多选题An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports21, 23 and 25. What types of packets will be permitted by this ACL? (Choose three.)（）AFTPBTelnetCSMTPDDNSEHTTPFPOP3
多选题
An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports21, 23 and 25. What types of packets will be permitted by this ACL? (Choose three.)（）
A
FTP
B
Telnet
C
SMTP
D
DNS
E
HTTP
F
POP3
参考解析
解析：
暂无解析
相关考题：
Your ERX Edge Router is using an inbound route-map for an EBGP peer to only accept routes in the range of 192.168.32.0 through 192.168.95.255. The route-map references an access list named test .What accurately accomplishes the goal of the route-map?（）A. access-list test 192.168.32.0 0.0.63.255B. access-list test permit 192.168.32.0 0.0.64.255C. access-list test permit 192.168.32.0 0.0.63.255D. access-list test permit 192.168.32.0 255.255.63.0
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines.What command would assign this access- list to the Virtual Terminal Lines?（）A. router(config-line)# ip access-group 1 inB. router(config-line)# access-class 1 inC. router(config-line)# ip access-list 1 inD. router(config-line)# access-line 1 in
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A. oneB. threeC. twoD. zero
Refer to the exhibit. Switch port FastEthernet 0/24 on AlSwitch1 will be used to create an IEEE 802.1Q- complaint trunk to another switch. Based on the output shown, What is the reason the trunk does not form, even thought the proper cabling has been attached?（）A.VLANs have not been created yetB.An IP address must be configured for the portC.The port is currently configured for access modeD.The correct encapsulation type has not been configuredE.The no shutdown command has not been entered for the port
Router R1 has been configured for EIGRP. The configuratio n also includes an ACL with one line -access - list 1 permit 10.100.32.0 0.0.15.255 - and the EIGRP configuration includes the distribute -list 1 in command. Which of the following routes could not be displayed in the output of the show ip eigrp topology comm and as a result?（）A、10.10.32.0/19B、10.10.44.0/22C、10.10.40.96/27D、10.10.48.0/23E、10.10.60.0/30
An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL (Choose three.)（）。A、FTPB、TelnetC、SMTPD、DNSE、HTTPF、POP3
Whenever a failover takes place on the ASA （configured for failover）， all active connections are droppedand clients must re-establish their connections unless： （）A、 The ASA is configured for Active-Standby failover.B、The ASA is configured for Active-Activefailover.C、 The ASA is configured for Active-Active failover and a state failover link has been configured.D、 The ASA is configured for Active-Standby failover and a state failover link has been configured.E、 The ASA is configured to use a serial cable as the failover link.F、 The ASA is configured for LAN-Based failover
Refer to the exhibit. Which statement is correct based on the show login command output shown？（）A、When the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.B、The login block-for command is configured to block login hosts for 93 seconds.C、All logins from any sources are blocked for another 193 seconds.D、Three or more login requests have failed within the last 100 seconds.
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router
A network administrator has configured access list 172 to prevent Telnet and ICMP traffic from reaching a server with the address if 192.168.13.26. Which command can the administrator issue to verify that the access list is working properly?（）A、Router# ping 192.168.13.26B、Router# debug access-list 172C、Router# show open ports 192.168.13.26D、Router# show access-listE、Router# show ip interface
Your ERX Edge Router is using an inbound route-map for an EBGP peer to only accept routes in the range of 192.168.32.0 through 192.168.95.255. The route-map references an access list named test . What accurately accomplishes the goal of the route-map?（）A、access-list test 192.168.32.0 0.0.63.255B、access-list test permit 192.168.32.0 0.0.64.255C、access-list test permit 192.168.32.0 0.0.63.255D、access-list test permit 192.168.32.0 255.255.63.0
On the serial interface of a router, an inbound access list is configured to deny all traffic from UDP and TCP ports 21, 23, and 25. All other traffic is permitted. Based on this information, which types of traffic will be allowed through this interface?（）A、SMTPB、DNSC、FTPD、TelnetE、HTTPF、POP3
The Frame Relay network in the diagram is not functioning properly. What is the cause of the problem?（）A、The Gallant router has the wrong LMI type configuredB、Inverse ARP is providing the wrong PVC information to the Gallant routerC、The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf commandD、The frame-relay map statement in the Attalla router for the PVC to Steele is not correctE、The IP address on the serial interface of the Attalla router is configured incorrectly
