多选题Refer to the exhibit. Which two statements are correct？ （Choose two.）（）AAll six routes will be installed in the routing table.BTwo routes will be installed in the routing table.CFour routes will be installed in the routing table.DAll the routes were redistributed into BGP from an IGP.EAll the routes were originated by BGP with the network command.
多选题
Refer to the exhibit. Which two statements are correct？ （Choose two.）（）
A
All six routes will be installed in the routing table.
B
Two routes will be installed in the routing table.
C
Four routes will be installed in the routing table.
D
All the routes were redistributed into BGP from an IGP.
E
All the routes were originated by BGP with the network command.
参考解析
解析：
暂无解析
相关考题：
Which of the following statements about ORACLE is (are) correct?Ⅰ.ORACLE follows SQL standardⅡ.ORACLE database defines two logical types: table and viewA．ⅠonlyB．Ⅱ onlyC．Ⅰ and ⅡD．none of the above
Which three statements are correct about Rate Limiters? ()(Choose three.) A. one-rate rate limitersB. two-rate rate limitersC. two-rate rate limiters is the defaultD. one-rate rate limiters is the defaultE. there is no default it must be configured
Which two statements regarding JUNOS architecture are correct?() A.The Routing Engine handles all exception traffic.B.The Routing Engine synchronizes the route table with the PFEC.The Routing Engine is hot-pluggable.D.The Routing Engine controls the PFE
Refer to the exhibit. Which of the following statements is true? () A. BGP NSF awareness is enabledB. SSO for BGP NSF capability is enabledC. BGP graceful restart awareness is enabledD. 10.11.1.187 is configured as an NSF-capable BGP neighbor
Refer to the exhibit. On the basis of the partial configuration, which two statements are correct? () A. Only routes 10.0.1.0/24 will be sent out all interfaces.B. Only routes matching 10.0.0.0/8 will be advertised out interfaces other than Ethernet 0.C. Only routes matching 10.0.0.0/8 will be advertised out Ethernet 0.D. Only routes matching 10.0.1.0/24 will be advertised out Ethernet 0.E. Only routes 10.0.1.0/24 will be allowed in the routing table.F. All rout es will be advertised out interfaces other than Ethernet 0.
Refer to the exhibit. Which two Cisco IOS commands on R2 would verify its OSPF neighbor relationships?() A.show ip ospfB.show ip ospf interfaceC.show ip ospf neighborD.show ip ospf databaseE.show ip ospf statisticsF.show running - config begin router ospf
Refer to the exhibit. Two routers are connected by Frame Relay and are running OSPF bet ween them. Each router has been configured with the appropriate network statements under router ospf 1, but the routers are not forming an adjacency. Which of the following three commands could be configured on each router to correct this problem?（）A. RouterC(config - if)#ip ospf network broadcast RouterD(config - if)#ip ospf network broadcastB. RouterC(config - if)#ip ospf network point - to - point RouterD(config - if)#ip ospf network point - to - pointC. RouterC(config - router)#neighbor 10.100. 100.4 RouterD(config - router)#neighbor 10.100.100.3D. RouterC(config - router)#neighbor 10.255.255.254 RouterD(config - router)#neighbor 10.255.255.253
Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel was configured, but the tunnel is not coming up. W hat did the TAC engineer configure incorrectly?() A. The crypto isakmp configuration is not correct.B. The crypto map configuration is not correct.C. The interface tunnel configuration is not correct.D. The network configuration is not correct; netw ork 172.16.1.0 is missing.
Refer to the exhibit. Based upon the configuration, you need to understand why the policy routi match counts are not increasing. Which would be the first logical step to take?() A. Confirm if there are other problematic route - map statements that precede divert.B. Check the access list for log hits.C. Check the routing table for 212.50.185.126.D. Remove any two of the set clauses. (Multiple set clause entries will cause PBR to use the routing table.)
