IPv6 was developed by the （ ） to deal with the long-anticipated problem of IPv4 adderss exhaustion．A．ISO B．IEEE C．ITU D．IETF
IPv6 was developed by the （ ） to deal with the long-anticipated problem of IPv4 adderss exhaustion．
A．ISO B．IEEE C．ITU D．IETF
相关考题：
在IPv4和IPv6混合网络中，协议翻译技术用于 （66） 。A.两个IPv6通过IPv4网络通信B.两个IPv4通过IPv6网络通信C.纯IPv4主机和纯IPv6主机之间通信D.两个双协议栈主机之间的通信
Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?() A. An automatic 6to4 tunnel does not req uire dual - stack (IPv4 and IPv6) routers at the tunnel endpoints.B. An automatic 6to4 tunnel allows multiple IPv4 destinations.C. A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations.D. A manually configured IPv6 in IPv4 tunnel does not require dual- stack (IPv4 and IPv6) routers at the tunnel endpoints.
Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? () A. IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.B. IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.C. Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.D. Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.E. IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.
Which three approaches can be used while migrating from an IPV4 addressing scheme to an IPV6 scheme.() A. statically map IPV4 address to IPV6 addressesB. configuration IPv4 tunnels between IPV6 islandsC. use DHCPv6 to map IPV4 addresses to IPV6 addressesD. use proxying and translation to translate IPV6 packets into IPV4 packetsE. configure IPV6 directlyF. enable dual-stack routing
(36）以下关于IPv4和IPv6的说法，错误的是( ）。A） IPv4存在局限性，所以人们开发了IPv6B） IPv6依然沿用了IPv4的核心设计思想C） IPv6在协议格式、地址表示法方面和IPv4是相同的D） IPv6采用了128位地址长度
在IPV4和IPV6混合的网络中，协议翻译技术用于（ ）A.两个IPV6主机通过IPV4网络通信 B.两个IPV4主机通过IPV6网络通信 C.纯IPV4主机和纯IPV6主机之间的通信D.两个双协议栈之间的通信
从IPv4迁移到IPv6可以使用哪三种方法？（）A、静态映射IPv4地址IPv6地址B、IPV6之间配置IPv4隧道C、使用DHCPv6来映射IPv4地址IPv6地址D、使用代理和翻译翻译IPV6数据包到IPv4数据包E、直接配置IPV6F、启用双栈路由
Which two statements are true about using IPv4 and IPv6 simultaneously on a network segment? （）A、IPv6 allows a host to create its own IPv6 address that will allow it to communicate to other devices on a network configured via DHCP. IPv4 does not provide a similar capability for hosts.B、IPv6 provides for more host IP addresses but IPv4 provides for more network addresses.C、Hosts can be configured to receive both IPv4 and IPv6 addresses via DHCP.D、Host configuration options for IPv4 can be either statically assigned or assigned via DHCP.Host configuration options for IPv6 can be statically assigned only.E、IPv4 and IPv6 addresses c an be simultaneously assigned to a host but not to a router interface.
Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?（）A、An automatic 6to4 tunnel does not req uire dual - stack (IPv4 and IPv6) routers at the tunnel endpoints.B、An automatic 6to4 tunnel allows multiple IPv4 destinations.C、A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations.D、A manually configured IPv6 in IPv4 tunnel does not require dual- stack (IPv4 and IPv6) routers at the tunnel endpoints.
Which of the following solutions will encapsulate IPv6 packets with IPv4 headers？（）A、Create an IPv4 tunnel and assign the tunnel IPv6 addressesB、Create IPv4 interfaces on both ends of the network， and use either static routes or a routingprocess to direct IPv6 packets through those interfacesC、IPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatibleD、Create IFV6 interfaces on both ends of the network， and use static routes to point the IPv4address to those interfacesE、Use an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that processF、Create an IPv4 tunnel and use the tunnel mode ipv6ip command
Your company is researching a new application that runs over IPv6， but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network， but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation？ （）A、 Tunnel IPv6 over IPv4 to connect far-end IPv6 networksB、 Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possibleC、 Explain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possibleD、 What is the meaning of EUI-64 and how does it work？E、 Tunnel IPv4 over IPv6 to connect far-end IPv4 networks.
