单选题A new floor has been added to the enterprise campus network， providing client access for desktop PCs， laptops， and IP phones for employees and guests. During verification， a few desktop PCs have limited corporate access but not Internet access. Most other desktop PCs， all laptops， and IP phones are working correctly. Additional information indicates that the desktop PCs are obtaining IP host addresses from the DHCP server， which is intended for only the IP phones. Where should troubleshooting about this connectivity issue be focused？（）ADNSBfirst-hop redundancy protocolCDHCP server and optionsDVLAN mappingEclient network configurationFrouting protocols
单选题
A new floor has been added to the enterprise campus network， providing client access for desktop PCs， laptops， and IP phones for employees and guests. During verification， a few desktop PCs have limited corporate access but not Internet access. Most other desktop PCs， all laptops， and IP phones are working correctly. Additional information indicates that the desktop PCs are obtaining IP host addresses from the DHCP server， which is intended for only the IP phones. Where should troubleshooting about this connectivity issue be focused？（）
A
DNS
B
first-hop redundancy protocol
C
DHCP server and options
D
VLAN mapping
E
client network configuration
F
routing protocols
参考解析
解析：
暂无解析
相关考题：
You are an administrator of a large campus network. Every switch on a floor within each building of your campus has been configured for a different VLAN. During implementation of the Junos Pulse Access Control Service, you must configure a RADIUS return attribute policy to apply a role representing a group of authenticated users that frequently transport their laptops from building to building and floor to floor.In the admin GUI, which policy element would you enable to accommodate these users?（）A. Add Session-Timeout attribute with value equal to the session lifetimeB. Add Termination-Action attribute with value equal 1C. VLAND. Open port
A new subnet with 12 hosts has been added to the network. Which subnet address should this network use to provide enough useable addresses while wasting the fewest addresses()。 A.192.168.10.80/28B.192.168.10.80/29C.192.168.10.96/28D.192.168.10.96/29
A customer wants to TFTP a new image from the corporate network to Flash on the Teleworker router through the IPSec tunnel. How should you configure the Teleworker router?（）A、No additional steps are required. B、Add the appropriate source-interface command. C、The router cannot access a server in the Enterprise Campus network. D、The Teleworker Router does not have any client applications; therefore this type of request is not possible.
A switch that is to be added to the production network has been preconfigured （trunks， VLANs， VTP， and STP） and was tested in your lab. After installing the switch into the network， the entire network went down. What might explain what happened？ （）A、The new switch happened to be running Cisco Catalyst operating system， while the other network switches were running Cisco IOS Software.B、The configuration revision of the new switch was higher than the configuration revision of the production VTP domain.C、The link costs on the new switch are set to a high value， causing all ports on the new switch to go into a forwarding mode and none into blocking mode， thereby causing a spanning-tree loop.D、The ports connecting to the two switches have been configured incorrectly. One side has the command switchport mode access and the other switchport mode trunk.
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router
Company.com has a cluster with nodes that support "hot swap" adapters. During an upgrade of The network infrastructure，an additional network adapter has been added to the nodes and configured in AIX. What is the next step required to add this adapter to HACMP？（） A、 Stop the node.B、 Stop the cluster.C、 Run autodiscovery.D、 Configure the IP adapter.
An administrator has added a new device to a system and wants to determine if it has been correctly added to the ODM database. Which command would the system administrator use？（）A、odmgetB、odmaddC、odmshowD、odmcreate
Which of the following should be performed after a maintenance kit has been applied and fullfunctionality tested?（）A、Roller regenerator appliedB、Page count resetC、New network settings appliedD、Printer drum replacement
The technician has suspicions that a browser has been hijacked. Which of the following should the technician look for in this situation?（）A、A new default gateway has been setup.B、A new Internet shortcut has been added.C、A new web browser has been installed and is now the default.D、A proxy server has been enabled.
A new floor has been added to the enterprise campus network， providing client access for desktop PCs， laptops， and IP phones for employees and guests. During verification， a few desktop PCs have limited corporate access but not Internet access. Most other desktop PCs， all laptops， and IP phones are working correctly. Additional information indicates that the desktop PCs are obtaining IP host addresses from the DHCP server， which is intended for only the IP phones. Where should troubleshooting about this connectivity issue be focused？（）A、DNSB、first-hop redundancy protocolC、DHCP server and optionsD、VLAN mappingE、client network configurationF、routing protocols
Which typical enterprise campus requirement ensures that the network supports the required applications and that data flows within the required time frames？（）A、 availabilityB、 performanceC、 functionalityD、 manageability
The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch.What must be done to ensure that this new switch becomes the root bridge on the network?（）A、One router is running RIPv1.B、RIP neighbor is 224.0.0.9.C、The network contains a loop.D、Network 10.10.1.0 is reachable.
