit 1Cunit 100Dunit 255
单选题Why is it useful to carry enough 25-cent coins with you?AThey can act as small change for the exact bus fares.BThere is generally no problem in using them in Canada.CAs a basic unit of money, they are gradually gaining in usage.DThey may come in handy for pay phones or laundry machines.
单选题What is the default maximum transmission unit on the Cisco router ATM interface？（）A4470 bytesB1516 bytesC9288 bytesD1500 bytesE1492 bytes