单选题Both bus and tree topologies are characterized by the use of multipoint (1).For the bus, all stations attach, through appropriate hardware (2) known as a tap, directly to a linear transmission medium, or bus. Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the(3). A transmission from any station propagates the length of the medium in both directions and can be received by all other (4). At each end of the bus is a (5) , which absorbs any signal, removing it from the bus.空白（4）处应选择（）AroutersBstationsCserversDswitches
单选题
Both bus and tree topologies are characterized by the use of multipoint (1).For the bus, all stations attach, through appropriate hardware (2) known as a tap, directly to a linear transmission medium, or bus. Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the(3). A transmission from any station propagates the length of the medium in both directions and can be received by all other (4). At each end of the bus is a (5) , which absorbs any signal, removing it from the bus.
空白（4）处应选择（）
A
routers
B
stations
C
servers
D
switches
参考解析
解析：
总线型和树形拓扑结构都使用多点传输介质。对于总线来说，所有站点都通过被称为接头的硬件直接连接到线性传输介质或总线上。站和接头之间的操作允许数据发送到总线上，也可以从总线上接收数据。任何站点发送的数据都向总线两端传播，并可以被所有其他站点接收到。在总线的两端各有一个终接器，它接收并从总线上移去所有信号。
相关考题：
“Sorry Sir, this bus is () downtown, you’ve taken the wrong bus.” A、make toB、aim toC、bound forD、direct to
● Both bus and tree topologies are characterized by the use of multipoint （71）. For the bus, all stations attach, through appropriate hardware（72）known as a tap, directly to a linear transmission medium, or bus. Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the （73）. A transmission from any station propagates the length of the medium in both directions and can be received by all other （74）.At each end of the bus is a （75) , which absorbs any signal, removing it from the bus.（71）A. mediumB. connectionC. tokenD. resource（72）A. processingB. switchingC. routingD. interfacing（73）A. treeB. busC. starD. ring（74）A. routersB. stationsC. serversD. switches（75）A. tapB. repeaterC. terminatorD. concentrator
Both bus and tree topologies are characterized by the use of multipoint().A.mediumB.connectionC.tokenD.resource
For the bus, all stations attach, through appropriate hardware()known as a tap, directly to a linear transmission medium, or bus.A.processingB.switchingC.routingD.interfacing
Which two statements describe the operation of the CSMA/CD access method, which is in use on the Ezonexam network? (Choose two)A. After a collision, the station that detected the collision has first priority to resend the lost data.B. In a CSMA/CD collision domain, stations must wait until the media is not in use before transmitting.C. In a CSMA/CD collision domain, multiple stations can successfully transmit data simultaneously.D. The use of hubs to enlarge the size of collision domains is one way to improve the operation of the CSMA/CD access method.E. After a collision, all stations run a random backoff algorithm. When the backoff delay period has expired, all stations have equal priority to transmit data.F. After a collision, all stations involved run an identical backoff algorithm and then synchronize with each other prior to transmitting data.
Both bus and tree topologies are characterized by the use of multipoint (71) ．For the bus，all stations attach，through appropriate hardware (72) known as a tap，directly to a linear transmission medium，or bus．Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the (73) ．A transmission from any station propagates the length of the medium in both directions and can be received by all other (74) ．At each end of the bus is a (75) ，which absorbs any signal，removing it from the bus．（71）A．mediumB．connectionC．tokenD．resource
In order to improve the performance of a network server, you need to select bus or local bus. The appropriate local bus is(69).A．VESAB．ISAC．EISAD．PCI
SCSI interfaces provide for faster data transmission rates (up to 80 megabytes per second) than standard serial and parallel ports. In addition, you can attach many devices to a single SCSI port, so that SCSI is really an I/O bus rather than simply an interface Which two statements about SCSI are true?（）A. The bus is limited to 64 devices.B. It is a full-duplex serial standard.C. It is a half-duplex serial standard.D. It allows up to 320 MB/s of shared channel bandwidth.