A standard access control list has been configured on a router and applied to interface Serial 0 in anoutbound direction. No ACL is applied to Interface Serial 1 on the same router. What will happen whentraffic being filtered by the access list does not match the configured ACL statements for Serial 0？（）A、The traffic is droppedB、The resulting action is determined by the destination IP addressC、The source IP address is checked，and，if a match is not found， traffic is routed out interface Serial 1D、The resulting action is determined by the destination IP address and port number
You wish to limit telnet access into your Cisco router to only a single host. In order to accomplish this, access list 1 has been written to allow host 172.16.1.224 access to the router vty lines. What command would assign this access- list to the Virtual Terminal Lines?（）A、router(config-line)# ip access-group 1 inB、router(config-line)# access-class 1 inC、router(config-line)# ip access-list 1 inD、router(config-line)# access-line 1 in
An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports21, 23 and 25. What types of packets will be permitted by this ACL? (Choose three.)（）A、FTPB、TelnetC、SMTPD、DNSE、HTTPF、POP3
An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL? （）A、FTPB、TelnetC、SMTPD、DNSE、HTTPF、POP3
A company has a small network,consisting of a single switch and a single router.The switch has been configured with two vlans,and route-on-a-stick is being configured on the router for inter-vlan routing.A trunk is configured to connect the switch to the router.What is the minimum number of router subinterfaces that are required for all the vlans to communicate?（）A、oneB、threeC、twoD、zero
单选题Refer to the exhibit. Which statement is correct based on the show login command output shown？（）AWhen the router goes into quiet mode， any host is permitted to access the router via Telnet，SSH， and HTTP，since the quiet-mode access list has not been configured.BThe login block-for command is configured to block login hosts for 93 seconds.CAll logins from any sources are blocked for another 193 seconds.DThree or more login requests have failed within the last 100 seconds.
多选题An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports21, 23 and 25. What types of packets will be permitted by this ACL? (Choose three.)（）AFTPBTelnetCSMTPDDNSEHTTPFPOP3
多选题An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL (Choose three.)（）。AFTPBTelnetCSMTPDDNSEHTTPFPOP3
多选题On the serial interface of a router, an inbound access list is configured to deny all traffic from UDP and TCP ports 21, 23, and 25. All other traffic is permitted. Based on this information, which types of traffic will be allowed through this interface?（）ASMTPBDNSCFTPDTelnetEHTTPFPOP3
多选题An inbound access list has been configured on a serial interface to deny packet entry for TCP and UDP ports 21, 23 and 25. What types of packets will be permitted by this ACL? （）AFTPBTelnetCSMTPDDNSEHTTPFPOP3
多选题Router R1 has been configured for EIGRP. The configuratio n also includes an ACL with one line -access - list 1 permit 10.100.32.0 0.0.15.255 - and the EIGRP configuration includes the distribute -list 1 in command. Which of the following routes could not be displayed in the output of the show ip eigrp topology comm and as a result?（）A10.10.32.0/19B10.10.44.0/22C10.10.40.96/27D10.10.48.0/23E10.10.60.0/30
多选题Whenever a failover takes place on the ASA （configured for failover）， all active connections are droppedand clients must re-establish their connections unless： （）AThe ASA is configured for Active-Standby failover.BThe ASA is configured for Active-Activefailover.CThe ASA is configured for Active-Active failover and a state failover link has been configured.DThe ASA is configured for Active-Standby failover and a state failover link has been configured.EThe ASA is configured to use a serial cable as the failover link.FThe ASA is configured for LAN-Based failover
单选题A standard access control list has been configured on a router and applied to interface Serial 0 in anoutbound direction. No ACL is applied to Interface Serial 1 on the same router. What will happen whentraffic being filtered by the access list does not match the configured ACL statements for Serial 0？（）AThe traffic is droppedBThe resulting action is determined by the destination IP addressCThe source IP address is checked，and，if a match is not found， traffic is routed out interface Serial 1DThe resulting action is determined by the destination IP address and port number
多选题A network administrator has configured access list 172 to prevent Telnet and ICMP traffic from reaching a server with the address if 192.168.13.26. Which command can the administrator issue to verify that the access list is working properly?（）ARouter# ping 192.168.13.26BRouter# debug access-list 172CRouter# show open ports 192.168.13.26DRouter# show access-listERouter# show ip interface
单选题A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）AFor the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.BFor the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.CDirect inter-vlan communication does not require OSPFDOSPF cannot be used if router-on-a-stick is configured on the router