单选题In a JSRP cluster with two J6350 routers, the interface ge-7/0/0 belongs to which device? （）AThis interface is a system-created interface.BThis interface belongs to NODE0 of the cluster.CThis interface belongs to NODE1 of the cluster.DThis interface will not exist because J6350 routers have only six slots.
单选题
In a JSRP cluster with two J6350 routers, the interface ge-7/0/0 belongs to which device? （）
A
This interface is a system-created interface.
B
This interface belongs to NODE0 of the cluster.
C
This interface belongs to NODE1 of the cluster.
D
This interface will not exist because J6350 routers have only six slots.
参考解析
解析：
暂无解析
相关考题：
Which two considerations must you take into account when deploying a Junos Pulse Access Control Service cluster?() A. State synchronization occurs only through the internal network interface card (NIC)B. Latency of the WAN must be less than 300 ms.C. Authenticating endpoints must be on the same LAN segment.D. Cluster members must use the same hardware platfor
In a chassis cluster with two SRX 5800 devices, the interface ge－13／0／0 belongs to which device?() A. This interface is a system-created interface.B. This interface belongs to node 0 of the cluster.C. This interface belongs to node 1 of the cluster.D. This interface will not exist because SRX 5800 devices have only 12 slots.
In a JSRP cluster with two J6350 routers, the interface ge－7／0／0 belongs to which device? () A. This interface is a system-created interface.B. This interface belongs to NODE0 of the cluster.C. This interface belongs to NODE1 of the cluster.D. This interface will not exist because J6350 routers have only six slots.
Routers A and B are connected with a point-to-point OC-3 interface. Each router‘s OC-3 interface is configured for both Level 1 and Level 2. The routers are configured in the same area.How many IS-IS adjacencies exist between the two routers?（）A.0B.1C.2D.3
Routers A and B are connected with a point-to-point OC-3 interface. Each routers OC-3 interface is configured for both Level 1 and Level 2. The routers are configured in different areas. How many IS-IS adjacencies exist between the two routers?（）A.0B.1C.2D.3
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state.Which two of these are possible causes? （）A. Bandwidth statements do not matchB. MTUs do not matchC. IP Addresses are not in the same subnetD. CHAP passwords do not match
There is a connectivity problem between the serial 0/0 interface of router TESTKING1 and the serial 0/0 interface of TESTKING2. A leased line point to point circuit is installed between these two routers. The output from the show interface serial 0/0 command is displayed below for each of these routers:From your observations of the above exhibit, what is the underlying cause of the problem?（）A. The loopback is not set.B. The serial cable is faulty.C. The subnet mask is not configured properly.D. The IP address is not configured properly.E. The Layer 2 frame types are not compatible.F. The keepalive setting is not configured properly.
Routers R1 and R2 use HSRP so that one router will back up the other should there be a failure. Which two statements are true about the Hot Standby Router Protocol （HSRP）？ （）A、 Load sharing with HSRP is achieved by creating multiple subinterfaces on the HSRP routers. B、 Routers configured for HSRP can belong to multiple groups and multiple VLANs.C、 Load sharing with HSRP is achieved by creating HSRP groups on the HSRP routers.D、 All routers configured for HSRP load balancing must be configured with the same priority. E、 Routers configured for HSRP must belong to only one group per HSRP interface.
CIS .com recently acquired a smaller competitor. The acquired company is not currently using Cisco routers, so you have connected the two WANs via an authenticated PPP link. After configuration both routers, issuing the show interface s0/0 command on the Cisco Router shows the interface to be in the up/down state. Which two of these are possible causes? （）A、Bandwidth statements do not matchB、MTUs do not matchC、IP Addresses are not in the same subnetD、CHAP passwords do not match
In a chassis cluster with two SRX 5800 devices， the interface ge-13/0/0 belongs to which device？（）A、This interface is a system-created interface.B、This interface belongs to node 0 of the cluster.C、This interface belongs to node 1 of the cluster.D、This interface will not exist because SRX 5800 devices have only 12 slots.
Which two considerations must you take into account when deploying a Junos Pulse Access Control Service cluster?（）A、State synchronization occurs only through the internal network interface card (NIC)B、Latency of the WAN must be less than 300 ms.C、Authenticating endpoints must be on the same LAN segment.D、Cluster members must use the same hardware platfor
In order to cluster IBM SONAS interface nodes so that they can serve the same data, the interface nodes must coordinate their locking and recovery. This coordination is done through（）.A、SONAS Health CenterB、SONAS Cluster ManagerC、Tivoli Storage ManagerD、Windows Active Directory
Which two are characteristics of link-state routing protocols?（） (Choose two.)A、Routers choose a best path for a destination based on the SPF algorithm.B、All routers in a given area or level build a consistent database describing the network's topology.C、Routers choose the best path for a destination based on the interface on which they received the link stateadvertisement with the lowest cost.D、All routers in a given area or level forward link state advertisements between interfaces in the same area or level, adding their metric to the link state advertisement's cost information when they forward it.