He got up so late that he missed the school bus．（改为同义句）He got up________ late________ ________the school bus．
CSMA, although more efficient than ALOHA or slotted ALOHA, still has one glaring inefficiency. If the medium is busy, the station will wait for a random amount of time. When two frames collide, the medium remains （ ） for the duration of transmission of both damaged frames. The use of random delays reduces the probability of（ ）. For（ ）frames, compared to propagation time, the amount of wasted capacity can be considerable. This waste can be reduced if a station continues to listen to the medium while（ ）.The maximum utilization depends on the length of the frame and on the（请作答此空） time; the longer the frames or the shorter the propagation time，the higher the utilization.A.propagationB.transmissionC.collidingD.listening
Both bus and tree topologies are characterized by the use of multipoint (1).For the bus, all stations attach, through appropriate hardware (2) known as a tap, directly to a linear transmission medium, or bus. Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the(3). A transmission from any station propagates the length of the medium in both directions and can be received by all other (4). At each end of the bus is a (5) , which absorbs any signal, removing it from the bus.空白（4）处应选择（）A、routersB、stationsC、serversD、switches
Both bus and tree topologies are characterized by the use of multipoint (1).For the bus, all stations attach, through appropriate hardware (2) known as a tap, directly to a linear transmission medium, or bus. Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the(3). A transmission from any station propagates the length of the medium in both directions and can be received by all other (4). At each end of the bus is a (5) , which absorbs any signal, removing it from the bus.空白（2）处应选择（）A、processingB、switchingC、routingD、interfacing
The customer brings their mini-tower and a new DVD/RW drive they want installed. The technician finds a second hard drive in an empty 5.25 bay connected to the secondary bus and jumpered as a slave. The ribbon cable will not stretch from the primary hard drive to the open 5.25 inch bay. Which of the following is the BEST solution?（）A、Connect the new DVD drive as the primary on the secondary bus and leave the old CD drive disconnected.B、Move the secondary hard drive next to the primary hard drive and connect to the primary bus. Connect the new DVD drive as the slave on the secondary bus.C、Move the secondary hard drive from the secondary to the primary bus and then reformat the hard drive after rebooting then reassign the drive letters in disk management prior to installing the new DVD drive on the secondary bus.D、Move the secondary hard drive to the bay and then connect it to the primary bus. Connect themini-tower and the new DVD drive as the master on the secondary bus.
Which of the following statements correctly describe the differences between half-duplex and full-duplex Ethernet?（）A、Full-duplex Ethernet uses CSMA/CD to prevent collisions.B、Half-duplex Ethernet uses a loopback circuit to detect collisions.C、A full-duplex Ethernet card allows 20Mbps for data transmission.D、Full-duplex Ethernet makes use of two pairs of wires for data.E、An Ethernet hub can operate both half and full duplex simultaneously.
What are the two parallel SCSI specifications？（）A、 Up to 25 m bus lengthB、 Only one device per SCSI busC、 Up to 16 devices per SCSI busD、 Half-duplex operationE、 Full-duplex operation
Both bus and tree topologies are characterized by the use of multipoint (1).For the bus, all stations attach, through appropriate hardware (2) known as a tap, directly to a linear transmission medium, or bus. Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the(3). A transmission from any station propagates the length of the medium in both directions and can be received by all other (4). At each end of the bus is a (5) , which absorbs any signal, removing it from the bus.空白（1）处应选择（）A、mediumB、connectionC、tokenD、resource
An on-premise application is exposed to external users through a Windows Communication Framework （WCF） service endpoint registered in the Windows Azure AppFabric Service Bus. You need to recommend an approach for providing transport-level security that maximizes performance and minimizes bandwidth requirements. What should you recommend？（）A、 Use reliable messaging. Use HTTP for message delivery.B、 Use binary message encoding. Use TCP for message delivery.C、 Use Plain Old XML （POX） messages. Use TCP for message delivery.D、 Use Message Transmission Optimization Mechanism （MTOM） message encoding. Use HTTPS formessage delivery
Which of the following hardware components is necessary for a server to access data directly on afiber channel based SAN？（）A、Gigabit NICB、RAID controller cardC、SATA controller cardD、Host bus adapter
单选题The customer brings their mini-tower and a new DVD/RW drive they want installed. The technician finds a second hard drive in an empty 5.25 bay connected to the secondary bus and jumpered as a slave. The ribbon cable will not stretch from the primary hard drive to the open 5.25 inch bay. Which of the following is the BEST solution?（）AConnect the new DVD drive as the primary on the secondary bus and leave the old CD drive disconnected.BMove the secondary hard drive next to the primary hard drive and connect to the primary bus. Connect the new DVD drive as the slave on the secondary bus.CMove the secondary hard drive from the secondary to the primary bus and then reformat the hard drive after rebooting then reassign the drive letters in disk management prior to installing the new DVD drive on the secondary bus.DMove the secondary hard drive to the bay and then connect it to the primary bus. Connect themini-tower and the new DVD drive as the master on the secondary bus.
