Which routing instance type is used to facilitate filter-based forwarding?（）A、VRFB、FBFC、forwardingD、no-forwarding
Which routing instance type is used to facilitate filter-based forwarding?（）
- A、VRF
- B、FBF
- C、forwarding
- D、no-forwarding
相关考题：
Referring to the exhibit, which type of classifier is being used in this CoS configuration?() A. behavior aggregateB. policerC. multifieldD. forwarding policy
What is the default Quality of Service traffic class used by the ERX Edge Router?() A. bronze forwardingB. assured forwardingC. expedited forwardingD. best effort forwarding
In JUNOS software, unclassified packets are associated with which forwarding class?() A. network controlB. best effortC. assured forwardingD. expedited forwarding
Which routing instance type is used to facilitate filter－based forwarding?() A. VRFB. FBFC. forwardingD. no-forwarding
Which three are used to create a separate multicast and unicast forwarding topology on a Juniper Networks router?() A. MBGPB. RIB groupsC. firewall filtersD. routing policyE. filter based forwarding (FBF)
Which statement is true about the internal link between the Routing Engine and the Packet－Forwarding Engine?() A.It is only used for exception traffic.B.It is an FE link called fxp2.C.It is rate-limited to avoid DDOS attacks.D.It is only used to send the forwarding-table from the Routing Engine to the Packet-Forwarding Engine.
Which routing method is used to determine the forwarding paths for IP traffic in a Secure Cisco Single-Site Network foundation solution with remote teleworkers？（）A、RIPB、EIGRPC、OSPFD、Static and default routes
Which of the following troubleshooting targets is considered to be a Layer 2 issue？（Choose allthat apply.）（）A、Spanning Tree ProtocolB、CablingC、Frame forwardingD、Packet forwardingE、EtherChannelF、Routing protocols
What is the default Quality of Service traffic class used by the ERX Edge Router?（）A、bronze forwardingB、assured forwardingC、expedited forwardingD、best effort forwarding
Which statement is correct about policies in the Junos OS?（）A、Import policies are used to filter routes from the routing table to the forwarding table.B、Import policies are used to filter routes destined for the routing table.C、Import policies are used to filter routes being sent to neighboring devices.D、Import policies are used to filter traffic entering the device.
Which three port states are used by RSTP 802.1w？（）A、ListeningB、LearningC、ForwardingD、BlockingE、DiscardingF、Disabled
The OSPF RFC 3623 Graceful Restart feature allows you to configure IETF NSF in ultivendor networks. When using OSPF Graceful Restart，which mechanism is used tocontinue forwarding packets during a switchover？（）A、Reverse Path ForwardingB、Hardware-based forwardingC、UDP forwardingD、Layer 2 Forwarding
Under which two circumstances would an RSTP bridge flush its CAM table？（）A、upon a port state changeB、upon receiving a topology change notificationC、when transitioning from discarding to forwardingD、when transitioning from forwarding to discardingE、only when changing from listening to discardingF、when CAM resources have been completely used up
Which IOS features are used to avoid Routing loops when dynamic Routing protocols are used betweenPE and CE in MPLS-VPN networks？（）A、Site Of Origin SOO.B、SHAM links with OSPFC、BGP cost communityD、BGP feature allow-as inE、RPF Reverse Path forwarding.F、Access-list Control in Distance Vector protocol like RIP and EIGRP.
When importing or exporting routing information using routing policy, the import or export is always done from which point of view?（）A、routing tableB、forwarding tableC、routing protocolD、neighbor or peer
Which three are used to create a separate multicast and unicast forwarding topology on a Juniper Networks router?（）A、MBGPB、RIB groupsC、firewall filtersD、routing policyE、filter based forwarding (FBF)
In JUNOS software, unclassified packets are associated with which forwarding class?（）A、network controlB、best effortC、assured forwardingD、expedited forwarding
What is the role of route preference?（）A、It is used to determine which route should become active.B、It is used to select which routing table to use for forwarding.C、It is used to determine what routes to accept into the routing table.D、It is used to select the best route between multiple equal cost paths.
What is the role of route preference?（）A、It is used as a tie breaker when the same prefix is available through multiple sourcesB、It is used to determine which routes to accept into the routing tableC、It is used to select the best route between multiple equal-cost pathsD、It is used to select which routing table to use for forwarding
What is the role of route preference?（）A、It is used as a tiebreaker when the same prefix is available through multiple protocols.B、It is used to determine the preferred path to a given destination.C、It is used to select the best route between multiple equal-cost paths.D、It is used to select which routing table to use for forwarding.
Which statement is correct about policies in the Junos OS?（）A、Export policies are used to filter routes from the RE forwarding table to the PFE forwarding table.B、Export policies are used to filter routes destined for the routing table.C、Export policies are used to filter routes being sent to neighboring devices.D、Export policies are used to filter traffic leaving the device.
单选题What is the role of route preference?（）AIt is used to determine which route should become active.BIt is used to select which routing table to use for forwarding.CIt is used to determine what routes to accept into the routing table.DIt is used to select the best route between multiple equal cost paths.
单选题Which statement is true about the internal link between the Routing Engine and the Packet-Forwarding Engine?（）AIt is only used for exception traffic.BIt is an FE link called fxp2.CIt is rate-limited to avoid DDOS attacks.DIt is only used to send the forwarding-table from the Routing Engine to the Packet-Forwarding Engine.
单选题What is the role of route preference?（）AIt is used as a tie breaker when the same prefix is available through multiple sourcesBIt is used to determine which routes to accept into the routing tableCIt is used to select the best route between multiple equal-cost pathsDIt is used to select which routing table to use for forwarding
多选题Which IOS features are used to avoid Routing loops when dynamic Routing protocols are used betweenPE and CE in MPLS-VPN networks？（）ASite Of Origin SOO.BSHAM links with OSPFCBGP cost communityDBGP feature allow-as inERPF Reverse Path forwarding.FAccess-list Control in Distance Vector protocol like RIP and EIGRP.
单选题What is the role of route preference?（）AIt is used as a tiebreaker when the same prefix is available through multiple protocols.BIt is used to determine the preferred path to a given destination.CIt is used to select the best route between multiple equal-cost paths.DIt is used to select which routing table to use for forwarding.
单选题Which routing instance type is used to facilitate filter-based forwarding?（）AVRFBFBFCforwardingDno-forwarding