1 Abis nibble=1 16kbit/s channel。针对EDGE业务,4个Abis nibble可支持的编码方式为()。A、CS1-CS2 and MCS1-MCS2B、CS1-CS4 and MCS1-MCS5C、CS1-CS4 and MCS1-MCS6D、CS1-CS4 and MCS1-MCS8E、CS1-CS4 and MCS1-MCS9

1 Abis nibble=1 16kbit/s channel。针对EDGE业务,4个Abis nibble可支持的编码方式为()。

  • A、CS1-CS2 and MCS1-MCS2
  • B、CS1-CS4 and MCS1-MCS5
  • C、CS1-CS4 and MCS1-MCS6
  • D、CS1-CS4 and MCS1-MCS8
  • E、CS1-CS4 and MCS1-MCS9

相关考题:

基本接口2B+D中,B和D的速率分别为()。 A、2048Kbit/s,256Kbit/sB、32Kbit/s,16Kbit/sC、64Kbit/s,16Kbit/sD、64Kbit/s,64Kbit/s

要启用LACP并将交换机端口加入端口信道1,可使用下面哪两个命令之一?() A.Switch(config)#interface port-channel1B.Switch(config)#channel-group 1 mode activeC.Switch#interface port-channel 1D.Switch(config-if)#channel-group 1 mode active

WhichportchannelcommandisrecommendedforN1KVonCiscoUCS?() A.channel-groupautomodeonB.channel-groupautomodeactiveC.channel-groupautomodeonsub-groupcdpD.channel-groupautomodeonsub-groupmanualE.channel-groupautomodeonmac-pinning

在BSC中,哪一块模块控制将SGSN发来的分组数据适配到Abis接口16kbit/s子时隙上?()A、MPCCB、TDPCC、PPCUD、SN1

在30B+D中,D通路的传输速率为16Kbit/s。

一路2B+D接口包含2路B通道和1路D通道,B通道用来传用户业务信号,速率为(),D通道用来传用户线路信令,速率为16Kbit/s。

Under U.S. regulatory domain, which channel plan delivers the proper coverage in a large lecturehall that requires four access points?()A、1, 4, 7, 11B、1, 4, 8. 11C、1, 6, 11, 1D、2, 4, 6, 8

A Channel ID mismatch occurs when ().A、fibers are terminated incorrectly on a nodeB、the channel number in the received K1 byte is not identical to the channel number transmitted in the K2 byteC、the channel number in the received C1 byte is not identical to the channel number transmitted in the C2 byteD、the channel number in the received C2 byte is not identical to the channel number transmitted in the C1 byteE、the channel number in the received K2 byte is not identical to the channel number transmitted in the K1 byte

在2B+D中,B的速率是()Kbit/s,D的速率是16Kbit/s。

TRAU主要负责将13Kbit/s话音(或数据)通过插入附加同步数据,使其速率变为16Kbit/s。

基本速率接口提供了()路64kbit/s的B信道和一路16kbit/s的D信道。A、1B、2C、4D、8

Gb接口是开放性的,Abis接口是私用的,它采用PCU帧(现有TRAU帧的扩展)来传递数据。PCU帧统一长度为()比特,每()ms传递一次通过Abis接口(16kbit/s)。A、160、10B、320、20C、640、30D、1280、40

对于SUM板,黄色的Abis1灯表示Abis1传输状态,熄灭表示()A、Abis1连接正常B、Abis1连接异常或者有误码C、Abis1没有配置或者没有启用D、无故障

对于SUM板,黄色的Abis1灯表示Abis1传输状态,常亮表示(),闪烁表示()或者有误码,熄灭表示Abis1没有配置或者没有启用。

GSM无线接口中,语音传输速率、编码速率、信道总速率分别是()。A、13Kbit/s,16Kbit/s,22.8kbit/sB、16kbit/s,22.8kbit/s,30kbit/sC、13kbit/s,22.8kbit/s,270kbit/sD、13kbits,16kbit/s,270kbit/s

