Which logical unit number must be configured on an interface using PPP encapsulation?（）A、unit 0B、unit 1C、unit 100D、unit 255
Which logical unit number must be configured on an interface using PPP encapsulation?（）
- A、unit 0
- B、unit 1
- C、unit 100
- D、unit 255
相关考题：
Which statement is true about logical units?() A. Logical units are similar to VLANs used by other vendors.B. A logical unit is required for transit interfaces.C. Frame Relay encapsulation supports one logical unit.D. Link speed and duplex are configured in the logical unit properties.
Which two statements are correct regarding units in JUNOS?() A.Units in JUNOS are always required for any interface configured with logical addresses such as IP and IPv6.B.Units in JUNOS are only required when you are configuring sub-interfaces for inter-VLAN routing.C.Unit numbers must match the DLCI or VCI numbers configured on the interface.D.Unit 0 is the only value allowed on interfaces running HDLC, PPP, or for Ethernet interfaces not doing VLAN-tagging.
Which statement is correct about logical units on Juniper Router interfaces?() A.Logical units are used only when a Layer 2 identifier is present such as a VLANB.A logical unit of 0 is required when using a frame-relay DLCIC.A logical unit is always requiredD.Logical units are not required unless ATM or 802.1Q VLAN tagging is configured.
Which two statements are true regarding interface properties? () A.MTU and speed must be configured under each unit.B.Physical parameters such as MTU, duplex mode, and speed are configured under the interface name.C.IP and IPv6 addresses are configured under a unit-number.D.DLCI numbers, VPI/VCI values, and VLAN tags are physical parameters.
Each hand portable fire extinguisher on M/V Utopia must be marked with______．A.the date that it was installed on the unitB.the names of the individuals qualified to use itC.the name of the unit on which it is locatedD.an identification number different from other extinguishers on the unit
Which logical unit number must be configured on an interface using PPP encapsulation?（）A、unit 0B、unit 1C、unit 100D、unit 255
Which two statements are true regarding interface properties? （）A、MTU and speed must be configured under each unit.B、Physical parameters such as MTU, duplex mode, and speed are configured under the interface name.C、IP and IPv6 addresses are configured under a unit-number.D、DLCI numbers, VPI/VCI values, and VLAN tags are physical parameters.
To troubleshoot interface problems, you can use both the disable command and the deactivate command. Which two statements are correct?（）A、If the interface is disabled, the logical unit will administratively shutdown.B、If the interface is deactivated, the physical interface will administratively shutdown.C、If the interface is deactivated, the interface configuration is ignored during commit.D、If the interface is disabled, the logical unit configuration is ignored during commit.
Which statement is true about logical units?（）A、Logical units are similar to VLANs used by other vendors.B、A logical unit is required for transit interfaces.C、Frame Relay encapsulation supports one logical unit.D、Link speed and duplex are configured in the logical unit properties.
An IT manager needs to deploy multiple applications simultaneously. Which virtualization technology will reduce the number of operating system maintenance tasks？（）A、Workload partitionsB、Dynamic logical partitionsC、Dedicated logical partitionsD、Virtualized logical partitions
A customer plans to consolidate multiple business unit applications on a single Power Systems server. The maximum number of cores which can be used by each business unit must be limited by creating shared processor pools. What is the minimum PowerVM Edition which provides this feature?（）A、BasicB、ExpressC、StandardD、Enterprise
Which statement is correct about logical units on Juniper Router interfaces?（）A、Logical units are used only when a Layer 2 identifier is present such as a VLANB、A logical unit of 0 is required when using a frame-relay DLCIC、A logical unit is always requiredD、Logical units are not required unless ATM or 802.1Q VLAN tagging is configured.
Which two statements are correct regarding units in JUNOS?（）A、Units in JUNOS are always required for any interface configured with logical addresses such as IP and IPv6.B、Units in JUNOS are only required when you are configuring sub-interfaces for inter-VLAN routing.C、Unit numbers must match the DLCI or VCI numbers configured on the interface.D、Unit 0 is the only value allowed on interfaces running HDLC, PPP, or for Ethernet interfaces not doing VLAN-tagging.