多选题You are designing a service that will use the Windows Azure AppFabric Service Bus. You need to recommend an approach for controlling access to the service by using the Windows Azure AppFabric Access Control Service. Which two actions should you recommend？（）AConfigure the service to not require authentication.BConfigure the service to require a relay access token.CSpecify message security for all communications between clients and the service.DSpecify transport security for allcommunications between clients and the service.
多选题SCSI interfaces provide for faster data transmission rates (up to 80 megabytes per second) than standard serial and parallel ports. In addition, you can attach many devices to a single SCSI port, so that SCSI is really an I/O bus rather than simply an interface Which two statements about SCSI are true?（）AThe bus is limited to 64 devices.BIt is a full-duplex serial standard.CIt is a half-duplex serial standard.DIt allows up to 320 MB/s of shared channel bandwidth.
单选题Suppose half the people on a bus exit at each stop and no additional passengers board the bus. If on the third stop the next to last person exits the bus, then how many people were on the bus?A20B16C8D4
单选题Both bus and tree topologies are characterized by the use of multipoint (1).For the bus, all stations attach, through appropriate hardware (2) known as a tap, directly to a linear transmission medium, or bus. Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the(3). A transmission from any station propagates the length of the medium in both directions and can be received by all other (4). At each end of the bus is a (5) , which absorbs any signal, removing it from the bus.空白（2）处应选择（）AprocessingBswitchingCroutingDinterfacing
单选题Both bus and tree topologies are characterized by the use of multipoint (1).For the bus, all stations attach, through appropriate hardware (2) known as a tap, directly to a linear transmission medium, or bus. Full-duplex operation between the station and the tap allows data to be transmitted onto the bus and received from the(3). A transmission from any station propagates the length of the medium in both directions and can be received by all other (4). At each end of the bus is a (5) , which absorbs any signal, removing it from the bus.空白（1）处应选择（）AmediumBconnectionCtokenDresource
单选题An on-premise application is exposed to external users through a Windows Communication Framework （WCF） service endpoint registered in the Windows Azure AppFabric Service Bus. You need to recommend an approach for providing transport-level security that maximizes performance and minimizes bandwidth requirements. What should you recommend？（）A Use reliable messaging. Use HTTP for message delivery.B Use binary message encoding. Use TCP for message delivery.C Use Plain Old XML （POX） messages. Use TCP for message delivery.D Use Message Transmission Optimization Mechanism （MTOM） message encoding. Use HTTPS formessage delivery
单选题All Loran-C transmitting stations are equipped with cesium frequency standards which permit （）.Aevery station in one chain to transmit at the same timeBeach station to transmit without reference to another stationCon-line transmission of single-line transmitters at the same timeDeach station to only depend on the master for synchronization and signal ratio
单选题Which of the following hardware components is necessary for a server to access data directly on afiber channel based SAN？（）AGigabit NICBRAID controller cardCSATA controller cardDHost bus adapter