登录7302 cli,以下是命令show xdsl operational-data near-end channel 1/1/4/3执行后的结果信息。 ============================================================ channel table ============================================================ if-index actual-bitrate-up attain-bitrate-up interleave-delay-down imp-noise-prot-down ------------------------------------------------------------------------------------------------------------------------------------ 1/1/4/3 128 704 8 11 ------------------------------------------------------------------------------------------------------------------------------------ channel count : 1 ============================================================ 根据以上信息判断,端口1/1/4/3上下行最大可达速率为()kbit/s。A、128B、704C、8D、无法确定

G-Abis接口提供()带宽传输CS-1/CS-2/CS-3/CS-4编码方式的分组数据。A、16kbit/sB、64kbit/sC、32kbit/sD、13kbit/s

Abis接口上的信令流,经过Abis接口E1/STM-1接口模块交换到Ater接口或者Pb接口。

下面关于分组业务信号流上行方向过程错误的是()A、GSM分组业务域数据由ABIS接口进入GMPS/GEPS框的GEIUB单板,根据CS1-4MSC1-9编码方案不同,占用ABIS接口1-4个16Kbit/s时隙B、每个16Kbit/s子时隙,在GEIUB解复用为64Kbit/s时隙,经过GTNU板交换到GEIUT板C、在GEIUT板复用为64Kbit/s子时隙,通过PB接口到达PCU,在经GB接口到达到达SGSN

A customer is deploying a new database on a PS701 Blade in a BladeCenter H, and requires redundant network and SAN adapters. Which configuration supports the customer requirement?()A、Configure 2CFFh combination fibre channel / gigabit Ethernet adaptersB、Configure 1CFFh 2-port fibre channel adapter and 1 CIOv 2-port gigabit Ethernet adapterC、Configure 1CIOv 2-port fibre channel adapter and 1 CFFh combination fibre channel / gigabit Ethernet adapterD、Configure 1CIOv 2-port gigabit Ethernet adapter and 1 CFFh combination fibre channel / gigabit Ethernet adapter

A customer is deploying a new database on a PS701 Blade in a BladeCenter H, and requires redundant network and SAN adapters. Which configuration supports the customer requirement?()A、Configure 2 CFFh combination fibre channel / gigabit Ethernet adaptersB、Configure 1 CFFh 2-port fibre channel adapter and 1 CIOv 2-port gigabit Ethernet adapterC、Configure 1 CIOv 2-port fibre channel adapter and 1 CFFh combination fibre channel / gigabit Ethernet adapterD、Configure 1 CIOv 2-port gigabit Ethernet adapter and 1 CFFh combination fibre channel / gigabit Ethernet adapter

PCM数字通信系统的速率范围通常在()A、4.8kbit/s以下B、4.8kbit/--16kbit/sC、16kbit/s--64kbit/sD、64kbit/s以上

单选题A Channel ID mismatch occurs when ().Afibers are terminated incorrectly on a nodeBthe channel number in the received K1 byte is not identical to the channel number transmitted in the K2 byteCthe channel number in the received C1 byte is not identical to the channel number transmitted in the C2 byteDthe channel number in the received C2 byte is not identical to the channel number transmitted in the C1 byteEthe channel number in the received K2 byte is not identical to the channel number transmitted in the K1 byte

单选题基本接口2B+D中,B和D的速率分别为()。A2048Kbit/s,256Kbit/sB32Kbit/s,16Kbit/sC64Kbit/s,16Kbit/sD64Kbit/s,64Kbit/s

填空题在2B+D中,B的速率是()Kbit/s,D的速率是16Kbit/s。

填空题一路2B+D接口包含2路B通道和1路D通道,B通道用来传用户业务信号,速率为(),D通道用来传用户线路信令,速率为16Kbit/s。

单选题Under U.S. regulatory domain, which channel plan delivers the proper coverage in a large lecturehall that requires four access points?()A1, 4, 7, 11B1, 4, 8. 11C1, 6, 11, 1D2, 4, 6, 8