Routers A and B are connected with a point-to-point OC-3 interface. Each routers OC-3 interface is configured for both Level 1 and Level 2. The routers are configured in different areas. How many IS-IS adjacencies exist between the two routers?（）A、0B、1C、2D、3
When configuring IOS firewall （CBAC） operations on Cisco routers， the "inspection rule" could be applied at which two locations？ （）A、 at the untrusted interfacein the inbound directionB、 atthe untrusted interface in theoutbounddirectionC、 at thetrusted interface inthe inbound directionD、 at the trusted interface in the outbound directionE、 at the trusted and untrusted interfaces in the inbound directionF、 at the trusted and untrusted interfaces in the outbounddirection
In a cluster using /etc/hosts for name resolution， which of the following describes the minimum requirementsfor the /etc/hosts file？（）A、IP address and IP label of each service and boot interface in the clusterB、IP address and IP label of each service and boot interface in the cluster， loopback interface， and the hostname of the nodeC、IP address and IP label of each service and boot interface in the cluster， the loopbackinterface， and the cluster gatewayD、IP address and IP label of each service and boot interface in the cluster， the loopbackinterface， the cluster gateway， and the subnet network addresses
A two-node cluster is configured for mutual takeover with two service IP labels. The cluster is Being tested for fallover behavior. Both nodes in the cluster have two network interfaces （ent0’ and ’ent1’） configured with IPAT via IP Replacement. When the network cable is removed from the interface card with the service address （’ent0’）， the service address is moved to ’ent1’， and ’ent0’ is reconfigured on its boot address. When the network cable is replaced on ’ent0，the service address does not switch back to ’ent0’. What statement most accurately describes this situation？（） A、 EtherChannel is needed to automatically switch the service IP address back to ’ent0’.B、 This is the default behavior for a network interface failure with this configuration.C、 Gratuitous ARP support needs to be enabled for the IP Network Interface Module in SMIT.D、 The Inactive Network Takeover option should be set to "true" to forece the service addressback to ’ent0’.
In a JSRP cluster with two J6350 routers, the interface ge-7/0/0 belongs to which device? （）A、This interface is a system-created interface.B、This interface belongs to NODE0 of the cluster.C、This interface belongs to NODE1 of the cluster.D、This interface will not exist because J6350 routers have only six slots.
Which two statements are true regarding high-availability chassis clustering？（）A、A chassis cluster consists of two devices.B、A chassis cluster consists of two or more devices.C、Devices participating in a chassis cluster can be different models.D、Devices participating in a chassis cluster must be the same models
单选题What is the purpose of a chassis cluster?（）AChassis clusters are used to aggregate routes.BChassis clusters are used to create aggregate interfaces.CChassis clusters are used to group two chassis into one logical chassis.DChassis clusters are used to group all interfaces into one cluster interface.
单选题Routers A and B are connected with a point-to-point OC-3 interface. Each routers OC-3 interface is configured for both Level 1 and Level 2. The routers are configured in different areas. How many IS-IS adjacencies exist between the two routers?（）A0B1C2D3
单选题What is the functionality of redundant interfaces （reth） in a chassis cluster？（）Areth interfaces are used only for VRRP.Breth interfaces are the same as physical interfaces.Creth interfaces are pseudo-interfaces that are considered the parent interface for two physical interfaces.DEach cluster member has a reth interface that can be used to share session state information with the other cluster members.
多选题When configuring IOS firewall （CBAC） operations on Cisco routers， the "inspection rule" could be applied at which two locations？ （）Aat the untrusted interfacein the inbound directionBatthe untrusted interface in theoutbounddirectionCat thetrusted interface inthe inbound directionDat the trusted interface in the outbound directionEat the trusted and untrusted interfaces in the inbound directionFat the trusted and untrusted interfaces in the outbounddirection
单选题In a chassis cluster with two SRX 5800 devices， the interface ge-13/0/0 belongs to which device？（）AThis interface is a system-created interface.BThis interface belongs to node 0 of the cluster.CThis interface belongs to node 1 of the cluster.DThis interface will not exist because SRX 5800 devices have only 12 slots.
单选题Routers A and B are connected with a point-to-point OC-3 interface. Each router’s OC-3 interface is configured for both Level 1 and Level 2. The routers are configured in different areas.How many IS-IS adjacencies exist between the two routers？（）A0B1C2D3
单选题The en0 interface on Node1 of a two-node cluster has failed. This adapter is configured with a boot addressand under stable operations also has the service address of the cluster’s single resource group. The resourcegroup is configured with the fallback option. The HA network was configured for IPAT via aliasing and now theservice address is on the en1 interface in the cluster. The en0 interface has already been physically replacedand configured with the boot address. Which of the following will return the cluster to its original state andminimize cluster downtime？（）ARun cluster synchronization.BRestart cluster services on Node1.CPerform a swap_adapter using C-SPOCDRestart cluster services on both nodes
多选题Which two statements are true regarding high-availability chassis clustering？（）AA chassis cluster consists of two devices.BA chassis cluster consists of two or more devices.CDevices participating in a chassis cluster can be different models.DDevices participating in a chassis cluster must be the same models