单选题The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration？（）Aermit all packets matching the first three octets of the source address to all destinationsBpermit all packet matching the last octet of the destination address and accept all source addressesCpermit all packet matching the host bits in the source address to all destinationsDpermit all packet from the third subnet of the network address to all destinations
单选题
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration？（）
A
ermit all packets matching the first three octets of the source address to all destinations
B
permit all packet matching the last octet of the destination address and accept all source addresses
C
permit all packet matching the host bits in the source address to all destinations
D
permit all packet from the third subnet of the network address to all destinations
参考解析
解析：
暂无解析
相关考题：
Given the following router output,which configuration file will the router use at its next reload?() A.configB.clientqos.cnfC.startup-configD.running-configuration
Refer to the exhibit. OSPF has been configured on all routers in the network. However, router R1 does not receive a default route to router R2 as in tended. Which configuration change would ensure that R1 would receive a default route from R2? （）A. Add the area 1 stub command on routers R1.B. Add the always keyword to the default - information originate configuration command on router R2.C. Remov e the default information originate configuration command from router R2 and place it on router R1.D. Add the ip route 5.0.0.0 255.255.255.0 0.0.0.0 command to router R2.
Part of the configuration files for routers testking1 and testking2 are displayed below:If you were to enter the show interface serial 0 command on router testking1,which of the following will be displayed?（）A. Serial 0 is down, line protocol is downB. Serial 0 is up, line protocol is upC. Open: IPCP, CDPCPD. LCP closedE. LCP open
The following configuration line was added to router R1 Access－list 101 permit ip 10.25.30.0 0.0.0.255 any What is the effect of this access list configuration?() A. permit all packets matching the first three octets of the source address to all destinationsB. permit all packet matching the last octet of the destination address and accept all source addressesC. permit all packet matching the host bits in the source address to all destinationsD. permit all packet from the third subnet of the network address to all destinations
The following configuration line was added to router R1Access－list 101 permit ip 10.25.30.00.0.0.255 anyWhat is the effect of this access list configuration?() A.ermit all packets matching the first three octets of the source address to all destinationsB.permit all packet matching the last octet of the destination address and accept all source addressesC.permit all packet matching the host bits in the source address to all destinationsD.permit all packet from the third subnet of the network address to all destinations
Router R1 has been configured for EIGRP. The configuratio n also includes an ACL with one line -access - list 1 permit 10.100.32.0 0.0.15.255 - and the EIGRP configuration includes the distribute -list 1 in command. Which of the following routes could not be displayed in the output of the show ip eigrp topology comm and as a result?（）A、10.10.32.0/19B、10.10.44.0/22C、10.10.40.96/27D、10.10.48.0/23E、10.10.60.0/30
You administer a network that uses two routers， R1 and R2， configured as an HSRP group to provide redundancy for the gateway. Router R1 is the active router and has been configured as follows： R1#configure terminal R1（config）#interface fa0/0 R1（config-if）#ip address 10.10.0.5 255.255.255.0 R1（config-if）#standby 1 priority 150 R1（config-if）#standby preempt delay minimum 50 R1（config-if）#standby 1 track interface fa0/2 15 R1（config-if）#standby 1 ip 10.10.0.20 Which of the following describes the effect the standby preempt delay minimum 50 command will have on router R1？（）A、 The HSRP priority for router R1 will increase to 200.B、 Router R1 will become the standby router if the priority drops below 50.C、 The HSRP priority for router R1 will decrease to 50 points when Fa0/2 goes down. D、 Router R1 will wait 50 seconds before attempting to preempt the active router.
In which Cisco IOS configuration mode is the route distinguisher （RD） configured？（）A、R1（config-route-at）#B、R1（config-route-map）#C、R1（config-it）#D、R1（config-vrf）#E、R1（config）#F、R1（router）#
An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each of her. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?（） key chain fred key 3 key - string whehew interface fa0/0 ip authenticat ion key - chain eigrp 9 fredA、The configuration is missing one authentication - related configuration commandB、The configuration is missing two authentication - related configuration commandsC、Authentication type 9 is not supported; type 5 should be u sed insteaDD、The key numbers must begin with key 1, so change the key 3 command to key 1
The VLANs in switch R1 are being modified. Which of the following are updated in R1 every time a VLAN is modified？（）A、Configuration revision numberB、Configuration revision flag fieldC、Configuration revision reset switchD、Configuration revision databaseE、None of the other alternatives apply
On router R1， which three of the following protocols will be forwarded to a host specified by the "iphelper-address" interface configuration command if the configuration has not been modified by the"ip forward-protocol udp" global configuration command？（）A、BOOTPB、TFTPC、ARPD、DNSE、proxy-ARPF、FTPG、CDP
Router R1 sits at an Enterprise branch office, using both the Internet and a leased line to another Enterprise router for its two connectivity options back into the rest of the Enterprise network. The engineer planning for this branch decided to use the leased line for all Enterprise traffic, unless it fails, in which case the Internet connection should be used to pass traffic to the Enterprise. Which of the following is most likely to be useful on the branch router?（）A、IPsec tunnelB、GRE tunnelC、Floating stati c routeD、An IGP
