Your network consists of a large hub － and － spoke Frame Relay network with a CIR of 56 kb／s foreach spoke. Which statement about the selection of a dynamic protocol is true?() A. EIGRP would be appropriate if LMI type ANS I is NOT used.B. EIGRP would be appropriate, because the Frame Relay spokes could be segmented into their own areas.C. EIGRP would be appropriate, because by default, queries are not propagated across the slow speed Frame Relay links.D. EIGRP would be appropriate, because you can manage how much bandwidth is consumed over the Frame Relay interface.
Your network consists of a large hub － and － spoke Frame Relay network with a CIR of 56 kb／s foreach spoke. Which statement about the selection of a dynamic protocol is true?()
A. EIGRP would be appropriate if LMI type ANS I is NOT used.
B. EIGRP would be appropriate, because the Frame Relay spokes could be segmented into their own areas.
C. EIGRP would be appropriate, because by default, queries are not propagated across the slow speed Frame Relay links.
D. EIGRP would be appropriate, because you can manage how much bandwidth is consumed over the Frame Relay interface.
相关考题：
Refer to the exhibit. Which statement about dynamic routing protocols for this network is true? () A.No dynamic interior routing protocol can summarize as shownB.Unless configured otherwise, EIGRP would automatically summa rize the prefixes as shown in the exhibitC.With this IP addressing scheme, EIGRP can be manually configured to summarize prefixes at the specified summarization pointsD.The IP address design lends itself to OSPF Each summarizing router would be an ABR, summarizing to the next area in the address hierarchy
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? () A. frame-relay arpB. frame-relay mapC. frame-relay interface-dlciD. frame-relay lmi-type
Refer to the exhibit. You are the network administrator of the Route.com company. You have been tasked to implement a hub and spoke EIGRP topology over Frame Relay to provide connectivity between the networks at headquarters and all 300 spokes. Before you begin the actual implementation, which three pieces of information are more important to know than the others?（）A. the Committed Information Rate of all the Frame Relay PVCsB. the Cisco IOS version running on all the routersC. the router model number of all the spoke routersD. the number of HQ networks connected behind the headquarter routersE. the routing policy, such as whether or not the spokes can be used as backup transient point between the two headquarter routers
In regard to a hub and spoke Frame－Relay data network, what kind of physical network is it classified as?() A. point-to-pointB. broadcast multi-accessC. nonbroadcast multipointD. nonbroadcast multi-accessE. broadcast point-to-multipoint
OSPF is configured over a Frame Relay network as shown in the exhibit. All PVCs are active.However, R1 and R3 fail to see all OSPF routes in their routing tables. The show ip ospf neighbor command executed on R2 shows the state of t he neighbors. What should be done to fix the problem? （）A. The ip ospf network broadcast command should be configured on each Frame Relay interfaceB. The ip ospf network non -broadcast command should be configured on each Frame Relay interfaceC. Th e ip ospf priority value on the spoke routers should be set to 0D. The ip ospf priority value on the hub router should be set to 0E. The neighbor command should be configured under the OSPF routing process on all routers
A new frame－relay network is being implemented and inverse ARP does not appear to be operating correctly. Which alternative command can be used to provide connectivity?() A. frame-relay arpB. frame-relay mapC. frame-relay interface-dlciD. frame-relay lmi-typeE. frame-relay pvc
You are the network consultant from pass4sure.com. One of your customer has six sites, three of which process a large amount of traffic among them. He plans to grow the number of sites in the future. Which is the most appropriate design topology?（）A.full meshB.peer-to-peerC.partial meshD.hub and spoke
Which two statements are correct about configuring AutoQoS on a Cisco router？ （）A、 AutoOoS can be implemented on only one side of a link.B、The interface does not have to have an IP address associated with it.C、The AutoOoS feature cannot be configured on a Frame Relay DLCI if a map class is attached to the DLCI.D、In a Frame Relay network， AutoOoS cannot be configured if a DLCI is already assigned to the Frame Relay subinterface
You are the network consultant from pass4sure.com. One of your customer has six sites, three of which process a large amount of traffic among them. He plans to grow the number of sites in the future. Which is the most appropriate design topology?（）A、full meshB、peer-to-peerC、partial meshD、hub and spoke
Which statement about Frame Relay is not true？（）A、Static mapping is used when the remote router does not support Inverse ARP.B、Frame Relay Inverse ARP requires LMI capability to construct an address to the DLCI mapping tableon the router.C、Frame Relay Inverse ARP is disabled by default in Cisco IOS Software for all protocols that areenabled on the physical interface.D、Inverse ARP does not work when LMI is disabled.E、Frame Relay provides forward and backward congestion notification messages
In regard to a hub and spoke Frame-Relay data network, what kind of physical network is it classified as?（）A、point-to-pointB、broadcast multi-accessC、nonbroadcast multipointD、nonbroadcast multi-accessE、broadcast point-to-multipoint
A new frame-relay network is being implemented and inverse ARP does not appear to be operating correctly. Which alternative command can be used to provide connectivity?（）A、frame-relay arpB、frame-relay mapC、frame-relay interface-dlciD、frame-relay lmi-typeE、frame-relay pvc
Which statement is true about the Cisco Self-Defending Network?（）A、The Cisco Self-Defending Network defines the physical position of the firewall to protect against internal and external attacksB、The Cisco Self-Defending Network Provides static filtering against known and unknown internal and external attacksC、The Cisco Self-defending Network Provides dynamic protection against known and unknown internal and external attacksD、The Cisco Self-defending Network Provides the Elements to install the antivirus software on the End-User Workstation
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router
Which three statements about L2TPv3 are true？（）A、L2TPv3 Frame Relay support includes only 32-bit DLCI addressingB、L2TPv3 sessions do not support Frame Relay LMI interworkingC、Multipoint DLCI is not supportedD、To use DCE or a Network-to-Network Interface on a Frame Relay port， you must configure the frame-relay switching commandE、L2TPv3 feature does not support Frame Relay extended addressing
Customer X has a hub-and-spoke Frame Relay network， with a central office and two branch offices （RemoteA and RemoteB）. Each location has only one physical link to the Frame Relay cloud and RemoteB has a router that is not a Cisco router. Since the installation， there is no connectivity between RemoteB and the central office. What is a possible solution to this issue？ （）A、 Because Frame Relay IETF encapsulation is only configurable at interface level， you must use IETF encapsulation on all routers.B、 This is not a possible scenario. A dedicated Frame Relay link to RemoteB is mandatory at the central office.C、 The router at RemoteB must be replaced by a Cisco router.D、 Use Frame Relay IETF encapsulation on a per-VC basis on the central office router.E、 There is a problem in the Frame Relay cloud， because Cisco routers are compatible with IETF Frame Relay.