A new subnet with 12 hosts has been added to the network. Which subnet address should this network use to provide enough useable addresses while wasting the fewest addresses（）。A、192.168.10.80/28B、192.168.10.80/29C、192.168.10.96/28D、192.168.10.96/29
Router R1 exists in an Enterprise that uses EIGRP as its routing protocol. The show ip route command output on router R1 lists the following phrase: "Gateway of last resort is 1.1.1.1 to network 2.0.0.0". Whic h of the following is most likely to have caused this output to occur on R1?（）A、R1 has been configured with an ip default- network 2.0.0.0 command.B、R1 has been configured with an ip route 0.0.0.0 0.0.0.0 1.1.1.1 command.C、R1 has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.D、Another router has been configured with an ip default - network 2.0.0.0 command.E、Another router has been configured with an ip route 2.0.0.0 255.0.0.0 1.1.1.1 command.
A new array of hard drives has been added to an existing server； however， when the server is booted into the Windows OS the new drives fail to appear in My Computer. From which of the following locations can the new storage drives be added？（）A、 Format commandB、 HypervisorC、 Computer ManagementD、 Disk ManagementE、 Virtual Center
A new system has been installed and the network connection is very slow. The network administrators are sure that the network port is set to 100 full duplex. What command will display the configured and current speed settings of the adapter?（）A、lsdevB、lsattrC、entstatD、ifconfig
A new application has been added to a system which needs to automatically be started at system startup. The system administrator has decided to accomplish this by using the /etc/inittab file. Which command would be used to accomplish this in a supported manner？（）A、viB、mkitabC、telinitD、startsrc
单选题One of the workers has hung the curtains that had been laying on the floor.AhasBhungChadDlaying
单选题The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch.What must be done to ensure that this new switch becomes the root bridge on the network?（）AOne router is running RIPv1.BRIP neighbor is 224.0.0.9.CThe network contains a loop.DNetwork 10.10.1.0 is reachable.
单选题A switch that is to be added to the production network has been preconfigured （trunks， VLANs， VTP， and STP） and was tested in your lab. After installing the switch into the network， the entire network went down. What might explain what happened？ （）AThe new switch happened to be running Cisco Catalyst operating system， while the other network switches were running Cisco IOS Software.BThe configuration revision of the new switch was higher than the configuration revision of the production VTP domain.CThe link costs on the new switch are set to a high value， causing all ports on the new switch to go into a forwarding mode and none into blocking mode， thereby causing a spanning-tree loop.DThe ports connecting to the two switches have been configured incorrectly. One side has the command switchport mode access and the other switchport mode trunk.
单选题A new building has been added to the enterprise campus network， providing client access for desktop PCs， laptops， and IP phones for employees and guests. During verification， only a few laptops using wireless are reported to have problems， while other desktops， IP phones， and most other wireless laptops are fully operational. Additional information received about the problem indicates that， while the problematic wireless laptops cannot reach internal corporate websites， they can reach the Internet. Where should troubleshooting about this connectivity issue be focused？（）Aclient network configurationBVLAN mappingCrouting protocolsDfirst-hop redundancy protocol
单选题Company.com has a cluster with nodes that support "hot swap" adapters. During an upgrade of The network infrastructure，an additional network adapter has been added to the nodes and configured in AIX. What is the next step required to add this adapter to HACMP？（）A Stop the node.B Stop the cluster.C Run autodiscovery.D Configure the IP adapter.
单选题Which of these phases involves ensuring that a new solution has been integrated without disrupting the existing network？ Select exactly 1 answer（s） from the following：（）。AplanBprepareCoperateDimplement
单选题A new subnet with 12 hosts has been added to the network. Which subnet address should this network use to provide enough useable addresses while wasting the fewest addresses（）。A192.168.10.80/28B192.168.10.80/29C192.168.10.96/28D192.168.10.96/29
多选题A new array of hard drives has been added to an existing server; however, when the server is booted into the Windows OS the new drives fail to appear in My Computer. From which of the following locations can the new storage drives be added?（）AFormat commandBHypervisorCComputer ManagementDDisk ManagementEVirtual Center
单选题The technician has suspicions that a browser has been hijacked. Which of the following should the technician look for in this situation?（）AA new default gateway has been setup.BA new Internet shortcut has been added.CA new web browser has been installed and is now the default.DA proxy server has been enabled.
单选题A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）AFor the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.BFor the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.CDirect inter-vlan communication does not require OSPFDOSPF cannot be used if router-on-a-stick is configured on the router
单选题You are an administrator of a large campus network. Every switch on a floor within each building of your campus has been configured for a different VLAN. During implementation of the Junos Pulse Access Control Service, you must configure a RADIUS return attribute policy to apply a role representing a group of authenticated users that frequently transport their laptops from building to building and floor to floor. In the admin GUI, which policy element would you enable to accommodate these users?（）AAdd Session-Timeout attribute with value equal to the session lifetimeBAdd Termination-Action attribute with value equal 1CVLANDOpen port