单选题What is the data encapsulation method for the VPLS virtual circuit （VC）？（）AMAC over MPLSBL2TPV3C802.1 QinQDEthernet over MPLSEGRE
单选题
What is the data encapsulation method for the VPLS virtual circuit （VC）？（）
A
MAC over MPLS
B
L2TPV3
C
802.1 QinQ
D
Ethernet over MPLS
E
GRE
参考解析
解析：
暂无解析
相关考题：
What is a method by which an IP interface can be assigned to a virtual router in a PPP over ATM environment?() A.policy listB.RADIUS VSAC.classifier ACLD.LCP negotiation
You are bringing up a new Ezonexam switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?A．Switch(config)# switchport trunk encapsulation islB．Switch(config)# switchport trunk encapsulation ietfC．Switch(config-if)# switchport trunk encapsulation islD．Switch(config-if)# switchport trunk encapsulation ietfE．Switch(config-if)# switchport trunk encapsulation dot1q
What are three factors a network administrator must consider before implementing Netflow in the network?() A.CPU utilizationB.where Netflow data will be sentC.number of devices exporting Netflow dataD.port availabilityE.SNMP versionF.WAN encapsulation
As a frame leaves a Layer 3 device, the Layer 2 encapsulation information is changed from what it was when it entered the device. For what two reasons can this happen?() A. The data is moving from 10BASE-TX to 100BASE-TX.B. The WAN encapsulation type has changed.C. The data format has changed from analog to digital.D. The source and destination hosts are in the same subnet.E. The source and destination MAC addresses have changed.
Which WAN service utilizes two different encapsulation types (one for data and one for signaling) on its data link layer?（）A、ISDNB、Frame RelayC、ATMD、FDDI
Which two implementations are standard Virtual Private LAN Service （VPLS） implementations that aresupported by the IETF？（）A、VPLS uses LDP for signaling.B、VPLS uses BGP for autodiscovery and signaling.C、VPLS uses extended IS-IS for signalingD、VPLS uses OSPF version 3 for auto discovery and signalingE、VPLS uses spanning tree for signaling
What are three factors a network administrator must consider before implementing Netflow in the network?（）A、CPU utilizationB、where Netflow data will be sentC、number of devices exporting Netflow dataD、port availabilityE、SNMP versionF、WAN encapsulation
What is a method by which an IP interface can be assigned to a virtual router in a PPP over ATM environment?（）A、policy listB、RADIUS VSAC、classifier ACLD、LCP negotiation
（）is not a physical wall but a flow virtual data to protect the computer network.A、data wallB、data channelC、databaseD、firewall
What is the objective of the aaa authentication login console-in local command？（）A、It specifies the login authentication method list named console-in using the local user database on the routerB、It specifies the login authorization method list named console-in using the local RADIUS username-password data baseC、It specifies the login authentication list named console-in using the local username- password data base on the routerD、It specifies the login authorization method list named console-in using the local username- password data base on the router
S9300支持的VPN类型有（）A、VPDN（Virtual Private Dial Network）B、VPRN（Virtual Private Routing Network）C、VLL（Virtual Leased Line）D、VPLS（Virtual Private LAN Service）
Which two demonstrate encapsulation of data？ （）A、 Member data have no access modifiers.B、 Member data can be modified directly.C、 The access modifier for methods is protected.D、 The access modifier to member data is private.E、 Methods provide for access and modification of data.
（）is not a physical wall, but a lot of virtual data to protect the computer network. A、Data wallB、Data ChannelC、Data baseD、firewall
You are bringing up a new Cisco Catalyst switch, and wish to connect it via a trunk to another switch from a different vendor, which uses the IEEE standard for the trunking method. When setting the encapsulation type on the trunk, what should you configure on the Cisco switch?（）A、Switch(config)# switchport trunk encapsulation islB、Switch(config)# switchport trunk encapsulation ietfC、Switch(config-if)# switchport trunk encapsulation islD、Switch(config-if)# switchport trunk encapsulation ietfE、Switch(config-if)# switchport trunk encapsulation dot1q
As a frame leaves a Layer 3 device, the Layer 2 encapsulation information is changed from what it was when it entered the devicE.For what two reasons can this happen? （）A、The data is moving from 10BASE-TX to 100BASE-TX.B、The WAN encapsulation type has changed.C、The data format has changed from analog to digital.D、The source and destination hosts are in the same subnet.E、The source and destination MAC addresses have changed.
What are key benefits of IBM Systems Director Standard Edition?（）A、Backup data Manage problems Monitor network systemB、Report problems Manage servers and virtual environment Monitor the network C、Monitor system health and network Install and manage AIX and IBM i Manage energy consumption D、Monitor system health and network Manage servers and virtual environment Collect performance data
You run a 16-bit scientific data analysis package on your Windows 2000 Professional computer. The package consists of three components. The first component is a data acquisition application that monitors continuous data output from scientific instruments. The second component is a data analysis application that receives data from the data acquisition application by using shared memory. The third component is a data graphing application that displays the processed data in real time. The data analysis application communicates with the data graphing application by using OLE. When you attempt to analyze large data sets, your computer is not able to display data in real time. You install a second processor in your computer; only one processor is used while the package is running, even though task manager shows both processors. You want your data analysis package to use both processors. What should you do?（）A、Configure the data acquisition application to run in its own virtual DOS machine (VDM).B、Configure the data analysis application to run in its own virtual DOS machine (VDM).C、Configure the data graphing application to run in its own virtual DOS machine (VDM).D、Configure the virtual DOS machine for the data acquisition and data analysis applications to.have a hard affinity for processor 0. Configure the VDM for the data graphing application to.have a hard affinity for processor1. E、Configure the virtual DOS machine for the data acquisition to have a hard affinity for processor 0. Configure the VDM for the data graphing application to have a hard affinity for processor1.