Which Cisco IOS traffic-shaping mechanism statement is true？ （）A、class-based policing is configured using the Modular QoS command-line （MQC）B、only the Frame Relay traffic-shaping （FRTS） mechanism can interact with a Frame Relay network， adapting to indications of Layer2 congestion in the WAN linksC、Distributed Traffic Shaping （DTS） is configured with the police command under the policy map configurationD、both Frame Relay traffic shaping （FRTS） and virtual IP （VIP）-based Distributed Traffic Shaping （DTS） have the ability to mark traffic
Which statement about the Link Control Protocol （LCP） is true？（）A、LCP is used for basic PPP link setup and operation.B、LCP is used for PPP CHAP authentication.C、LCP is used for PPP over ATM （PPPoA） setup.D、LCP is used for PPP over Ethernet （PPPoE） setup.E、LCP is used for PPP over Frame Relay （PPPoFR） setup
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? （）A、frame-relay arpB、frame-relay mapC、frame-relay interface-dlciD、frame-relay lmi-type
Which two of these are characteristics of the 802.1Q protocol?（）A、it is a layer 2 messaging protocol which maintains vlan configurations across network.B、it includes an 8-bit field which specifies the priority of a frame.C、it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.D、it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.E、it is a trunking protocol capable of carring untagged frames.
单选题Your network consists of a large hub - and - spoke Frame Relay network with a CIR of 56 kb/s foreach spoke. Which statement about the selection of a dynamic protocol is true?（）AEIGRP would be appropriate if LMI type ANS I is NOT used.BEIGRP would be appropriate, because the Frame Relay spokes could be segmented into their own areas.CEIGRP would be appropriate, because by default, queries are not propagated across the slow speed Frame Relay links.DEIGRP would be appropriate, because you can manage how much bandwidth is consumed over the Frame Relay interface.
单选题Which statement is true about the Cisco Self-Defending Network?（）AThe Cisco Self-Defending Network defines the physical position of the firewall to protect against internal and external attacksBThe Cisco Self-Defending Network Provides static filtering against known and unknown internal and external attacksCThe Cisco Self-defending Network Provides dynamic protection against known and unknown internal and external attacksDThe Cisco Self-defending Network Provides the Elements to install the antivirus software on the End-User Workstation
单选题Which statement about the Link Control Protocol （LCP） is true？（）ALCP is used for basic PPP link setup and operation.BLCP is used for PPP CHAP authentication.CLCP is used for PPP over ATM （PPPoA） setup.DLCP is used for PPP over Ethernet （PPPoE） setup.ELCP is used for PPP over Frame Relay （PPPoFR） setup
单选题Phase I and Phase II DMVPN differ in terms of which of these characteristics？（）AUtilization of spoke-to-spoke dynamic tunnelsBUtilization of multipoint GRE tunnels at the hub siteCUtilization of hub-to-spoke dynamic tunnelsDSupport for multicast
多选题Which two statements are correct about configuring AutoQoS on a Cisco router？ （）AAutoOoS can be implemented on only one side of a link.BThe interface does not have to have an IP address associated with it.CThe AutoOoS feature cannot be configured on a Frame Relay DLCI if a map class is attached to the DLCI.DIn a Frame Relay network， AutoOoS cannot be configured if a DLCI is already assigned to the Frame Relay subinterface
单选题In regard to a hub and spoke Frame-Relay data network, what kind of physical network is it classified as?（）Apoint-to-pointBbroadcast multi-accessCnonbroadcast multipointDnonbroadcast multi-accessEbroadcast point-to-multipoint
单选题A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）AFor the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.BFor the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.CDirect inter-vlan communication does not require OSPFDOSPF cannot be used if router-on-a-stick is configured on the router
单选题Which statement is true about the configuration of AutoQoS on a Frame Relay interface？（）AAutoQoS can be configured from a different subinterface if the DLCI is already assigned to one subinterface BMultilink PPP (MLP) over Frame Relay must be manually configured on low speed DLCIs Cfor low-speed Frame Relay DLCIs with Frame Relay-to ATM interworking, the AutoQoS cannot be configured if a virtual template is already configured for the DLCI DAutoQoS can be configured on a Frame Relay DLCI only if a map class is attached to the DLCI