Regarding secure tunnel （st） interfaces， which statement is true？（）A、You cannot assign st interfaces to a security zone.B、You cannot apply static NAT on an st interface logical unit.C、st interfaces are optional when configuring a route-based VPND、A static route can reference the st interface logical unit as the next-hop
All servers on your network run Windows Server 2008 R2. You plan to configure multiple highly available virtual machines （HAVMs） on a Hyper-V failover cluster. You need to recommend a storage solution that supports high availability. Which storage solution should you recommend？（）A、a direct-attached storage （DAS） deviceB、a multipath serial-attached SCSI drive with a witness diskC、a multipath Fibre Channel logical unit number （LUN） with a witness diskD、a multipath iSCSI logical unit number （LUN） with Cluster Shared Volumes （CSVs）
You host several virtual machines on a Windows Server 2008 R2 Hyper-V failover cluster. You are deploying a highly available virtual machine （HAVM） that supports live migration. You need to install the operating system in the appropriate location. What are two possible locations that will allow you to achieve this goal？（） A、a VHD on network-attached storage （NAS）B、a VHD on an iSCSI logical unit number （LUN）C、a pass-through disk on direct-attached storage （DAS）D、a pass-through disk on a Fibre Channel logical unit number （LUN）
You need to recommend the minimum number of logical unit numbers （LUNs） that must be provisioned for Cluster1. The recommendation must support the company’s planned changes. Which number should you recommend？（）A、1B、2C、8D、9
Which of the following is a requirement for configuring a service IP address using IPAT via Replacement？（）A、The service IP must be in the same logical subnet as all boot IP addressesB、The service IP must be in a different logical subnet to all boot IP addressesC、The service IP must be in the same logical subnet as the persistent IP addressesD、The service IP must be in the same logical subnet as one of the boot IP addresses
单选题Which of the following is a requirement for configuring a service IP address using IPAT via Replacement？（）AThe service IP must be in the same logical subnet as all boot IP addressesBThe service IP must be in a different logical subnet to all boot IP addressesCThe service IP must be in the same logical subnet as the persistent IP addressesDThe service IP must be in the same logical subnet as one of the boot IP addresses
单选题A System p administrator is looking at changing attributes of a logical volume. Which of the following must be defined when it is created（）Aplacement of the logical volumeBstripe size of the logical volumeCinter-disk policy of the logical volumeDintra-disk policy of the logical volume
单选题Which logical unit number must be configured on an interface using PPP encapsulation?（）Aunit 0Bunit 1Cunit 100Dunit 255
单选题Which statement is correct about logical units on Juniper Router interfaces?（）ALogical units are used only when a Layer 2 identifier is present such as a VLANBA logical unit of 0 is required when using a frame-relay DLCICA logical unit is always requiredDLogical units are not required unless ATM or 802.1Q VLAN tagging is configured.
多选题Which two statements are true regarding interface properties? （）AMTU and speed must be configured under each unit.BPhysical parameters such as MTU, duplex mode, and speed are configured under the interface name.CIP and IPv6 addresses are configured under a unit-number.DDLCI numbers, VPI/VCI values, and VLAN tags are physical parameters.
单选题You need to recommend the minimum number of logical unit numbers （LUNs） that must be provisioned for Cluster1. The recommendation must support the company’s planned changes. Which number should you recommend？（）A1B2C8D9
单选题Which statement is true about logical units?（）ALogical units are similar to VLANs used by other vendors.BA logical unit is required for transit interfaces.CFrame Relay encapsulation supports one logical unit.DLink speed and duplex are configured in the logical unit properties.
单选题All servers on your network run Windows Server 2008 R2. You plan to configure multiple highly available virtual machines （HAVMs） on a Hyper-V failover cluster. You need to recommend a storage solution that supports high availability. Which storage solution should you recommend？（）Aa direct-attached storage （DAS） deviceBa multipath serial-attached SCSI drive with a witness diskCa multipath Fibre Channel logical unit number （LUN） with a witness diskDa multipath iSCSI logical unit number （LUN） with Cluster Shared Volumes （CSVs）
单选题Each hand portable fire extinguisher on a ship must be marked with（）.Athe name of the unit on which it is locatedBthe date that it was installed on the unitCthe names of the individuals qualified to use itDan identification number different from other extinguishers on the unit
单选题Regarding secure tunnel （st） interfaces， which statement is true？（）AYou cannot assign st interfaces to a security zone.BYou cannot apply static NAT on an st interface logical unit.Cst interfaces are optional when configuring a route-based VPNDA static route can reference the st interface logical unit as the next-hop