During consultation， you find that a customer has only a single asset closet and is looking for asolution that is easy to deploy. Which NAS physical deployment model would you suggest to this customer？（）A、 edgeB、 centralC、 Layer 2D、 Layer 3
During consultation， you find that a customer has only a single asset closet and is looking for asolution that is easy to deploy. Which NAS physical deployment model would you suggest to this customer？（）
- A、 edge
- B、 central
- C、 Layer 2
- D、 Layer 3
相关考题：
In which of these phases is a customers current network infrastructure assessed？（）A、planB、designC、implementD、prepare
For SONET ring switching， the 50ms switch time： Select all that apply？（）A、Plncludes the detection timeB、Applies to rings smaller than 1200kmC、Applies to rings smaller than 1000kmD、Includes up to 16 nodes
Which cisco product family is the recommended platform for 10 gigabit ethernet in the datacenter?（）A、CatalystB、ISRC、vCenterD、NexusE、ASR
What are the possible trunking modes for a switch port?（）A、transparentB、autoC、onD、desirableE、clientF、forwarding
What is the WMM user priority of the packets going downstream to the client when the client does not support TSPEC but the Cisco WLC has ACM enabled and WLAN priority is set to Platinum?（）A、backgroundB、best effortC、voiceD、video
How many VLANs on the UCS must be configured when using FCoE?（）A、One per bladeB、One per VSANC、One per fabricD、None are required
Which of the following be stdescribes the following command：ipflow-export destination 192.168.1.501500（）A、it is not a valid NetFlow command.B、it is an SNMP command tha texports1500-byte packets to IPaddress192.168.1.50.C、it is a NetFlov/command that v/ill export 1500-byte packets to IP address192.168.1.50.D、it is a NetFlov/command that allows IP address192.168.1.50 to send traffic to port 1500.E、It is a NetFlov/command that v/ill specify that the NetFlov/collector’s IP address is 192.168.1.50 over UDP port 1500
Which statement is true about the command ipv6 ospf 1 area 0?（）A、It must be issued before the network command to enable the OSPF pr ocess for IPv6.B、It must be issued after the network command to enable the OSPF process for IPv6.C、It must be issued in router global configuration mode to enable the OSPF process for IPv6.D、It must be issued in interface configuration mode to ena ble the OSPF process for IPv6.
An 802.1Q trunk is not coming up between two switches. The ports on both switches are configured as "switchport mode desirable." Assuming that there is no physical issue， choose two possible causes.（）A、Incorrect VTP domainB、Incorrect VTP passwordC、Incorrect VTP modeD、Incorrect VTP configuration revision
You are designing your network to be able to use trunks. As part of this process you are comparing the ISL and 802.1Q encapsulation options. All of these statements about the two encapsulation options are correct except which one？ （）A、 Both support normal and extended VLAN ranges.B、 ISL is a Cisco proprietary encapsulation method and 802.1Q is an IEEE standard.C、 ISL encapsulates the original frame.D、 Both support native VLANs.E、 802.1Q does not encapsulate the original frame.