Refer to the exhibit. You want to use all the routes in the EIGRP topology for IP load balancing. Which two EIGRP subcommands wou ld you use to accomplish this goal?() A. traffic - share balancedB. distanceC. maximum- pathsD. default - networkE. variance
Refer to the exhibit. Which two statement s are correct?() A. All the routes were redistributed into BGP from an IGPB. All the routes were originated by BGP with the network commandC. All six routes will be installed in the routing tableD. Four routes will be installed in the routing ta bleE. Two routes will be installed in the routing table
Refer to the exhibit. Which two statements are true about the partial configuration that is provided.() A. The peer group shortens the EBGP configurationB. The peer group shortens the IBGP configurationC. All the configured neighbors are in autonomous system 100D. Three AS - path filters are applied to each BGP neighborE. Only the outgoing filters are applied to BGP updates
Refer to the exhibit. Which two statements about the topologies shown are correct?() A. Design 1 is a looped triangle design.B. Design 2 is a looped triangle design.C. Design 2 achieves quick convergence using RSTP.D. Both designs supportstateful services at the aggregation layer.E. Design 2 is the most widely deployed in enterprise data centers.
Refer to the exhibit. When deploying an MSFC and an FWSM, which statement is correct?() A. Proper placement depends on the VLAN assignment.B. Place it outside the firewall.C. Place it inside the firewall to make design and management easier.D. Place it inside the firewall with multiple context modes connecting to all configured contexts.
Refer to the exhibit. Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?() A.255.255.255.0B.255.255.254.0C.255.255.252.0D.255.255.248.0
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?() A.10.0.0.0B.10.0.0.254C.192.223.129.0D.192.223.129.254
Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）A、As numbers must be changed to match on all the routers.B、Loopback interface must be configured so a DR is elected.C、The no auto-summary command is needed on Router A and Router C.D、Router B needs to have two network statements, one for each connected network.
Refer to the exhibit. Which two statements are true about the partial configuration that is shown？（）A、Hosts connected to the FastEthernet0/1 interface will not receive DHCP replies from the routerB、The first DHCP client to connect to the FastEthernet 0/1 interface will receive the IP address10.10.0.1C、The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.1D、DHCP requests received on the FastEthernet 0/1 interface will be forwarded to 10.0.0.2E、The first DHCP client to connect to the FastEthernet 0/0 interface will receive the IP address10.0.0.6
Which of the following statements are true？（） A、 The equals（） method determines if reference values refer to the same object.B、 The == operator determines if the contents and type of two separate objects match.C、 The equals（） method returns true only when the contents of two objects match.D、 The class File overrides equals（） to return true if the contents and type of two separate objects match.
Which three statements are correct about Rate Limiters? （）(Choose three.)A、one-rate rate limitersB、two-rate rate limitersC、two-rate rate limiters is the defaultD、one-rate rate limiters is the defaultE、there is no default it must be configured
Which two statements regarding JUNOS architecture are correct？（）A、The Routing Engine handles all exception traffic.B、The Routing Engine synchronizes the route table with the PFEC、The Routing Engine is hot-pluggable.D、The Routing Engine controls the PFE
Which two statements are true about standard database auditing（）A、DDL statements can be audited.B、Statements that refer to stand-alone procedure can be audited.C、Operations by the users logged on as SYSDBA cannot be audited.D、Only one audit record is ever created for a session per audited statement even though it is executedmore than once.
多选题Which two statements are true about standard database auditing（）ADDL statements can be audited.BStatements that refer to stand-alone procedure can be audited.COperations by the users logged on as SYSDBA cannot be audited.DOnly one audit record is ever created for a session per audited statement even though it is executedmore than once.
单选题Refer to the exhibit. When running EIGRP, What is required for RouterA to exchange routing updates with RouterC?（）AAs numbers must be changed to match on all the routers.BLoopback interface must be configured so a DR is elected.CThe no auto-summary command is needed on Router A and Router C.DRouter B needs to have two network statements, one for each connected network.
多选题Refer to the exhibit. Which two statements are correct？（）AAll six routes will be installed in the routing tableBTwo routes will be installed in the routing tableCFour routes will be installed in the routing tableDAll the routes were redistributed into BGP from an IGPEAll the routes were originated by BGP with the network command
多选题Which two statements are correct regarding MPLS LSP establishment methods?（） (Choose two.)ALDP uses Down Stream On Demand.BRSVP uses Down Stream On Demand.CLDP uses Down Stream Unsolicited.DRSVP uses Down Stream Unsolicited.
多选题Which of the following statements are true？（）AThe equals（） method determines if reference values refer to the same object.BThe == operator determines if the contents and type of two separate objects match.CThe equals（） method returns true only when the contents of two objects match.DThe class File overrides equals（） to return true if the contents and type of two separate objects match.