Which two parameters are virtual router specific?() A.ATM PVCB.static routesC.IP interfacesD.encapsulations
Which two parameters are virtual router specific?()
A.ATM PVC
B.static routes
C.IP interfaces
D.encapsulations
相关考题：
i need a _______________ milk for this recipe. A. two-litre carton ofB. two litres carton ofC. two-litres-carton ofD. two-litre carton
The professor asked us to write a _____________ report.A、two-hundreds-wordsB、two-hundreds-wordC、two-hundred-wordsD、two-hundred-word
假设在LAC路由器上运行show vpdn命令，路由器软件系统输出的配置信息如图8-18所示。结合图 8-16所示的网络拓扑结构，请将(5)～(9)空缺处填写完整，完成在LAC上对L2TPv2协议的相关配置。Router_LAC(config) vpdn enableRouter_LAC(config) (5) (创建相应vPdn组，并进入该组的配置模式)(6) (接受对端发起L2TP通道连接请求，并根据virtual-template 1创建virtual-access接口)Router_LAC(config-vpdn1) (7) (启用L2TP通道验证功能)Router_LAC(config-vpdn1) 12tp tunnel password !abcd1234!(8)Router_LAC (config) (9) (创建并进入相应的L2TP虚接口模板)(其他配置略)
假设在LAC路由器上运行show vpdn命令，路由器软件系统输出的配置信息如图5-17所示。结合图 5-15所示的网络拓扑结构，请将(5)～(9)空缺处填写完整，完成在LAC上对L2TPv2协议的相关配置。Router_LAC(config)vpdn enableRouter_LAC(config) (5) (创建相应vpdn组，并进入该组的配置模式)(6) (接受对端发起L2TP通道连接请求，并根据virtual—template 1创建virtual-access接口)Router_LAC(config-vpdnl) (7) (启用L2TP通道验证功能)Router_LAC(config-vpdnl)12tp tunnel password! abcd1234!(8)Router_LAC(config) (9) (创建并进入相应的L2TP虚接口模板)(其他配置略)
Which three statements are correct regarding the CLI command, 12tp destination profile to－NewYork virtual－router vr1 ip address 1.1.1.1 ? ()(Choose three.) A. LNS IP address is defined.B. LAC IP address is defined.C. Virtual-router vr1 sends and receives L2TP traffic.D. Virtual-router vr1 is the authenticating virtual-router.E. This command is performed on the LNS.
The output of the show aaa domain-map displays the following information:Domain: isp1.com; virtual-router: vr1; loopback: 1Domain: isp2.com; virtual-router: vr2; loopback: 1Domain: none; virtual-router: vr3; loopback: 1Domain: default; virtual-router: vr4; loopback: 1The end user supplies a login name of joe@isp7.com .Which virtual router is responsible for authenticating this user?（）A. vr1B. vr2C. vr3D. vr4
Which configuration command creates a virtual router called isp－1?() A.virtual-routerisp-1B.virtual-routerISP-1C.virtual-routerVRisp-1D.virtual-routerVRISP-1
Refer to the exhibit. During the process of configuring a virtual link to connect area 2 with the backbone area, the network administrator received this console message on R3:*Mar 1 00:2 5:01.084: %OSPF -4- ERRRCV: Received invalid packet: mismatch area ID, from backbone area must be virtual link but not found from 20.20.20.1, Serial 0 .How should the virtual link be configured on the OSPF routers to establish full connectivity between the areas?（）A.R1(config - router)# area 0 virtual - link 1.1.1.1R3(config - router)# area 2 virtual - link 3.3.3.3B.R1(config - router)# area 1 virtual - link 2.2.2.2 R3(config - router)# area 1 virtual - link 2.2.2.2C.R1(config - router)# area 1 virtual - link 20.20 .20.2 R3(config - router)# area 1 virtual - link 30.30.30.2D.R1(config - router)# area 1 virtual - link 30.30.30.3 R3(config - router)# area 1 virtual - link 20.20.20.1E.R1(config - router)# area 1 virtual - link 3.3.3.3 R3(config - router)# area 1 virtual - link 1.1 .1.1
About ________ of the workers in the factory were born in the ________.A.two-thirds, 1970 B.two-thirds, 1970s C.two-third,1970 D.two-third, 1970s