Company network is implemting IPv6 into their existing IPv4 netwrok. Which statement is trueabout incorporating IPv6 into an already existing IPv4 network？（）A、Only OSPF version 3 can be utilized for routing IPv4 and IPv6B、IPv4 and IPv6 networks can be routed simultaneouslyC、IPv6 can be routed using the same routing protocol versions as IPv4D、A router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route themE、None of the other alternatives apply
Which three approaches can be used while migrating from an IPV4 addressing scheme to an IPV6 scheme?（）A、statically map IPV4 address to IPV6 addressesB、configuration IPv4 tunnels between IPV6 islandsC、use DHCPv6 to map IPV4 addresses to IPV6 addressesD、use proxying and translation to translate IPV6 packets into IPV4 packetsE、configure IPV6 directlyF、enable dual-stack routing
IPV6与IPV4的首部比较，下列说法错误的是（）。A、IPV6与IPV4的版本相同B、IPV4的首部长度在IPV6中取消了C、IPV4的协议在IPV6中被取消D、IPV4中的源地址、目的地址在IPV6中由32位变成了64位111
多选题Your company is researching a new application that runs over IPv6， but part of it must still have IPv4 support. Your company uses a traditional IPv4 network. Your plan is not to run IPv6 over the whole network， but to segment parts of the network or even to operate simultaneously with IPv6 and IPv4. You must make a brief presentation about IPv6 technology to the board of technical directors. Which three of these items could be part of your presentation？ （）ATunnel IPv6 over IPv4 to connect far-end IPv6 networksBExplain why configuring IPv4 and IPv6 at the same time over the same LAN interface is not possibleCExplain why configuring IPv4 and IPv6 at the same time over the same LAN interface is possibleDWhat is the meaning of EUI-64 and how does it work？ETunnel IPv4 over IPv6 to connect far-end IPv4 networks.
单选题Company network is implemting IPv6 into their existing IPv4 netwrok. Which statement is trueabout incorporating IPv6 into an already existing IPv4 network？（）AOnly OSPF version 3 can be utilized for routing IPv4 and IPv6BIPv4 and IPv6 networks can be routed simultaneouslyCIPv6 can be routed using the same routing protocol versions as IPv4DA router routing for IPv6 and IPv4 must convert IPv4 packets to IPv6 packets to route themENone of the other alternatives apply
多选题Which three approaches can be used while migrating from an IPV4 addressing scheme to an IPV6 scheme？（）Astatically map IPV4 address to IPV6 addressesBconfiguration IPv4 tunnels between IPV6 islandsCuse DHCPv6 to map IPV4 addresses to IPV6 addressesDuse proxying and translation to translate IPV6 packets into IPV4 packetsEconfigure IPV6 directlyFenable dual-stack routing
多选题从IPv4迁移到IPv6可以使用哪三种方法？（）A静态映射IPv4地址IPv6地址BIPV6之间配置IPv4隧道C使用DHCPv6来映射IPv4地址IPv6地址D使用代理和翻译翻译IPV6数据包到IPv4数据包E直接配置IPV6F启用双栈路由
单选题Which of the following solutions will encapsulate IPv6 packets with IPv4 headers？（）ACreate an IPv4 tunnel and assign the tunnel IPv6 addressesBCreate IPv4 interfaces on both ends of the network， and use either static routes or a routingprocess to direct IPv6 packets through those interfacesCIPv6 packets cannot be encapsulated with IPv4 headers because the addresses are notcompatibleDCreate IFV6 interfaces on both ends of the network， and use static routes to point the IPv4address to those interfacesEUse an IPv6 routing protocol like OSPFv3 and assign IPv4 packets to that processFCreate an IPv4 tunnel and use the tunnel mode ipv6ip command