A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）A、For the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router
Router R1 is configured for HSRP. Which of the following are valid HSRP states on R1？ （）A、 InitB、 IdleC、 ActiveD、 StandbyE、 EstablishedF、 Backup
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exis ts in a planning document intended to be used to copy/paste into Router R1 to enable EIGRP for IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about EIGRP for IPv6 on R1 after this configuration has been pasted into R1?（） ipv6 router eigrp 1 ipv6 unicast- routing interface f0/0 ipv6 address 2000::1/64 ipv6 eigrp 1 interface s0/0/0 ipv6 address 2001::/64 eui - 64 ipv6 eigrp 1A、EIGRP works on F0/0 and S0/0/0 without further configurationB、EIGRP works with the addition of one command: a no shutdown command in EIGRP router configuration modEC、EIGRP works with the addition of one command: an eigrp router - id command in EIGRP router configurat ion modED、EIGRP for IPv6 needs at least two more configuration commands before it works on R1
Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable RIPng and IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Which of the following is true about RIPng on R1 after this configuration has been pasted into R1?（） ipv6 unicast- routing interface f0/0 ipv6 rip one enable ipv6 address 2000::1/64 interface s0/0/0 ipv6 address 2001::/64 eui - 64 ipv6 rip one enableA、RIPng will be enabled on no interfaces.B、RIPng will be enabled on one interface.C、RIPng will be enabled on two interfaces.D、RIPng will advertise about prefixes connected to S0/0/0 and F0/0, but only send Updates on one interface.
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.0 0.0.0.255 any What is the effect of this access list configuration?（）A、permit all packets matching the first three octets of the source address to all destinationsB、permit all packet matching the last octet of the destination address and accept all source addressesC、permit all packet matching the host bits in the source address to all destinationsD、permit all packet from the third subnet of the network address to all destinations
单选题Given the following router output,which configuration file will the router use at its next reload?（）A configB clientqos.cnfC startup-configD running-configuration
单选题An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each of her. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?（） key chain fred key 3 key - string whehew interface fa0/0 ip authenticat ion key - chain eigrp 9 fredAThe configuration is missing one authentication - related configuration commandBThe configuration is missing two authentication - related configuration commandsCAuthentication type 9 is not supported; type 5 should be u sed insteaDDThe key numbers must begin with key 1, so change the key 3 command to key 1
单选题An administrator needs to update a router configuration for a router that does not support SSH.Which of the following can be used to securely update the router configuration?（）AFTPBSNMPv2CTFTPDKTTPS
多选题Router R1 has been configured for EIGRP. The configuratio n also includes an ACL with one line -access - list 1 permit 10.100.32.0 0.0.15.255 - and the EIGRP configuration includes the distribute -list 1 in command. Which of the following routes could not be displayed in the output of the show ip eigrp topology comm and as a result?（）A10.10.32.0/19B10.10.44.0/22C10.10.40.96/27D10.10.48.0/23E10.10.60.0/30
单选题What is the importance of using Virtual Output Queues on ingress Line Cards in a high-end router？（）APrevents head-of-line blockingBUses less memoryCIncreases forwarding performanceDSimplifies configuration
多选题On router R1， which three of the following protocols will be forwarded to a host specified by the "iphelper-address" interface configuration command if the configuration has not been modified by the"ip forward-protocol udp" global configuration command？（）ABOOTPBTFTPCARPDDNSEproxy-ARPFFTPGCDP
单选题Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable RIPng and IPv6 on interfaces F0/0 and S0/0/0. No other related configuration exists. Which of the following is true about RIPng on R1 after this configuration has been pasted into R1?（） ipv6 unicast- routing interface f0/0 ipv6 rip one enable ipv6 address 2000::1/64 interface s0/0/0 ipv6 address 2001::/64 eui - 64 ipv6 rip one enableARIPng will be enabled on no interfaces.BRIPng will be enabled on one interface.CRIPng will be enabled on two interfaces.DRIPng will advertise about prefixes connected to S0/0/0 and F0/0, but only send Updates on one interface.
单选题A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router，as the routing protocol for the network.Which statement about thisnetwork is true？（）AFor the two vlans to communicate，a network statement for the trunk interface needs to be added to the OSPF configuration.BFor the two vlans to communicate， a network statement for each subinterface needs to be added to the OSPF configuration.CDirect inter-vlan communication does not require OSPFDOSPF cannot be used if router-on-a-stick is configured on the router
多选题Router R1 sits at an Enterprise branch office, using both the Internet and a leased line to another Enterprise router for its two connectivity options back into the rest of the Enterprise network. The engineer planning for this branch decided to use the leased line for all Enterprise traffic, unless it fails, in which case the Internet connection should be used to pass traffic to the Enterprise. Which of the following is most likely to be useful on the branch router?（）AIPsec tunnelBGRE tunnelCFloating stati c routeDAn IGP
多选题Router R1 is configured for HSRP. Which of the following are valid HSRP states on R1？ （）AInitBIdleCActiveDStandbyEEstablishedFBackup