You run a 16-bit scientific data analysis package on your Windows 2000 Professional computer. Thepackage consists of three components.The first component is a data acquisition application that monitors continuous data output fromscientific instruments. The second component is a data analysis application that receives data from thedata acquisition application by using shared memory. The third component is a data graphingapplication that displays the processed data in real time.The data analysis application communicates with the data graphing application by using OLE. When youattempt to analyze large data sets, your computer is not able to display data in real time. You install asecond processor in your computer. Only one processor is used while the package is running, even thoughtask manager shows both processors.You want your data analysis package to use both processors. What should you do?（）A、Configure the data acquisition application to run in its own virtual DOS machine (VDM). B、Configure the data analysis application to run in its own virtual DOS machine (VDM). C、Configure the data graphing application to run in its own virtual DOS machine (VDM). D、Configure the virtual DOS machine for the data acquisition and data analysis applications to have a hard affinity for processor 0. Configure the VDM for the data graphing application to have a hard affinity for processor1. E、Configure the virtual DOS machine for the data acquisition to have a hard affinity for processor 0.Configure the VDM for the data graphing application to have a hard affinity for processor1.
多选题What are three factors a network administrator must consider before implementing Netflow in the network?（）ACPU utilizationBwhere Netflow data will be sentCnumber of devices exporting Netflow dataDport availabilityESNMP versionFWAN encapsulation
多选题You run a 16-bit scientific data analysis package on your Windows 2000 Professional computer. Thepackage consists of three components.The first component is a data acquisition application that monitors continuous data output fromscientific instruments. The second component is a data analysis application that receives data from thedata acquisition application by using shared memory. The third component is a data graphingapplication that displays the processed data in real time.The data analysis application communicates with the data graphing application by using OLE. When youattempt to analyze large data sets, your computer is not able to display data in real time. You install asecond processor in your computer. Only one processor is used while the package is running, even thoughtask manager shows both processors.You want your data analysis package to use both processors. What should you do?（）AConfigure the data acquisition application to run in its own virtual DOS machine (VDM).BConfigure the data analysis application to run in its own virtual DOS machine (VDM).CConfigure the data graphing application to run in its own virtual DOS machine (VDM).DConfigure the virtual DOS machine for the data acquisition and data analysis applications to have a hard affinity for processor 0. Configure the VDM for the data graphing application to have a hard affinity for processor1.EConfigure the virtual DOS machine for the data acquisition to have a hard affinity for processor 0.Configure the VDM for the data graphing application to have a hard affinity for processor1.
单选题Given： Which statement is true？（）A The cardID and limit variables break polymorphism.B The code demonstrates polymorphism.C The ownerName variable breaks encapsulation.D The setCardInformation method breaks encapsulation.E The class is fully encapsulated.
多选题You run a 16-bit scientific data analysis package on your Windows 2000 Professional computer. The package consists of three components. The first component is a data acquisition application that monitors continuous data output from scientific instruments. The second component is a data analysis application that receives data from the data acquisition application by using shared memory. The third component is a data graphing application that displays the processed data in real time. The data analysis application communicates with the data graphing application by using OLE. When you attempt to analyze large data sets, your computer is not able to display data in real time. You install a second processor in your computer; only one processor is used while the package is running, even though task manager shows both processors. You want your data analysis package to use both processors. What should you do?（）AConfigure the data acquisition application to run in its own virtual DOS machine (VDM).BConfigure the data analysis application to run in its own virtual DOS machine (VDM).CConfigure the data graphing application to run in its own virtual DOS machine (VDM).DConfigure the virtual DOS machine for the data acquisition and data analysis applications to.have a hard affinity for processor 0. Configure the VDM for the data graphing application to.have a hard affinity for processor1.EConfigure the virtual DOS machine for the data acquisition to have a hard affinity for processor 0. Configure the VDM for the data graphing application to have a hard affinity for processor1.
单选题What is a method by which an IP interface can be assigned to a virtual router in a PPP over ATM environment？（）AprofileBpolicylistCclassifier ACLDLCP negotiation
单选题Companycom has a p5 590 that has their production LPAR, their Tivoli Storage Manager (TSM) LPAR, and several other LPARs. What method would provide connectivity between the production LPAR, and the TSM LPAR, but be isolated from the other LPARs in the system without utilizing a Virtual IO Server or physical adapter resources?（）AUse shared memory and semaphores to transfer the data to the TSM LPARBProvide gigabit Ethernet adapters in each LPAR and run a crossover cableCCreate a Virtual Ethernet between the production server and the TSM LPARsDCreate a Virtual Ethernet between the TSM server LPAR and the non-production LPARs
单选题What is the objective of the aaa authentication login console-in local command？（）AIt specifies the login authentication method list named console-in using the local user database on the routerBIt specifies the login authorization method list named console-in using the local RADIUS username-password data baseCIt specifies the login authentication list named console-in using the local username- password data base on the routerDIt specifies the login authorization method list named console-in using the local username- password data base on the router
多选题As a frame leaves a Layer 3 device, the Layer 2 encapsulation information is changed from what it was when it entered the device. For what two reasons can this happen?（）AThe data is moving from 10BASE-TX to 100BASE-TX.BThe WAN encapsulation type has changed.CThe data format has changed from analog to digital.DThe source and destination hosts are in the same subnet.EThe source and destination MAC addresses have changed.
单选题What are key benefits of IBM Systems Director Standard Edition?（）ABackup data Manage problems Monitor network systemBReport problems Manage servers and virtual environment Monitor the network CMonitor system health and network Install and manage AIX and IBM i Manage energy consumption DMonitor system health and network Manage servers and virtual environment Collect performance data